DTA measurements of normal-incommensurate phase transition in (NH4)2ZnCl4 and K2ZnCl4 crystals

Differential thermal analysis (DTA) was applied to determine the changes in enthalpy and entropy of (NH₄)₂ZnCl₄ and K₂ZnCl₄ crystals at their phase transition from the orthorhombic normal phase to the incommensurate phase. The temperature of this transition, T _i , is 406 K for (NH₄)₂ZnCl₄ and 555 K for K₂ZnCl₄ and the entropy changes (S/R) are 0.053 and 0.035, respectively. The low value obtained for S/R is characteristic of incommensurate phase transitions. The results were compared with the data reported for other crystals of the A₂BX₄ family. Thermal properties of the crystals of the A₂ZnCl₄ subgroup were found to the correlated with the length of A-Cl bonds.     

Solid-liquid phase equilibria of benzene + 2-methyl-2-propanol system under high pressures

Solid-liquid phase equilibria of the benzene + 2-methyl-2-propanol system have been investigated at temperatures from 278 to 323 K and pressures up to 300 MPa using a high-pressure optical vessel. The uncertainties of the measurements of temperature, pressure and composition are within ±0.1 K, ±0.5 MPa, and ±0.001 mole fraction, respectively. The freezing pressure at a constant composition increases monotonously with pressure. The eutectic point shifts to a higher temperature and benzene-rich composition with increasing pressure. In order to describe the pressure-temperature-composition relation of high-pressure solid-liquid phase equilibria, a new simple equation has been proposed as follows:

Thermal transport behavior of van der Waals solids and liquids in the neighborhood of the solid-liquid phase transition

The thermal conductivity, , is one of the few transport coefficients which shows a relatively small change at the solid-liquid phase transition, and hence it is a property that can be used in comparing dynamic properties of both ordered and disordered systems. Although the discontinuity in can be accounted for largely by the difference in density, , of solid and liquid at the phase transition, its volume dependence is examined more closely. The thermal diffusivity, which is known to dominate the dynamic structure factor of liquid argon, has been determined around the phase transition also; the sound velocity has been considered in addition. The results are discussed and a comparison is made with these properties in solid and liquid benzene and cyclohexane.Paper presented at the Ninth Symposium on Thermophysical Properties, June 24–27, 1985, Boulder, Colorado, U.S.A.     

Magnetic and mössbauer studies on ductile Fe-Cr-Co permanent magnet alloys

Iron-chromium-cobalt alloys possess attractive magnetic properties combined with good formability and hence are identified as technologically important magnetic materials. Alloys with compositions Fe-28·9 Cr-15·6 Co and Fe-28·4 Cr-20·1Co (weight percent) have been studied. Heat-treatment parameters during thermomagnetic treatment viz temperature, time and external magnetic field were optimized with reference to magnetic properties. The fully treated anisotropic alloys develop remanence=11·5–12·0 kilo Gauss, coercivity=600–650 Oersted and energy product=4–4·5 million Gauss Oersted. Electron microscopic and Mössbauer spectroscopic techniques were used to identify the original and transformed phases. During the various stages of the development of the alloy, the changes in mechanical hardness were correlated with magnetic hardness.     

Site occupations and ordering behaviour of O phase in Ti2AlNb—based intermetallics

1　ＩＮＴＲＯＤＵＣＴＩＯＮＴｈｅｏｒｔｈｏｒｈｏｍｂｉｃａｌｌｏｙｓａｒｅｏｆｇｒｅａｔｔｅｃｈ ｎｏｌｏｇ ｉｃａｌｉｎｔｅｒｅｓｔｉｎｈｉｇｈｔｅｍｐｅｒａｔｕｒｅａｐｐｌｉｃａｔｉｏｎｓｓｉｎｃｅｔｈｅｙｈａｖｅａｇｏｏｄｂａｌａｎｃｅａｍｏｎｇｓｔ     

Characterization of blasted austenitic stainless steel and its corrosion resistance

