板壳式换热器设置膨胀节的判定

介绍板壳式换热器的主要特点和应用。当壳体与板束温差较大时,笔者通过对产品开发的生产实践,提出解决板壳式换热器要否设置膨胀节的类似判定方法。     

Internet上化学化工资源

详细介绍了Internet上的化学化工资源及域名地址。     

Application of K2CO3 catalysts in the coal gasification process using nuclear heat

Conventional gasification processes use coal not only as feedstock to be gasified but also for supply of energy for reaction heat, steam production, and other purposes. With a nuclear high temperature reactor (HTR) as a source for process heat, it is possible to transform the whole of the coal feed into gas. This concept offers advantages over existing gasification processes: saving of coal, as more gas can be produced from coal; less emission of pollutants, as the HTR is used for the production of steam and electricity instead of a coal-fired boiler; and a lower production cost for the gas. However, the process has the disadvantage that the temperature is limited to the outlet temperature (950 °C max) of the helium cooling gas of the HTR. Therefore the possibility of catalytic steam gasification was examined. Model calculations based on experimental results show that use of 3–4 wt% relative to coal of K²CO³ catalyst increases the throughput of a large scale nuclear gasification plant by ≈65%, while gas production costs decrease by ≈15%. Corrosion by catalysts is not significant at low concentration (< 5 wt%) and low temperature (< 900 °C).     

Transient Hot-Strip Method for Simultaneous Determination of Thermal Conductivity and Thermal Diffusivity of Refractory Materials

The transient hot-strip method has been used for determining thermal conductivity and thermal diffusivity of a refractory brick. The technique is based on recording the transient temperature increase of a 25-μm-thick, 8-mm-wide, and 70-mm-long iron strip clamped between two sample halves and heated with a constant direct current. The method is accurate to within 5% in the thermal conductivity and to within 10% in the thermal diffusivity in the temperature range 20° to 700°C.     

Air-source heat pump coupled with economized vapor injection scroll compressor and ejector:Design and experimental research

Ejector can utilize high pressure energy from liquid mechanism,it can be used in heat pump system coupled with economized vapor injection(EVI)scroll compressor.When running under low temperature conditions,the performance of the EVI system with ejector can be improved further.In this paper,the design method of the heat pump system with ejector is presented,and the process for designing the heat pump with ejector(EVIe)was summarized.One prototype heat pump was designed under the condition of the evaporation ...     

Application of open-pit and underground mining technology for residual coal of end slopes

Given the conditions of residual coal from the boundary of a flat dipping open-pit mine,which uses strip areas mining and inner dumping with slope-covering,we propose an open-pit and underground integrated mining technology for residual coal of end slopes.In the proposal a conveyance road and ventilation conveyance near the slope are built,corresponding to the pit mining area and the surface coal mine dump,as well as an interval haulage tunnel and air-inlet tunnel.The outcome shows that such mining method may reduce the effect to slope stability from underground mining,it does not affect the dumping advance and has a high recovery rate of residual coal resources.The working face is timbered by single hydraulic props,transported by a scraper conveyor and supported by coal walls.This method of mining is one of layered top coal caving,with high resource recovery,low production cost where positive economic benefit can be realized.     

有限体积法求解立体角离散误差

为解决采用有限体积法求解辐射传输方程时引起离散误差的问题,从有限体积法立体角内热流密度的求解过程出发,运用泰勒级数推导了近似误差的表达式,并分析影响离散误差的各种因素,包括离散射线数,辐射强度分布,假散射及网格比.根据分析结果,采用辐射强度的连续分布模型,模拟了各种因素对误差的影响.结果表明,辐射强度的分布函数对于有限体积法的离散误差有一定程度影响.当增加网格数及减小网格尺寸比时,可以有效地减小离散误差.假散射与离散误差间呈较强的非线性耦合关系.     

制造任务分解与制造单元级资源配置协同优化

针对网络化制造环境下制造任务分解与资源配置脱节的问题,提出了制造任务逐层分解与制造单元级资源配置协同优化的方法,建立了协同优化流程.在对制造任务特点进行分析的基础上,建立了制造任务模型和制造单元资源模型,建立了多目标优化模型和目标的综合评价体系,利用在遗传算法求解搜索过程中所获得的动态信息进行综合评价,并随着求解搜索过程的深入对变异幅度进行调整,以达到全局优化和加快收敛速度的目的.最后以实例验证了该方法的可行性与有效性.     

大口径光学透镜瞬态温度场模拟

为考察热辐射效应对光学元件稳、瞬态温度场的影响,给出了考虑辐射和导热耦合换热情况下复杂几何结构光学透镜稳、瞬态热特性的适体坐标下离散坐标法.对喷管形和圆柱形介质进行计算并与其他方法比较表明,建立的适体坐标系下辐射与导热耦合换热计算方法精度较好.对两端为球缺中间为圆柱的大口径透镜内的辐射与导热耦合换热过程进行了数值模拟.计算结果表明,为了精确地预测半透明介质如透镜内的温度分布,应该考虑辐射与导热耦合作用,且应当考虑介质的光谱特性.     

城市污水的层流换热特性理论

为有效利用城市污水热能,以污水源热泵系统中的流动工质——城市污水为研究对象,通过理论分析的方法,对其层流状态下的换热特性进行理论推导和实验验证.结果表明:污水作为热泵的冷热源,有良好的换热特性,推导得出的换热准则关联式h=4.53λ/D,为污水源热泵系统设计提供依据,同时为应用污水余热技术提供理论基础.