Structural changes and mechanical performance of recycled poly(vinyl chloride) bottles exposed to ultraviolet light at 313 nm

The structural changes and mechanical performance of virgin poly(vinyl chloride) (PVC) bottle (VB) compounds blended with postconsumer PVC bottles collected from a specified factory (RB‐F) and houses (RB‐H), were examined before and after UV irradiation at 313‐nm UV wavelength for different periods of time up to 28 days. The results indicated that, when exposed to UV light, the RB‐F/VB blends containing greater conjugated double bonds with higher yellowness index appeared to exhibit better mechanical performance than that of the RB‐H/VB blends. It was found that the amount of conjugated double bonds was not a linear function of the discoloration level of PVC compounds. Tensile strength of the VB compounds was not affected when incorporated with RB‐F recyclate, but progressively decreased with increasing RB‐H recyclate. An optimum concentration for RB recyclates to be added into the virgin compound was recommended for obtaining a maximum impact strength. Both tensile and impact strengths decreased with increasing UV exposure time, a severe degradation being obvious after a UV exposure time of 21 days. Hardness was not affected significantly by the addition of PVC recyclate, but increased with increasing UV exposure time. © 2004 Wiley Periodicals, Inc. J Appl Polym Sci 92: 84–94, 2004     

Domestic and Industrial Wastewater Treatment with Ozonated Activated Sludge

Poor sludge settleability is a problem encountered in many activated sludge wastewater treatment plants. This study was aimed at combatting the unwanted biological growths at the root of this phenomenon with ozone. Ozone dosed directly into the aeration basins of small activated sludge pilot plants treating both domestic and synthetic fuel wastewaters led to a substantial reduction of the bulking problem even at dosages as low as 6 to 10 mg/L. Ozone did not interfere in the delicate nutrient removal processes and significantly enhanced effluent quality.     

Methacrylic acid and dodecyl methacrylate (MAc‐DMA) hydrogel for enhanced catalytic activity of lipase of Bacillus coagulans MTCC‐6375

An alkaline thermotolerant bacterial lipase of Bacillus coagulans MTCC‐6375 was purified and immobilized on a methacrylic acid and dodecyl methacrylate (MAc‐DMA) hydrogel. The lipase was optimally bound to the matrix after 20 min of incubation at 55°C and pH 9 under shaking conditions. The matrix‐bound lipase retained approximately 50% of its initial activity at 70–80°C after 3 h of incubation. The immobilized lipase was highly active on medium chain length p‐nitrophenyl acyl ester (C: 8, p‐nitrophenyl caprylate) than other p‐nitrophenyl acyl esters. The presence of Fe³⁺, NH₄⁺, K⁺, and Zn²⁺ ions at 1 mM concentration in the reaction mixture resulted in a profound increase in the activity of immobilized lipase. Most of the detergents partially reduced the activity of the immobilized lipase. The immobilized lipase performed ～62% conversion in 12 h at temperature 55°C. © 2006 Wiley Periodicals, Inc. J Appl Polym Sci 100: 1420–1426, 2006     

工业污水深度处理回用技术研究

通过对石化企业工业污水进行曝气生物滤池、连续微滤、反渗透等深度处理,使出水满足工业化用水的水质要求,从而得以回用。     

Reactive‐extrusion route for the closed‐loop recycling of poly(ethylene terephthalate)

The effectiveness of the reactive extrusion technique was investigated for poly(ethylene terephthalate) to promote the concept of closed‐loop recycling, that is, the reuse of waste material in the initial application. More specifically, a chain‐extender system, consisting of pyromellitic dianhydride, polyol, and a catalyst, was employed, and its efficiency regarding the improvement of the recyclate quality was evaluated. Accordingly, rheological and thermal characterizations were performed and used as criteria of the modification induced in the polymer molecular structure during processing due to the counteracting degradation and chain‐extension reactions. In particular, the molecular weight, related to intrinsic viscosity and melt flow rate measurements, of modified poly(ethylene terephthalate) samples was found to increase with the additive content. Simultaneously, a decrease in the crystallinity was observed, attributed to the branching effect of the chain extender, which restricted the ability of the macromolecules to organize in the crystal structure. Beyond a critical concentration of the additive system, the molecular weight of the treated samples started to decrease again, and this was accompanied by a small increase in the crystallinity. © 2007 Wiley Periodicals, Inc. J Appl Polym Sci 104: 1671–1678, 2007     

