驻极体声传感器及其储电材料的现状

综述了驻极体声传感器及其储电材料近年来的迅猛发展。传统的FEP(tetrafluoroethylene—hexa—fluoropropylene copolymer)极体电容式声传感器及以铁电聚合物PVDF(poly vinylidene fluoride)家族为芯片的声传感器和超声抉能器仍焕发着青春活力。Si基微型驻极体声传感器的理论和实验研究已经日趋成熟，而用空间电荷型多孔聚合物驻极体压电薄膜为芯片可望研制出新一代声电和电声传感器、压力传感器和驱动器。     

Oxidation of Silicon Carbide in Environments Containing Potassium Salt Vapor

At high temperatures in clean oxidizing environments, SiC forms a very protective SiO₂ film, but, in environments containing low levels of gaseous alkali salt contaminants or where condensed salts may deposit on the surface, the resistance of the film is significantly reduced. Oxidation kinetics of SiC were measured by continuous thermogravimetric analysis in a controlled environment containing CO₂, H₂O, and O₂ plus low levels of potassium-containing salts. Potassium was found to be incorporated into the SiO₂ scale and to significantly change its transport properties and its morphology. The rate of scale formation was found to increase directly in proportion to K in the scale. A change in mechanism was observed when water vapor was added to the reacting gas stream.     

Nuclear Magnetic Resonance Studies of Silicon Carbide Polytypes

The ²⁹Si MAS NMR spectra of the 2H, 4H, 6H, and 3C polytypes of silicon carbide are presented. An attempt is made to correlate differences in the chemical shifts with local atomic environment. The results of the analysis of the spectra of pure polytypes are used as a basic for the interpretation of the spectra of mixed polytypes and a discussion of the crystallinity and impurity levels of different samples. Carbon-13 chemical shifts obtained from spectra of the same polytypes are also tabulated.     

A Silicon–Silica Nanocomposite Material

The synthesis and characterization of a novel silicon–silica nanocomposite material are reported. A self‐assembly method allows the encapsulation of silicon nanoclusters within the channels of a periodic mesoporous silica thin film. The result is the formation of a silicon–silica nanocomposite film with bright, room‐temperature photoluminescence in the visible range, and a nanosecond luminescence lifetime. The properties of the nanocomposite material have been studied by several analytical techniques, which collectively show the existence within the channels of non‐diamondoid‐structure‐type silicon nanoclusters with various hydrogenated silicon sites. It is estimated that the silicon nanoclusters in the silica mesoporous films occupy up to 39 % of the accessible pore volume. The nanocomposite film shows improved resistance to air oxidation compared to crystalline silicon. The high loading and chemical stability to oxidation under ambient conditions are important advantages in terms of the development of silicon‐based light‐emitting diodes from this class of materials.     

Stepwise-Graded Si3N4–SiC Ceramics with Improved Wear Properties

The processing of stepwise graded Si₃N₄/SiC ceramics by pressureless co-sintering is described. Here, SiC (high elastic modulus, high thermal expansion coefficient) forms the substrate and Si₃N₄ (low elastic modulus, low thermal expansion coefficient) forms the top contact surface, with a stepwise gradient in composition existing between the two over a depth of ∼1.7 mm. The resulting Si₃N₄ contact surface is fine-grained and dense, and it contains only 2 vol% yttrium aluminum garnet (YAG) additive. This graded ceramic shows resistance to cone-crack formation under Hertzian indentation, which is attributed to a combined effect of the elastic-modulus gradient and the compressive thermal-expansion-mismatch residual stress present at the contact surface. The presence of the residual stress is corroborated and quantified using Vickers indentation tests. The graded ceramic also possesses wear properties that are significantly improved compared with dense, monolithic Si₃N₄ containing 2 vol% YAG additive. The improved wear resistance is attributed solely to the large compressive stress present at the contact surface. A modification of the simple wear model by Lawn and co-workers is used to rationalize the wear results. Results from this work clearly show that the introduction of surface compressive residual stresses can significantly improve the wear resistance of polycrystalline ceramics, which may have important implications for the design of contact-damage-resistant ceramics.     

Mössbauer Study of the Influence of Fe-Si-N Liquid in the Synthesis of β-Si3N4 from Silica

Mössbauer spectra of the products obtained by carbothermal reduction and distribution of silica in the presence of iron in the temperatures range 1200^o to 1540^o were studied. The preponderance of β- Si₃N₄ over the α form at a higher reaction temperature were assumed to be related to the formation of an Fe-Si-N liquid. The liquid did not alter its composition with the variation of reduction-temprature, Iron had no effect on the reaction mechanism below 1300^oC.     

Thermal Shock Behavior of Porous Silicon Carbide Ceramics

Using the water-quenching technique, the thermal shock behavior of porous silicon carbide (SiC) ceramics was evaluated as a function of quenching temperature, quenching cycles, and specimen thickness. It is shown that the residual strength of the quenched specimens decreases gradually with increases in the quenching temperature and specimen thickness. Moreover, it was found that the fracture strength of the quenched specimens was not affected by the increase of quenching cycles. This suggests a potential advantage of porous SiC ceramics for cyclic thermal-shock applications.     

流场拟合法在缩微环境中的研究

流场拟合法是由何继善院士提出的物理探测技术。以流场拟合法为理论基础研制的管涌渗漏检测仪在堤坝检测及抗洪抢险中发挥了重要作用，本文提出了一种在缩微环境中模拟管涌渗漏，对流场拟合法进行模拟测试并获得了明显的结果。为管涌仪器的性能检测、校验、标定提供了便捷的测试方法，并为该仪器在生产过程中统一性能和企业标准的制订提供了理论依据。     

射频放大器互调失真检测和载波抵消的研究

采用高功率射频信号内部互调失真的包络特性检测与比较技术,对射频功率带外信号进行检测和估计。设计用于高功率射频放大器前馈技术线性化的一个带外信号检测器。探讨如何进行射频载波抵消以及检测放大器互调失真信号。     

硅压力传感器的可靠性测试

硅压力传感器的可靠性测试技术研究受到了国内外的重视，对它的测试项目及其加速寿命测试方法进行了综述。