Ordered mesoporous Pd/SnO2 synthesized by a nanocasting route for high hydrogen sensing performance

Ordered mesoporous SnO₂ and mesoporous Pd/SnO₂ have been successfully synthesized via nanocasting method using the hexagonal mesoporous SBA-15 as template. Two different procedures, impregnation technique and direct synthesis, were utilized for the doping of Pd in the mesoporous SnO₂. The results of small angle X-ray diffraction (SAXD), nitrogen adsorption–desorption and transmission electron microscopy (TEM) demonstrate that the SnO₂ and Pd/SnO₂ display ordered mesoporous structures and high surface areas. Wide angle X-ray diffraction (WAXD) and X-ray photoelectron spectroscopy (XPS) reveal tetragonal structure of SnO₂ and the existence of Pd element. The sensing properties of mesoporous SnO₂ and mesoporous Pd/SnO₂ for H₂ were detected. The sensor utilizing mesoporous Pd/SnO₂ via direct synthesis method exhibits excellent response and recovery behavior and much higher sensitivity to H₂, compared to those using mesoporous SnO₂ and mesoporous Pd/SnO₂ via impregnation technique. It is believed that its high gas sensing performance is derived from the large surface area, high activity and well dispersion of Pd additive, as well as high porosity, which lead to highly effective surface interaction between the target gas molecules and the surface active sites.     

Structural and properties of nanocrystalline WO3/TiO2-based humidity sensors elements prepared by high energy activation

Nanocrystalline WO₃/TiO₂-based powders have been prepared by the high energy activation method with WO₃ concentration ranging from 1 to 10 mol%. The samples were thermal treated in a microwave oven at 600 °C for 20 min and their structural and micro-structural characteristics were evaluated by X-ray diffraction, Raman spectroscopy, EXAFS measurements at the Ti K-edge, and transmission electron microscopy. Nitrogen adsorption isotherms and H₂ Temperature Programmed Reduction were also carried out for physical characterization. The crystallite and particle mean sizes ranged from 30 to 40 nm and from 100 to 190 nm, respectively. Good sensor response was obtained for samples with at least 5 mol% WO₃ activated for at least 80 min. Ceramics heat-treated in microwave oven for 20 min have shown similar sensor response as those prepared in conventional oven for 120 min, which is highly cost effective. These results indicate that WO₃/TiO₂ ceramics can be used as a humidity sensor element.     

政务信息资源中心框架设计及关键技术研究

目前国内有关政务信息资源共享的研究及应用还停留在网络互联互通、信息资源整合、点对点数据交换阶段,并没有达到"协同工作"的要求.鉴于此,提出了政务信息资源中心的概念,实现政务信息资源的统一获取、统一管理、规则化和规模化服务.结合工作实践,对其组成、总体框架、技术架构进行了设计,并就实现时需要解决的关键技术进行了研究.     

无线光电定位网络的设计

为满足非接触化、小型化、集成化、数字化、智能化等现代检测技术的发展要求,从成本、工作原理、灵敏度等方面综合考虑,现采用以光电定位模块为核心的光电定位技术,以无线传感器网络作为数据传输与管理的技术手段,构建了无线光电定位网络,并进行了实验分析.可实现多点实时监测、异地显示测量数据、数据网络化管理等特殊需求;涵盖了多学科领...     

A fuzzy-based interleaved multi-hop authentication scheme in wireless sensor networks

In sensor networks, a compromised node can either generate fabricated reports with false votes or inject false votes into real reports, which causes severe damage such as false alarms, energy drain and information loss. An interleaved hop-by-hop authentication (IHA) scheme addresses the former attack by detecting and filtering false reports in a deterministic and hop-by-hop fashion. Unfortunately, in IHA, all en-route nodes must join to verify reports while only a few are necessary to the authentication procedure. In this paper, we propose a fuzzy-based interleaved multi-hop authentication scheme based on IHA. In our scheme, the fuzzy logic system only selects some nodes for verification based on the network characteristics. Moreover, we apply a voting method and a hash-based key assignment mechanism to improve network security. Through performance evaluation, the proposed scheme is found to save up to 13% of the energy consumption and to provide more network protection compared to IHA.     

Fabrication and characterization of a miniaturized planar voltammetric sensor array for use in an electronic tongue

A planar voltammetric sensor array for use in an electronic tongue was fabricated using a combination of microfabrication techniques. The techniques of e-beam evaporation and pulsed laser deposition were applied to prepare a device that contained all of the electrodes integrated on a silicon die (6 mm × 6 mm). The working electrodes were metals gold, platinum, iridium and rhodium. They were characterized by SEM and EDX, and by electrochemical investigation of the packaged dies with cyclic voltammetry in solutions of sulfuric acid and of ferrocene carboxylic acid in aqueous buffer solution. The robustness and reproducibility of the devices were assessed by potential cycling in acid solution.     

Identification and quantification of different vapours using a single polymer chemoresistor and the novel dual transient temperature modulation technique

This paper presents a novel signal processing technique for a square wave temperature modulated carbon black/polymer composite sensor. The technique consists of only two mathematical operations: summing the off- and on-transients of the conductance signals, and subtracting the steady-state conductance signal. The technique has been verified through its application to a carbon black/polyvinylpyrrolidone composite chemoresistor. Identification of water, methanol and ethanol vapours was successfully demonstrated using the peak time of the resultant curves. Furthermore, quantification of those vapours was found to be possible using the height of the peak heights, which was linearly proportional to concentration. The technique does not require zero-gas calibration and thus is superior to previously reported techniques.     

Gold nanowire array electrode for non-enzymatic voltammetric and amperometric glucose detection

The non-enzymatic voltammetric and amperometric detection of glucose using a gold nanowire array electrode is described. The voltammetric detection of glucose was performed by cyclic and differential-pulse voltammetry. The detection of glucose by partial and direct oxidation of glucose during the anodic and cathodic potential sweeps was shown in cyclic voltammetry. An unusual decrease in overpotential for partial oxidation of glucose on a Au NW array electrode was observed. A linear differential-pulse voltammetric response for partial oxidation of glucose was observed up to a glucose concentration of at least 20 mM with a sensitivity of 41.9 μA mM⁻¹ cm⁻² and detection limit below 30 μM (signal-to-noise ratio of 3) for glucose oxidation at low potentials, where the influence of possible intermediates can be avoided. The amperometric response was also linear up to a glucose concentration of 10 mM with a sensitivity of 309.0 μA mM⁻¹ cm⁻². The wide dynamic range and high sensitivity, selectivity and stability, as well as good biocompatibility of the Au NW electrode make it promising for the fabrication of non-enzymatic glucose sensors.     

采用商业卫星构建虚拟星座

提出了虚拟星座的概念,从商业卫星资源优势、卫星参数差异和传感器特征差异3个方面分析了构建虚拟星座的可行性。以LANDSAT-7卫星和SPOT5卫星为试验对象,验证了构建虚拟星座的可操作性。