It is known that the corrosion resistance of stainless steel is deteriorated by blasting, but the reason for this deterioration is not clear. A blasted austenitic stainless steel plate (JIS-SUS304) has been characterized with comparison to the scraped and non-blasted specimens. The surface roughness of the blasted specimen is larger than that of materials finished with #180 paper. A martensite phase is formed in the surface layer of both blasted and scraped specimens. Compressive residual stress is generated in the blasted specimen and the maximum residual stress is formed at 50–100 μm from the surface. The corrosion potentials of the blasted specimen and subsequently solution treated specimen are lower than that of the non-blasted specimen. The passivation current densities of the blasted specimens are higher those of the non-blasted specimen. The blasted specimen and the subsequently solution treated specimen exhibit rust in 5% sodium chloride (NaCl) solution, while the non-blasted specimen and ground specimen do not rust in the solution. It is concluded that the deterioration of corrosion resistance of austenitic stainless steel through blasting is caused by the roughed morphology of the surface.     

FORMATION OF MANGANESE SILICIDE THIN FILMS BY SOLID PHASE REACTION

1. IntroductionThe transition metal silicides have attraeted much attention because of their potentialapplicatiOIl in very large scale integration (VLSI) de.ice[1]. Near-noble metal silicides canbe used as Schottky al1d ohn1ic col1tacts in silicon-based d…     

氰化氢在终冷塔中气液两相之间转移的研究

分析了煤气中氰化氢的形成,论述了氰化氢在煤气和其冷凝液中的平衡机理,讨论了影响氰化氢相平衡的因素,研究了直接终冷、间接终冷时煤气中氰化氢的转移情况。     

Polylactide films formed by immersion precipitation: Effects of additives,nonsolvent, and temperature

The influence of nonsolvent, crystallinity of the polymer film, and addition of dodecane (a poor solvent for the polymer and for the nonsolvent) on the morphology of polylactides films has been investigated and was related to phase separation behavior. Both amorphous poly‐DL ‐lactide (PDLLA) and crystalline poly‐L ‐lactide (PLLA) were dissolved in dichloromethane, and subsequently films were made by immersion in nonsolvent baths. PDLLA gave dense films without any internal structure, since the structure was not solidified by crystallization or glassification. PLLA films show varying structure depending on the nonsolvent. With methanol, asymmetric morphologies were observed as a result from combined liquid‐liquid demixing and crystallization, while with water symmetric spherulitic structures were formed. As a next step, dodecane was added, which is not miscible with the nonsolvent, and we found it to have a strong influence on the morphology of the films. The PDLLA films with dodecane did not collapse: a closed cell structure was obtained. In PLLA films, dodecane speeds up phase separation and induces faster crystallization in the films, and the porosity, size of the pores, and interconnectivity increased. When the PLLA solutions were subjected to a heat pretreatment, crystallization could be postponed, which yielded a cellular structure around dodecane, which did not contain spherulites anymore. © 2007 Wiley Periodicals, Inc. J Appl Polym Sci 104: 959–971, 2007     

Monoterpene concentrations in fresh,senescent, and decaying foliage of singleleaf pinyon (Pinus monophylla Torr. & Frem.: Pinaceae) from the western Great Basin

Senescent foliage from pines is potentially a large contributor to the total monoterpene content of the litter layer, and the availability of these compounds as phytotoxins may result from release of these compounds into the vapor phase. In order to determine the fate of several monoterpene hydrocarbons in the natural environment, we examined their concentrations in fresh, senescent, and decaying needles from 32 single-leaf pinyon pine (Pinus monophylla Torr. & Frem.: Pinaceae) trees growing at two different locations. Total monoterpene content was highest in the fresh needles (mean=5.6 ± 2.2 mg/g extracted air dry weight), but also remained relatively high in senescent needles (mean=3.6 ±1.8 mg/g extracted air dry weight), either still attached to the tree or forming the freshest layer of understory litter. Decaying needles within a dark decomposing layer of litter material 5–20 cm from the surface were found to contain much lower amounts of total monoterpenes (average: =0.12 ±0.06 mg/g extracted air dry weight). Further investigation of the fate of these compounds in the pinyon understory is required to determine if these hydrocarbons are indeed exerting phytotoxic characteristics.