低功率激光治疗血管性头痛24例

低功率激光穴位照射治疗血管性头痛24例,总治愈率54.2%,好转率29.2%,无效率16.6%,但头痛部位、治疗经穴的不同,疗效差别很大。     

ZXJ10机IN业务功能扩展及实现

本文从智能网的基本概念入手,论述了利用 ZXJ10程控交换系统为发展智能网业务提供支持功能的技术策略以及分阶段实现的过程,并对各个阶段能够实现的业务作了简要介绍。     

降凝剂对高蜡稠油的改性效果及机理研究

实验研究了工业品原油降凝剂WHP改善含蜡56.9%、其中96.6%为正构烷烃的胜利郑王庄稠油流动性的效果。WHP含乙烯/醋酸乙烯/乙烯醇嵌段聚醚三元共聚物30%-35%。在60℃将WHP加入稠油中,测定其凝点和32℃、0-42.6 s^-1范围5个剪切速率下的黏度,均随WHP加量的增加（50-300 mg/L）而降低,200 mg/L为最佳加量,在该加量下0.32 s^-1黏度由34.16 Pa·s降至79.2 mPa·s,凝点（℃）、屈服值（Pa）、稠度系数（Pa·s^n）分别由49.0、32.42、31.57降至39.5、0.1297、0.02142,流型指数由0.1176升至0.9790。由黏温曲线求出,加入200mg/L WHP使该稠油析蜡点由65℃降至58℃,反常点由70℃降至50℃。根据空白和加剂原油扫描电镜照片显示的蜡晶形态,利用共晶机理分析讨论了WHP这种高分子表面活性剂的降凝、降黏、改善流动性的作用。图3表3参5。     

矿用圆环链弯曲点的角度分布

矿用圆环链弯曲点是应力集中点 ,肩部断裂发生于该点附近 .以 2 6× 92矿用圆环链为研究对象 ,应用方向数据统计导出该点的角度分布 ,并给出了批量检验矿用圆环链尺寸匹配状况的一种方法     

Effects of shear flow on long-ranged correlations,spinodal demixing kinetics,and the location of the critical point and cloud point

A derivation of an expression for the shear rate-dependent Ornstein Zernike structure factor is discussed, together with the resulting anomalous behavior of the turbidity. The predicted scaling behavior of the turbidity, comprising the effect of both temperature and shear rate, is in good agreement with experiments on binary fluids. Then initial spinodal decomposition is discussed, and an explicit expression for the time- and shear rate-dependent effective diffusion coefficient is derived, which shows all the typical characteristics of anisotropic light scattering patterns that are observed experimentally for binary fluids. Next it is shown that the spinodal is shifted linearly with the (bare) Peclet number for not too large Peclet numbers, whereas the cloud point is singularly displaced into the unstable region due to a shear now. This is in agreement with an experiment on a two-polymer/solvent mixture and binary fluid mixtures. It is argued that light scattering is useless to determine the location of the spinodal of a sheared system.Paper presented at the Twelfth Symposium on Thermophysical Properties, June 19–24, 1994, Boulder, Colorado, U.S.A.     

催化裂化再生系统设备应力腐蚀开裂成因分析及解决对策

通过对催化裂化装置再生系统设备裂纹断口分析 ,以及对再生烟气的组分、冷凝水酸度及露点等的分析及对设备焊接残余应力测试 ,阐明了设备应力腐蚀开裂发生的原因 ,指出了富氧操作、高露点温度和高应力水平对再生系统设备应力腐蚀的影响作用 ,并重点提出了解决和防止应力腐蚀开裂的一系列有效措施和部分应用情况     

合理选用过剩空气系数的重要性分析

通过分析过剩空气系数过大或过小时加热炉多方面的影响,强调了合理选用过剩空气系数的重要性,并提出了控制措施。     

A study of suppression of vapor explosions by adding inversely soluble polymers

The mechanism of the suppression of vapor explosions by adding inversely soluble polymers in water is studied. Vapor explosion experiments and quench experiment are conducted using a silver test piece. Polymetric solution (polyethylene oxide), of concentrations from 0 to 500 wppm, whose normalized viscosity (by water) varies from 1.00 to 2.00, is used. No vapor explosion is observed in the aqueous polymer solution at a concentration higher than 200 wppm. Quench experiments using the silver test piece submerged in the polymer solution and water are performed in order to examine the stability of film boiling. The suppression of the vapor film collapse is attributed to the precipitation of polyethylene as a gel around the vapor film. © 2002 Wiley Periodicals, Inc. Heat Trans Asian Res, 31(4): 297–306, 2002; Published online in Wiley InterScience ( www.interscience.wiley.com ). DOI 10.1002/htj.10037     

烷基化原料预加氢工艺应用分析

由于来自催化裂化装置的烷基化原料中所含有的丁二烯在烷基化反应中可生成重质油,使产品干点上升,辛烷值下降,并使酸耗增加.针对这种状况,齐鲁石化公司研究院和胜利炼油厂联合开发了QSH-01烷基化原料预加氢催化剂及其相应的工艺技术,来脱除原料中丁二烯.笔者对该工艺技术及其应用作了阐述,并对该技术的应用前景作出分析.