空冷发电厂的热力设计与分析

本文对热力发电厂的汽轮机排汽冷却系统进行了评估。作者编制了计算机程序,并对海勒式空冷系统做了计算,结果显示了塔高、水流速与空气流量、冷却塔与散热器投资以及经济效益的关系。     

强度型光纤传感器的信号检测系统

本文阐述了一种可提高强度型光纤传感器测量精度的检测系统。该系统利用同一检测电路交替检测信号、参考通道的输出信号，并将信号、参考两通道的检测结果相除，从而消除了因发光二极管光源波动及检测电路系统不稳定所带来的误差。采用同步相关技术抑制了噪声，提高了输出信噪比。实验证明，当时间常数ＲＣ为０．０５Ｓ时，采用该检测系统可获得优于千分之一的零点稳定性和优于２×１０３的输出信噪比。     

计算机控制的SEESR实验系统的研制

SEESR(Simultaneous Electrochemical ESR)是研究电极过程中的自由基中间体行为的理想和方便的手段。在以前研制的ESR仪数据系统的基础上,我们应用IBM-PC/XT微机与JES-FE1XG型(JEOL产)ESR谱仪及HDV-7型恒电位仪研制了一套由计算机控制的SEESR实验装置。该系统可以完成包括循环伏安法、电流阶跃、电位阶跃及电位反转等多种电化学方法的SEESR实验。系统还具有包括数据平滑、曲线拟合等功能的多种数据处理软件,使用方便。我们应用模型化合物对该系统进行了实际测量,所得结果与文献报道一致。     

排列互比法用于超精测角的研究

作者分析了我互比法现行的两种数据处理方法的缺点，提出了应用最小二乘法原理推导出合理的数据处理方法。本文还首次从理论上阐明了排列互比法测量结果中出现一次谐波系统误差的原因，提出了减少和消除这一些系统误差的方法，并给实验验证。     

Flexible and light weight copper indium diselenide solar cells on polyimide substrates

Thin film flexible CuInSe₂ (CIS) solar cells have been fabricated for the first time on light-weight polymeric substrates. Evaporated Cu---In alloy precursors were selenized in H₂Se atmosphere at around 400°C to grow the CIS absorber layers. Low temperature techniques which are compatible with the polymeric substrates were used to deposit the window layers of CdS and ZnO. The demonstrated active area conversion efficiency of 9.3% makes this light-weight device very attractive for many terrestrial and space power generation applications where high specific power and mechanical flexibility are needed.     

低旋流进气直喷燃烧系统在195柴油机上的应用研究

介绍了低旋流进气直喷燃烧系统应用于１９５柴油机的试验结果，着重探讨了燃烧室结构尺寸和供油系统主要参数对柴油机性能和燃烧放热规律的影响。研究表明，这种燃烧系统应用于小缸径直喷柴油机具有良好的推广前景。     

一种新型宽频带正交线极化馈源设计

本文介绍一种适用于散射通讯用的前馈抛物面宽频带正交器双线极化馈源设计,该馈源工作于0.8GHz频段。实践证明,该馈源在20％的工作带宽内基本上具有近似于旋转对称的波束,且系统VSWR<1.3。因此,对工作于较低频段的天线,该馈源是很好的选型。     

姚河坝水电站工程的重大地质变化及处理措施

介绍姚河坝水电站由于前期的地质勘探工作深度不够，在厂房后边坡、调压井和引水隧洞下段的施工过程中地质条件所发生的重大变化及具体处理措施，通过分析对工程投资和工期的影响，总结了其中的经验和教训。     

国外模拟IC的发展现状分析

本文主要根据电子整机的发展要求,从集成化、高性能和高可靠等三方面分析国外模似IC的发展,进而说明模拟IC总的发展趋势及其表现。最后指出,模拟IC正面临一个新的变革时期。     

Does the use of Solar Home Systems (SHS) contribute to climate protection?

The paper addresses planners and decision-makers in the field of international development cooperation and also institutions concerned with the impacts of project- and technology promotion. The primary aim of the dissemination of Solar Home Systems (SHS) in off grid areas in developing countries is to improve the living conditions of the population in a cost–effective manner. A large-scale dissemination is essential both for significant contributions to development and for climate effectiveness. However, the contribution of SHS to climate protection is disputed. This analysis presents the most important parameters affecting the contribution of SHS to climate protection and quantifies the influence of those parameters. The case considered presupposes the commercial dissemination of SHS. Greenhouse gas (GHG) emissions are affected by the marketing decisions of the supplier of SHS. With regard to the impact on GHG emissions, a comparison is made between traditional lighting with petroleum lamps and the use of dry cell batteries to operate small devices (baseline case) on the one hand and SHSs on the other. The comparison shows GHG savings of around 9 tonnes of CO₂ equivalent GHG emissions within a 20-year period of use of one single 50 Wp SHS compared with the baseline case. The result is robust with respect to variations in GHG-affecting variables. Petroleum consumption and dry cell batteries dominate GHG emissions balances to such an extent that scarcely any importance can be attached to GHG emissions from the transportation and manufacture of SHS. Therefore, it is permissible to use simplified GHG inventories which ignore the GHG emissions arising from the transportation and manufacture of SHS. Therefore the conclusion is, if SHS are commercially disseminated and used cost efficiently to substitute kerosene and dry cell batteries they reduce GHG emissions effectively. In that case SHS can make a significant contribution to climate protection by the dissemination of large numbers.