几种添加剂对模型石膏性能的影响

研究了N型减水剂、硅溶胶等添加剂对模型石膏凝结时间、强度、吸水率、溶蚀率等性能的影响,并确定了有关性能与添加量之间的关系,得出了最佳添加量。     

Ionic liquid mediated nano-composite polymer gel electrolyte for rechargeable battery application

ABSTRACT

Nano-composite polymer gel electrolytes (NPGEs) based on polymer poly(vinylidene fluoride-co-hexafluoropropylene) PVdF-HFP, ionic liquid, 1-butyl-3- methylimidazolium bis(trifluoromethanesulfonyl)imide BMIMTFSI, Li-salt along with the addition of SiO₂ nanoparticles have been synthesized and characterized by various techniques. Prepared NPGEs show high room temperature ionic conductivity (~10^?3 S/cm) and have a wide electrochemical window (ECW) (~3.3–3.5 V). The galvanostatic charge/discharge profile was studied by sandwiching best performing NPGEs between a LiFePO₄ cathode and lithium metal anode. The specific discharge capacity of the cell (Li/NPGE/LiFePO₄) room temperature at 0.1C rate is found to be 138 mAh/g.     

Ozone Contactor Hydrodynamics

Tracer tests were conducted at the 6,000 pounds of ozone per day Tucson, CAP Water Treatment Plant in Tucson, Arizona. The tests were designed to determine T₁₀ values through the contactors at various operating conditions. The tests were modeled using three techniques. Peclet Number was calculated for each of the runs, which would indicate the hydrodynamic conditions inside the ozone contactor. The results indicated that the increase in water flow rate and the number of cells with gas flow increased Peclet Number. The flow rate of liquid seemed to impact the Peclet Number more than gas flow. The headloss in each cell appeared to be important in controlling the distribution of liquid and gas through the cell. A correlation was developed between the product of gas and liquid phase Reynolds Number and Peclet Number.     

INVESTIGATION OF THE USE OF LASER-DOPPLER VELOCIMETRY IN TWO-PHASE BUBBLY FLOWS

Understanding the dynamic phenomena of viability loss of shear sensitive cells and bubble breakage and coalescence within airlift reactors requires knowledge of local, liquid-phase hydrodynamics. The laser-Doppler velocimeter (LDV) is a non-invasive instrument which may be used to obtain this information. Experimental procedures and software were developed to detect and measure Doppler bursts in two-phase flow in a split-cylinder airlift reactor. Off-line analysis of the data indicated a detection rate approximately one order of magnitude greater than that observed using an available commercial frequency tracker. Approximately 400 to 500 observations are needed for the ensemble mean to characterize the local mean velocity to within ±5% for a superficial gas velocity of 10.4 cm/s, the highest superficial gas velocity used in these studies. The limitations, prospects, and signal-processing options for LDV in this application are also discussed     

ABSORPTION OF CO2 INTO AQUEOUS SOLUTIONS OF STERICALLY HINDERED METHYL AMINOETHANOL USING A HYDROPHOBIC MICROPOROUS HOLLOW FIBER CONTAINED CONTACTOR

The absorption of dilute CO₂ into aqueous solutions of sterically hindered 2-methyl aminoethanol (MAE) and the desorption of CO₂ from CO₂-loaded MAE solutions into N₂ stream were investigated separately for the various combinations of operational variables, using a hydrophobic microporous hollow fiber (polytetrafluoroethylene, PTFE) contained gas-liquid contactor with aqueous solutions of MAE as liquid media in the shell side at 30°C. The absorption of CO₂ in this contactor is governed by resistance in the liquid and hollow fiber phases. The resistance to diffusion in the hollow fiber phase amounts to 76-80% of the total resistance. Nevertheless, the absorption rates of CO₂ into aqueous MAE solutions in this contactor are higher than those into aqueous solutions of sterically hindered 2-amino-2-methyl-1-propanol (AMP) in the stirred tank with a plane unbroken gas-liquid interface. The process of desorption of CO₂ from CO₂-loaded MAE solutions can be regarded as being controlled by diffusion and chemical reaction in both the stagnant film of the liquid phase and the liquid-filled pore of the hollow fiber phase under the slow or intermediate reaction regime. Both absorption and desorption rates under the simultaneous absorption-desorption operation in a single unit tend to approach the respective constant values as process time elapses. The total absorption rate here seems to be almost balanced with the total desorpion rate at the constant mass transfer rate periods.     

Removal of mineral material from solvent-refined coal by solvent extractions

Solvent refined coal (SRC), a coal extract which is highly polyaromatic in character and relatively high in N, O and S content, is derived from the direct liquefaction of coal. SRC contains mineral matter in the form of soluble organometallic compounds which can not be removed by filtration. These soluble species can be detrimental to the hydrocracking catalyst used in the upgrading of the SRC to high-value liquid fuels. These species, however, can be separated from the SRC by extraction with benzene or tetralin as solvents so that the mineral matter is mainly concentrated in the solvent-insoluble fraction, the other fraction are then readily hydrocracked, as demonstrated in this work.     

环己烷液相无催化剂的氧化动力学研究

采用搅拌釜反应器,在确认已排除传质因素对反应速率影响的情况下,研究了环己烷液相无催化剂的氧化反应动力学。应用自由基理论及最优化计算技术,从导出的8个候选动力学模型中,确定了最佳的动力学模型,它能满意地描述环已烷氧化过程。该动力学可为环己烷氧化工业生产操作条件的优化、反应器的选型及工业设计提供依据。     

磷渣对硅酸盐水泥凝结时间的影响及机理

重点研究了磷渣对硅酸盐水泥凝结时间的影响,以及几种常用外加剂硫酸钠、烧石膏和烧明矾石对磷渣水泥凝结时间的改善,并研究了一种以硫铝酸钙为主要矿物组成的合成外加剂的作用。结果表明磷渣的掺量与比表面积对磷渣硅酸盐水泥的缓凝作用非常大,硫酸钠和合成外加剂对磷渣的缓凝的改善效果最佳,烧石膏与烧明矾石的作用不显著。通过对磷渣的缓凝机理的研究,指出了磷渣中的PO43-溶出对水泥的缓凝作用。     

应用微扰理论（PHCT）诠释MH—55状态方程

用硬链微扰理论分析了ＭＨ－５５型状态方程。首次改进了该方程中的参考项，以ＣＳ硬球方程替代了原来的ｖａｎｄｅｒＷａａｌｓ斥力项，使改进后的ＭＨ－５５方程计算范围扩大到汽液两相。     

GPU accelerated online multi-particle beam dynamics simulator for ion linear particle accelerators

An online beam dynamics simulator is being developed for use in the operation of an ion linear particle accelerator. By employing Graphics Processing Unit (GPU) technology, the performance of the simulator has been significantly increased over that of a single CPU and is therefore viable in the demanding accelerator operations environment. Once connected to the accelerator control system, it can rapidly respond to any control set point changes and predict beam properties along an ion linear accelerator in pseudo-real time. This simulator will be a virtual beam diagnostic tool which is especially useful when direct beam measurements are not available. Details about the code structure design, physics algorithms, GPU implementations, and performance are presented.