武钢 3×10~4m~3/h 空分手动变负荷生产的探索与实践

对武钢引进的两台３×１０４ｍ３／ｈ空分设备，为改变其自动变负荷生产调节范围小、时间长的问题，采用了人工手动变负荷的操作方法。实践表明：扩大了增减产范围，缩短了调节时间，有十分明显的综合经济效益，可供大型空分变负荷生产借鉴参考。     

4TYD112型离心空压机联轴器故障的分析及处理

对新冶钢动力厂制氧机组配套的原料空气压缩机故障现象进行了原因分析,并有针对性地提出了处理措施,经运行检验,故障基本消除。     

挑坎型掺气减蚀设施过流掺气特性研究

采用一维激光测速系统，对掺气减蚀工程中常用的直线型挑坎的流场特性进行试验研究．通过测量挑坎上及空腔区水流的流速分布及紊动特性，探讨通气量与紊动强度的关系．同时在深入研究流场特性和掺气机理的基础上，通过分析影响掺气的因素，从理论上探求临界掺气流速的计算，重点分析挑坎型掺气过流在空腔负压较大的情况下，临界掺气条件的理论预测，并通过试验资料验证了该计算方法．在此基础上，还进一步研究了掺气量的计算公式及其变化规律．     

气囊内模制作桥面板在华丰湾防洪工程中的应用

采用气囊作内模进行浇筑桥面板混凝土 ,加快了预制桥面板施工进度 ,确保工程施工质量 ,并降低了工程施工成本     

高浓度钢渣粉尘环境发动机空气过滤系统的改进与维护

针对液压挖掘机在高浓度钢渣粉尘作业环境下,钢渣粉尘对发动机的损害,分析了发动机空气滤清器的作用,阐述了传统空气过滤系统存在的问题,提出了改进的方案与维护措施.     

炼厂碱渣处理工艺及设计优化

针对催化裂化装置汽油和液态烃精制产生的含硫废弃物的碱渣处理，讨论了碱渣提酚、碱渣湿式氧化脱臭两种处理工艺的环境治理效果，并就碱渣湿式氧化脱臭工艺如何降低运行成本、减少污水排放等内容进行了探讨。     

Kinetics of phenol oxidation in a trickle bed reactor over active carbon catalyst

The wet air oxidation of phenol over a commercial active carbon catalyst was studied in a trickle bed reactor (TBR) in the temperature and oxygen partial pressure ranges of 120–160 °C and 0.1–0.2 MPa, respectively. The performance of the active carbon was compared in terms of phenol and COD destruction. The weight change of active carbon due to reaction was also measured. Finally, oxic phenol adsorption isotherms were assessed in batch conditions at 25, 125 and 160 °C. In order to use the conversion data obtained from the TBR for a kinetic study, special care was taken to check the kinetic control in the TBR experiments. Several kinetic models including power law or Langmuir–Hinshelwood expressions were considered to describe the catalytic oxidation of phenol over active carbon. The simple power law model with first order dependence on both phenol and oxygen concentration predicted satisfactorily the experimental data not only over the entire range of operating conditions studied, but also outside its validity range. Copyright © 2005 Society of Chemical Industry     

The Danish Twin Apartment Study – Part II: Mathematical modeling of the relative strength of sources of indoor air pollution

Abstract This study deals with the modeling of air pollution in apartments from laboratory measurements of source strengths, using formaldehyde and Total Volatile Organic Compounds (TVOCs) as model pollutants. The sources in two test apartments were grouped into two: building-related sources and occupant-related sources. The measured source strengths and ventilation rates were used for the prediction of concentrations expected in the apartments. These predictions were compared to measurements in the apartment over 12 months. The conclusions were that the model predictions based on emission rates measured in the laboratory can be used to predict the long-term concentration of the two model pollutants in the apartments. Considering the measured differences in ventilation between the apartments, an occupant emission rate of between 0.2 and 0.3 mg/h/kg body weight could be estimated. Based on previous suggested limits of acceptable exposures of humans to VOCs, an acceptable average emission rate of VOCs from building materials in general was estimated to be about 30 (μ/m²/h. The modeling showed that during the first 200 days, building materials dominated the emissions. After this, sources relating to the occupants dominated. On average about half of the VOC pollution originated from the building materials.     

DA200－61型离心式空气压缩机振动超标治理

本文给出了用振动谱分析方法对一种大型空气压缩机油膜自激振荡进行故障诊断的实例。     

固井设备发动机防爆系统研究

针对目前固井设备不具备防爆功能的问题, 烟台杰瑞石油装备技术有限公司研制了JCMS210固井混浆橇中Detroit8V—71N发动机防爆气控系统。在对柴油发动机的引燃源进行分析后, 阐述了防爆气控系统设计方案, 给出气控系统工作原理图。室内试验和中海油田服务股份有限公司的现场使用证明, 这种防爆气控系统性能良好, 工作可靠, 能满足ZONE2的防爆要求, 解决了固井设备的防爆问题。