下喷自吸环流反应器中气-液局部相际传质模型

引言 下喷自吸环流反应器是在结合喷射、环流、自吸等优点基础上而开发出的一种新型高效反应器,开展该反应器内局部气液传质模型的研究,对于该反应器的优化设计及放大具有极重要的理论意义.多年来,经典传质理论的不足与局限都在经历不断的修正与改进.其中,激光多普勒测试在传质研究中的应用使得人们对湍流在传质中的重要性有了     

Study on Jet Coflow Packing Tray

Experimental study on hydrodynamics and mass transfer efficiency of jet coflow packing tray (JCPT) was conducted in a φ285 mm column and a φ200 mm column, respectively. Compared with new vertical sieve tray which has been applied in the petrochemical industry since 1968, the JCPT has lower pressure drop, higher capacity and higher mass transfer efficiency, and seems promising in commercial application.     

FORMATION AND FLOW OF GAS BUBBLES IN A PRESSURIZED BUBBLE COLUMN WITH A SINGLE ORIFICE OR NOZZLE GAS DISTRIBUTOR

The characteristics of gas bubbles in a 5 cm diameter bubble column equipped with a single orifice of 1,3 or 5 mm diameter were investigated under system pressure of 0.1-15 MPa. The formation of gas bubbles was strongly affected by the system pressure. Under high pressures a dispersed gas jet was formed at gas velocities where spherical gas bubbles would have been formed at atmospheric pressure. The critical gas velocity between the bubbling regime and the jetting regime was correlated with the liquid phase Weber number and the gas phase Reynolds number based on the gas velocity at the orifice. Bubble size and gas holdup in the main part of the bubble column were also affected by the bubble formation pattern at the distributor     

三级生物接触氧化在高层建筑污水处理改造工程中的应用

某高层建筑已完成污水处理装置土建部分的施工,为达标排放,提出改造方案。经方案比较,将原单级接触氧化法改为三级接触氧化法,将原鼓风曝气改为潜水曝气,增加污泥外循环回流及清水池和排水泵,以强化系统脱氮效果,保证出水顺利排放。同时,介绍了各处理单元的设计参数,分析了运行费用和投资,以供同类工程参考。     

Study of a downward gas jet in a two–dimensional fluidized bed

The study of a downward gas jet was performed in a two–dimensional (2–D) fluidized bed of sand particles under conditions of minimum fluidization and at atmospheric pressure and room temperature. The jet shifted through a cyclic sequence of left–central–right–central–left positions. The probability of the left and right jets was 40% each, while the less stable central jet occurred only 20% of the time. Discrete probability distributions of jet presence for each of the three jet configurations and an overall distribution are presented. They show that jets are dominant along the external walls of the nozzle. The depth of the downward jet increased with air flowrate in agreement with the correlation from Massimilla and Russo (1973).     

反相微乳液法制备陶瓷彩喷墨水(Ⅰ)

系统地研究了Span80-Tween60/助乳化剂/油/FeCl3反相微乳液体系。通过正交实验,进行方差分析,得出最佳反相微乳液体系。通过均匀实验和全面实验,绘制出体系的拟三元相图,并由相图得出体系的最佳比例。绘制出最大溶水量与温度的曲线,从而确定最佳乳化温度。在最佳温度、最佳比例下,配制出两种墨水,并测定了墨水的表面张力、粘度、电导率和稳定性等性能。     

反相微乳液法制备陶瓷彩喷墨水(Ⅱ)

通过红外光谱仪测定两种墨水的微乳液结构。结果表明,醚氧键中的羟基与H2O分子作用后因形成氢键,而且有强烈的相互作用;正己醇分子在该反相微乳液中水分子作用很弱,而且推断它位于反相微乳液的栅状层;随着微乳液中含水量的增大,水分子O-H伸缩振动峰的强度和频率均发生变化,其吸收强度变大,峰面积增加,频率也向低频方向位移;体系中存在三种水:结合水、捕获水和自由水。并探讨了其反应机理。     

某抽水蓄能电站下库进出水口水沙运动特性试验研究

利用河工模型对某抽水蓄能电站下库区进行了特征洪水过程及电站运行的联合模拟试验。试验表明在输沙槽与拦沙潜堰共同作用下,电站进出水口的含沙量得到有效控制。在来水含沙量低于3kg/m3时,进出水口含沙量都满足电站运行要求,但是在含沙量较高的洪水期,底部浑水会逆行至电站进出水口附近,导致过机含沙量较高,因此提出了增设非封闭式拦沙潜坝的修改方案。修改方案改善了进出水口前的水流结构,起到了良好的拦沙截淤作用,进出水口前含沙量及泥沙淤积大幅减少,蓄能期过机含沙量降低13%~22%。在含沙量较大的洪水期,电站不宜抽水运用,但适时采用发电运行有助于减轻下库进出水口前的泥沙淤积。     

用对流磨粉碎石灰石的试验研究

本文扼要介绍了对流磨的结构与粉碎原理，及粉碎石灰石的试验研究。研究的主要内容是给料粒度与粉碎产物细度和能量效率的关系，以及喷嘴形状与能量效率的关系。