Sulfur in chromia

The solubility of sulfur in chromia has been studied in H₂-H₂O-H₂S tagged with³⁵S at 973 and 1173 K at low oxygen and sulfur partial pressures typical for coal gasification-systems. For monocrystalline samples, it has been shown that sulfur-containing species are only present adsorbed on the surface of the specimens and can be removed by ultrasonic cleaning in acetone. The surface coverage after 4 weeks of exposure to H₂-H₂O-H₂S was between 2.8 and 19.3% of a monolayer. In polycrystalline chromia, sulfur was located only in pores and cracks of the sample. In dense, compact areas of the specimens the solubility of sulfur was below the detection limit of autoradiography, which was estimated to be better than 0.17 ppm.     

Selective solvation of polystyrene in tetralin/cyclohexane mixtures

Refractive index increments and density increments have been measured at 307.6K for polystyrene in binary solvents of 1,2,3,4-tetrahydronaphthalene (tetralin, TET) and cyclohexane over the whole range of solvent composition. Comparison of these increments with the corresponding values obtained at dialysis equilibrium (i.e. at constant chemical potential of low molecular weight species) yielded the coefficients of selective adsorption (γ₁) of TET by the polymer. Positive values of γ₁ were exhibited at solvent compositions up to 78% (v/v) of the thermodynamically better solvent, TET. Theoretical curves of γ₁ vs. composition were calculated on the basis of, firstly, relevant interaction parameters and, secondly, interaction parameters in conjunction with solubility parameters. Both procedures afforded self-consistent results, which were, however, uniformly lower than the experimental values of γ₁.     

IR study of the interaction of hydroxyl groups of silica gel with Cr species of Phillips' type catalysts

Spectroscopic evidence for the interaction of hydroxyl groups and chromium ions was obtained using a catalyst prepared from chromyl chloride. A new OH peak, observed at 3705 cm^–1 after pumping away CO gas, is attributed to the direct interaction of OH with the low-valent chromium. This peak shifts to 3590 cm^–1 on contact with O₂ at room temperature and it is assigned to a hydroxyl interacting with the oxidized chromium. New assignments are also proposed for IR bands of CO presorbed on the catalyst. The peak due to CO at 2188 cm^–1 decreases as the OH intensity at 3705 cm^–1 increases, suggesting that the former peak arises from adsorption on Cr(II) species to which two oxygen atoms are attached.     

Surface properties of ZSM-5 modified by phosphorus

Phosphorus modification of ZSM-5 leads to extra framework P⁵⁺ and probably incorporation of +3 valence state of P in the framework. The resulting system has increased Brønsted acidity. Theoretical calculations also favour the postulate that phosphorus in +3 valence state can be incorporated into the lattice.     

Preparation,characterization, and adsorption properties for metal ions of a novel chelating resin containing sulfoxide and diethylene glycol

A novel chelating resin containing sulfoxide and diethylene glycol, poly{4‐vinylbenzyl‐[2‐2‐(hydroxyethyl)ethoxyl]sulfoxide} (PVESO) was synthesized using chloromethylated polystyrene (PS‐Cl) as material. Its structure was characterized by elemental analysis, infrared spectra, and scanning electron microscopy (SEM). The adsorption capacities of the resin for Hg²⁺, Ag⁺, Cu²⁺, Zn²⁺, and Pb²⁺ at various pH values were determined. The maximum adsorption capacities for Hg²⁺ and Ag⁺ were 1.56 and 0.75 mmol g^?1 respectively. The resin had high selectivity for Hg²⁺ and Ag⁺ over the pH range 1.0–7.0. The adsorption capacities for Hg²⁺ and Ag⁺ under competitive condition were also determined by batch experiment method. In addition, the adsorption kinetics of the resin towards Hg²⁺ at different temperatures was also investigated. The results showed that the adsorption rate was governed by film diffusion at 20°C and 25°C, by particle diffusion at 30°C and 35°C. © 2006 Wiley Periodicals, Inc. J Appl Polym Sci 102: 6054–6059, 2006     

Phosphate sorption approach for determining phosphorus requirements of wheat in calcareous soils

Five field experiments involving P application rates from 0 to 66 kg P ha^–1 were conducted on irrigated wheat at Tandojam, Pakistan. The soils belonged to two great soil groups, Torrifluvent and Camborthid. All soils were calcareous. Olsen-P contents ranged from 3.5 to 6.3 mg P kg^–1. Phosphate sorption curves were developed for soils from control (no P) plots at each site. Concentrations of P in solution established by fertilization in the field as estimated from the sorption curves ranged from 0.008 to 0.16mg P L^–1. Actual grain yields were converted to relative grain yields and plotted against corresponding concentrations of P in solution. Yield response to P application was obtained in each experiment. Control plot yields ranged from 57 to 89% of maximum yield of respective experiments. Phosphorus requirements of wheat were 0.032 mg L^–1 for 95% yield as determined from a composite yield response curve. Predicted quantities of P required to attain 0.032 mg P L^–1 ranged from 18 to 29 kg P ha^–1. The results of the study suggest that the P sorption approach can be used as a rational basis for making P fertilizer recommendations for various soil-crop combinations.     

炭分子筛概述

阐述了炭分子筛分离的原理，并分别从其制备原料、制备方法、产品用途等方面综述了近年来炭分子筛的新进展。     

Adsorption isotherms of sesame oil in a concentrated miscella system

The adsorption of peroxides, unsaturated carbonyls, free fatty acids and carotenoids from unrefined sesame oil on vegetable carbon (5%, w/w) in a miscella system was studied. Three different solvent conditions (hexane/ethanol, 100:0, 95:5 and 75:25, vol/vol), combined in a factorial design with five levels of solvent (0, 10, 20, 30 and 40%, w/w), were used to develop the miscella. Equilibrium adsorption was not achieved during the 100 min of adsorption, mainly because the oil components were involved in oxidation reactions during the adsorption process. However, for a given solvent concentration, adsorption of the oil components showed a significant linear regression on their respective initial concentration in the miscella (C_i). Peroxides and carbonyls showed, at all solvent levels investigated, an affinity for the carbon more independent of their C_i than free fatty acids and carotenoids. In general, at the same C_i, a higher adsorption was achieved as solvent concentration increased. The results indicated that free fatty acid adsorption may depend on competitive adsorption based on molecule hydrophobicity. However, in spite of the higher hydrophobicity of carotenoids, compared with free fatty acids, they might not be competing for the same adsorbing sites. Ethanol showed a prooxidant effect that increased peroxide production during adsorption but did not affect the reaction involved in carbonyl production.     

改性活性炭的表面特性及其对苯酚的吸附性能

研究了表面改性对活性炭吸附苯酚性能的影响。研究发现,硫酸氧化可增加活性炭表面酸性基团的含量,提高了活性炭的表面亲水性,降低pHPZC值,因而对吸附水中的苯酚的性能产生明显影响,降低了对苯酚的吸附。     

氧化铝上吸附平衡与动力学的分形特性

在实验测定氧化铝吸附氮气的平衡和动力学过程的基础上 ,由平衡数据得到分形维数 ,对动力学结果分别用欧氏几何和分形几何的动力学模型进行处理 ,比较两种方法得到的扩散系数之间的差别。结果表明 :粉状氧化铝的分形维数为 2 .12 ;采用分形动力学模型得到的扩散系数同欧氏几何扩散模型的结果不一样 ,扩散系数不随浓度的变化而改变 ;而欧氏几何扩散模型中的扩散系数随浓度变化发生改变 ,且变化符合Darken关系