天然气吸附储存脱附过程的动态模拟

通过热动力学计算,认识了脱附过程当中储罐内温度剖面分布的典型特征:储罐轴心处的温度下降幅度最大。分析了脱附过程当中储罐壁的热交换、吸附剂的导热系数以及储罐内的初始压力对储罐内的温度剖面的影响。结论是加强储罐外壁的热交换、增大吸附剂的导热系数皆能改善吸附储罐内的温度剖面。     

集成电路生产中废气的污染及治理

介绍集成电路生产中产生各种废气的种类,废气中有害物质浓度及其危害性,并依据工程实践,评述了各类有害废气的各种处理方法。     

一种实现最佳用户检测的非线性优化神经网络

本文提出并讨论了实现码分多址（CDMA）系统上最佳多用户检测（MUD）的一种神经网络方法。该方法通过将最佳多用户检测视为非线性优化组合问题，利用神经网络能有效求解非线性优化问题的优势，导出了一种非线性优化神经网络来实现最佳多用户检测，理论分析和计算机模拟表明，所提出的神经网络具有可实时应用的动态性能和较传统方法优越得多的误码率性能和抗多址干扰的性能。     

带隔板底水油藏油井临界产量计算公式

本给出了带隔板底水油藏油井的监界产量计算公式，它适用于所有带隔板底水油藏的油井。     

离子注入中污染的产生及防护

本文概述了离子注入过程中污染产生的原因和防止污染的措施，特别强调了对微粒污染和金属污染的防护以满足ＵＬＳＩ加工对离子注入的要求。     

Error in the UNITY substitution rule for subscripted operators

UNITY, introduced by Chandy and Misra [ChM88], is a programming logic intended to reason about temporal properties of distributed programs. Despite the fact that UNITY does not have the full power of, for example, linear temporal logic, it enjoys popularity due to its simplicity.There was however a serious problem with the Substitution Rule. The logic is incomplete without the rule, and with the rule it is inconsistent.     

压差式漏率测试仪的实验研究

将薄膜电容真空计的测量室接于被测密闭容器，静态真空室接于一个比较容器，即组成一台压差式漏率测试仪。首先使两容器压力平衡，真空计读数为零。当被测容器存在漏孔时，真空计薄膜两侧形成压差，真空计指示读数，继而计算出该容器的漏率。应用商品真空计在抽真空测试时，检测的最小可测漏率达10－4～10-5Pa·L／s；而在充压测试时，因受气体温度变化的影响，灵敏度会降低几个量级。该仪器有可能具备寻找漏孔位置和确定漏孔漏率的功能。     

Nitric oxide reduction and carbon monoxide oxidation over carbon-supported copper-chromium catalysts

Carbon supported copper-chromium catalysts are shown to be very active for both the reduction of nitric oxide with carbon monoxide and the oxidation of carbon monoxide with oxygen. Mixed copper-chromium oxide active phases have good activity in the simultaneous removal of nitric oxide and carbon monoxide from exhaust gases. The influence of several catalyst variables has been investigated. The activity per volume of catalyst increases with increasing loading, while the intrinsic activity shows a maximum around C/M=100−50. An optimum catalyst for nitric oxide reduction and carbon monoxide oxidation has a copper/chromium ratio of 2/1. The apparent activation energy for the carbon monoxide oxidation over carbon supported copper-chromium catalysts is 77 kJ/mol, suggesting that the Cu---O bond rupture is the rate-limiting process. The reduction of nitric oxide takes place at higher temperatures. Since all catalysts have a low selectivity for molecular nitrogen formation at lower temperatures, the dissociation of nitric oxide is probably rate determining, resulting in a slightly reduced catalyst system. In an excess of carbon monoxide the reaction is first-order in nitric oxide and zero-order in carbon monoxide. Moisture inhibits the reaction by reversible competitive adsorption, whereas carbon dioxide does not. Oxygen completely inhibits the reduction of nitric oxide due to the more rapid reoxidation of the catalytic sites compared to nitric oxide. Therefore, the reduction of nitric oxide takes place only when all oxygen has been converted and, hence, is shifted to higher temperatures. As a possible consequence, the production of nitrous oxide is reduced. Nitric oxide and molecular oxygen react preferentially with carbon monoxide, so, in an excess of oxidizing component, gasification of the carbon support occurs at higher temperatures after carbon monoxide has been completely consumed.     

半导体芯片厂有害气体检测器使用经验之探讨

本文除概略介绍气体检测器的种类处，主要对气体检测器的原理和在实际使用中的局限性作一基本归纳叙述。限于篇幅，本文将论述的重点放在气体检测器的选用与设置规划上，提出个人的一点心得与看法，以作为未来设置气体检测器系统时之参考。     

用快切装置替代备自投装置提高厂用电安全可靠性

指出目前厂用电切换装置存在的不足，分析了快切装置的基本原理以及厂用电事故下的成功快切对电厂安全生产的意义，说明了在厂用电切换中尽快应用快切装置的必要性。