无机复合混凝剂ISF-01处理日用化学工业废水的研究

研究了新型无机复合混凝剂ISF-01对日用化学工业废水的絮凝、破乳效果及混凝剂用量和体系pH值对混凝效果的影响,并与其它无机絮凝剂进行了比较。试验结果表明．ISF-01混凝剂有较宽的pH适用范围,对日用化学工业废水具有良好的混凝效果,与传统混凝剂相比,它具有破乳性能好、投药量少、絮体沉降速度快、上清液透光性能好的特点。     

Feedback PID-like fuzzy controller for pH regulatory control near the equivalence point

In this research the use of a feedback PID-like fuzzy controller scheme for pH control is presented to deal with instability problems near the equivalence point in neutralization processes. State space analysis of the titration curves and a fuzzy clustering algorithm based on calculating a measure of potential derived from the square distance of the pH data are complementary applied to define the membership structure and the fuzzy sets of the controller. To test the performance of the controller, both simulated and experimental runs were used. The fuzzy controller was tested for compensating step-change perturbations of propionic acidic flow rates, propionic acid concentration, and buffering conditions. Stationary cycling behavior has been observed for large loads of acidic flow rates. It was found that though the rejection time was strongly dependent on the mean residence time of the liquid solutions, the proposed controller keep the neutralization process operating close to the specified set point of pH = 7.     

开放式热风穿流干燥蔬菜降低能耗的研究进展

开放式热风干燥（AD）工艺以其设备成本低、操作和维修简单等特点，在国内大批量脱水蔬菜生产中仍占有较高的比例。但开放式AD蔬菜的能耗高，故对其进行节能技术研究是项急需而有意义的。我们可以从AD工艺前处理、AD和其它干燥方法联合、干燥系统改进、余热回收以及工艺参数再优化等5个方面来降低AD蔬菜生产中的能耗。     

污水厂污泥制地砖及共性能

参照普通陶瓷砖的生产工艺，烧制污泥地砖，对其抗压、抗折、抗磨损性能、腐蚀性能及影响因素进行检测和分析，以探讨用城市污水处理污泥制造地砖的可能性。实验表明：随污泥含量增加，烧制成品的抗压强度显著下降，抗折强度略有增加。细粒径污泥粉配料有利于提高制品整体强度。采用复合材料结构可提高制品的抗压强度。成品的抗磨损性能优于普通砖的，略低于普通市售陶瓷砖的。这种地砖的水浸出液不具有腐蚀性能，且污泥中所含重金属Mn，Cu被很好固化在砖中而不能渗出。     

Feasibility of Sludge Ozonation for Stabilization and Conditioning

A pilot-scale sludge treatment plant was built to investigate the feasibility of ozonation processes for waste activated sludge treatment. Ozonation of wastewater sludge resulted in mass reduction by mineralization as well as by supernatant and filtrate recycle. Another advantage of sludge ozonation is a significant improvement of settleability and dewaterability. Experimental results showed that mass reduction of 70% and volume reduction of 85% compared with the control sludge was achieved through the sludge ozonation at a dose of 0.5?gO₃/gDS. It is also interesting to note that the filterability deteriorates up to ozone dose of 0.2?gO₃/gDS and then improves considerably at a higher ozone dose. The filterability could be improved by chemical conditioning even at a low ozone dose. The economic feasibility by cost analysis reveals that ozonation processes can be more economical than other alternative processes for sludge treatment and disposal at small-sized wastewater treatment plants.