稀磷酸澄清槽泥浆泵改用单螺杆泵的实践

磷酸生产中输送稀磷酸澄清槽淤渣的泥浆泵，各厂的运行情况都不够理想。介绍了三种类型泥浆泵的运行情况，针对淤渣中会出现块结垢物影响泥浆泵长期运行，在单螺杆泵进料腔内设置破碎送料器后，取得了较理想的效果，从而提高了磷酸装置的运转率和磷得率。     

液氯离心泵的气蚀与防治

分析了影响液氯离心泵气蚀的两种参数：允许吸上真空度、气蚀余量。提出了泵气蚀的防治措施：提高离心泵基础设计质量，在实际使用中应采用高分子聚合材料涂覆，并进行补焊、补气。     

双螺杆转速差决定的螺杆间隙之探讨

根据相对运动原理计算了同向旋转双螺杆因螺杆转速差决定的两螺杆之间的径向和轴向间隙,可为工程上设计这些间隙时提供参考。     

A novel shaft-less double suction mini pump

A novel double suction shaft-less mini pump was developed for heat control of small energy systems in this study.The mini pump impeller with an exit diameter of 40 mm was combined with the motor rotor supported by the hybrid dynamic bearing.The specific speed of the pump was 125 min-1 m3 min-1 m.The hydraulic performance of the pump was investigated experimen-tally under four rotational speeds.From the test results,it was recognized that the pump could provide a flow discharge of 5 L/min and head of 1.5 m,w...     

Air-source heat pump coupled with economized vapor injection scroll compressor and ejector:Design and experimental research

Ejector can utilize high pressure energy from liquid mechanism,it can be used in heat pump system coupled with economized vapor injection(EVI)scroll compressor.When running under low temperature conditions,the performance of the EVI system with ejector can be improved further.In this paper,the design method of the heat pump system with ejector is presented,and the process for designing the heat pump with ejector(EVIe)was summarized.One prototype heat pump was designed under the condition of the evaporation ...     

城市污水的层流换热特性理论

为有效利用城市污水热能,以污水源热泵系统中的流动工质——城市污水为研究对象,通过理论分析的方法,对其层流状态下的换热特性进行理论推导和实验验证.结果表明:污水作为热泵的冷热源,有良好的换热特性,推导得出的换热准则关联式h=4.53λ/D,为污水源热泵系统设计提供依据,同时为应用污水余热技术提供理论基础.     

Simulation and optimization of SOFC-BCHP system

As the prime motor of dispersed energy system, the high-temperature solid oxide fuel cells (SOFC) are high efficient with large heat recovery. This study presents a simulation of SOFC building-based cooling, heat and power (BCHP) system, which can meet basic requirements in power and heating (cooling) of the designated customers. The peak power load can be met by power grid, while the peak heating (cooling) load requirement can be met by backup equipments. In order to solve the economic dispatch problem of the energy system, a restricted nonlinear optimization model has been developed. The production costs can be minimized via both the equality constraints of customer’s heat and power demands, and other inequality constrains of equipments’ capacities. The sequential quadratic programming method has been used to search the solution. The study indicates that the model can be used to optimize the system’s capacities and run strategy. An office building case has been computed, and it is indicated that the model can be served in design and optimization of SOFC-BCHP system.     

Rotordynamic forces generated by discharge-to-suction leakage flows in centrifugal pumps

In order to investigate the flow-induced vibration in the shroud passage of centrifugal pump and predict rotordynamic forces of centrifugal pump rotor system,an analysis of rotordynamic forces arising from shrouded centrifugal pump is presented. CFD techniques were utilized to analyze the full three-dimensional viscous,primary/secondary flow field in a centrifugal pump impeller to determine rotordynamic forces. Multiple quasi-steady solutions of an eccentric three-dimensional model at different whirl frequency ratios yielded the rotordynamic forces. The skew-symmetric stiffness,damping,and mass matrices were obtained by second-order least-squares analysis. Simulation of the coupled primary/secondary flow field was conducted,and the complex flow characteristics in the flow field of a shroud passage were achieved including the mean velocity and pressure,as well as the eddy in a large scale of flow field due to viscosity. The rotordynamic force coefficients were calculated,and the results were in good agreement with those of experiment except for the direct inertial coefficient without the consideration of whirling forces from the impeller primary flow passage.     

螺纹桩在软弱地层中的应用

分析了螺纹桩的受力机理,探讨了螺纹桩单桩承载力的确定方法,指出螺纹桩单桩承载力高、节约材料显著、能充分利用地基土的特性,在软弱地层中的应用优势显著,并通过实际工程实例给予具体说明.     

基于STM32和nRF905的无线水泵监控系统设计

针对传统水泵控制系统存在布线复杂、成本高和动力设备分散等问题,设计了一种基于STM32控制器和nRF905无线收发模块的无线水泵监控系统。该系统由从站采集水泵供水系统的水压、液位等参数,通过nRF905组建的一对多无线通信网络进行数据传输,由STM32实现数据处理及主站与上位机间的通信。测试结果表明,该系统采样精度高、数据传输可靠、通信稳定。