Superconductivity at differentTc in CdBa2Ca2Cu3Oy

A Cd analogue of the Tl and Hgn =3 series with nominal composition CdBa₂Ca₂Cu₃O_y has been synthesized. The samples were superconducting according to magnetic susceptibility measurements. The critical temperature was 103 or 107 K depending on the preparation conditions. The EDX analysis revealed the presence of Cd-1111, Cd-1121, and Cd-2333 as minor phases. The observed diamagnetic effects were attributed to the differentT _c of these phases.     

锆(Ⅳ)-3,5-diBr-PADAP-安替比林三元配合物的分光光度研究与应用

本文提出在安替比林存在下,以3,5-diBr-PADAP为显色剂,分光光度测定微量锆的新方法。在pH1～2的HCl介质中,锆(W)与试剂和安替比林形成配合比为1:1:1的红色三元配合物,最大吸收值在615nm波长处,摩尔吸光系数ε=1.35×10~5。锆(Ⅳ)量在0～25μg/25ml范围内,遵守比尔定律。方法简单、快速、准确。若采用钽试剂—苯萃取法分离共存离子,可适用于钽铌矿和合金中痕量锆的测定。     

Al2O3对唐钢高炉炉渣性能的影响

针对唐钢近2年提高进口矿配比后，Al2O3含量升高对炉渣流动性带来的不利影响，对唐钢高炉的炉渣性能进行了试验研究。并结合国内同行业的生产实践经验，从理论上分析了炉渣中Al2O3及MgO的适宜含量范围，着重论述了唐钢所处冀东矿区条件下降低Al2O3的主要途径及适应高Al2O3炉渣的具体措施。     

The determinants of heat-shock element-directed lacZ expression in Saccharomyces cerevisiae.

Heat-shock induction of heat-shock protein genes is due to a specific promoter element (the heat-shock element, HSE). This study used lacZ under HSE control (HSE-lacZ) to characterize HSE activity in Saccharomyces cerevisiae cells of different physiological states and differing genetic backgrounds. In batch fermentations HSE-lacZ induction by heat shock was maximal in exponential growth, and showed marked decline with the approach to stationary phase. Expression in the absence of heat shock was unaffected by growth phase, indicating that the growth-dependent expression of many yeast heat-shock genes uses promoter elements in addition to the HSE. Heat-induced expression was strongly influenced by the temperature at which cultures were grown. While basal, uninduced expression was constant during growth at different temperatures to 30 degrees C, induction by transfer to 39 degrees C was reduced by increases in growth temperature as low as 18-24 degrees C. Maximal HSE-lacZ induction (30- to 50-fold) was in cultures grown at low temperatures (18-24 degrees C), then heat shocked at 39 degrees C. Ethanol was a poor inducer. Mutations having little effect on HSE-lacZ expression included a respiratory petite; ubi4 (which inactivates the poly-ubiquitin gene); also ubc4 and ubc5 (which each inactivate one of the ubiquitin ligases involved in degradation of aberrant protein). pep4-3 increased both basal and induced beta-galactosidase about two-fold, probably because of slower turnover of this enzyme in pep4-3 strains.     

一种可用于可调谐环行Ti：Al_2O_3激光器的宽带单向器

本文介绍一种宽带单向器的原理及设计。选用ＴＧＧ作磁旋光介质，旋光石英晶片作补偿片，所设计的色散补偿型宽带单向器预计可在７００～１０００ｎｍ波长范围内实现环行激光腔中的单向行波运行；将其应用在可调谐环行Ｔｉ：Ａｌ２Ｏ３激光器中，获得了良好的实验结果。     

人工神经网络A／D变换器

本文对［５］的４位人工神经网络Ａ／Ｄ变换器进行了研究．指出按其方法推广实现多位Ａ／Ｄ时存在突触电阻大小以至无法实现且抗干扰能力也不好的问题并给出了解决办法．同时对如何改善神经元转移特性的硬限幅曲线作了简单讨论．     

Emulsifying Properties of the Total Fraction and the Hydrophobic Fraction of Bovine Milk Proteose-peptones

Since proteose-peptone is a mixture of heterogeneous proteins and peptides, its functional properties have not yet been fully understood. The present study was undertaken to elucidate the emulsifying properties of proteose-peptones and a parallel evaluation was performed of the emulsifying activity of the total fraction prepared from bulk skimmed milk by precipitation with ammonium sulphate and of the most hydrophobic fraction purified by hydrophobic interaction fast protein liquid chromatography. A turbidimetric technique was used and the absorbance value at 500 nm was then directly used as the emulsifying activity index. The results obtained confirmed the good emulsifying activity of this protein fraction of the whey and demonstrated the considerable influence of the concentration on the capacity of the proteose-peptones to stabilize a model oil-in-water emulsion. Moreover, at all the concentrations examined, the purified component 3 showed a higher emulsifying activity than the total unpurified fraction.     

ANALYSIS OF EXPERIMENTAL AND NUMERICAL RESULTS OF A TURBULENT SWIRLING FLOW IN A TUBE

In many applications swirling flow is used to enhance heat and mass transfer. One of the problems of modelling a turbulent swirling flow is the choice of the turbulent closure model which is acceptable for engineering purposes. To evaluate which model performs best, numerical results are compared with experimental data. Local velocity measurements are carried out on a swirling flow in a circular tube. The measurement method is hot-wire anemometry combined with visualization techniques. The numerical analysis is carried out using the k-ε model and the Algebraic Stress Model. In the experiment a symmetrical swirl was observed, Comparing the experimental data with the numerical results shows that the Algebraic Stress Model represents the experimental data quite well, whereas the k-ε model fails.