"摩圣"技术在空气压缩机上的应用

介绍了4L-20/8型空气压缩机采用"摩圣"技术后的运行情况。"摩圣"技术在设备正常运行条件下能成功修复摩擦副的磨损,使之恢复原设计的尺寸和要求,因而提高了生产效率,取得了显著的经济效益。     

小型别墅中央空调的新风设计

提出了小型别墅中央空调新风处理的方法，就某别墅采用本方法作中央空调新风设计，并以其计算数据为依据，验证了本方法的可行性。     

钢坯修磨金属切除率数学模型的研究

从分析修磨过程运动学和单个磨粒切削入手,建立了磨削深度与磨削过程诸参数(如工艺、材料性能、砂轮性能等)的关系表达式,从而建立起金属切除率与各单项参数的定量关系,为改善或提高修磨效率和修磨过程控制提供了有意义的根据。理论分析与实验结果吻合良好。     

码分多址（CDMA）技术和公用空中接口综述

本文主要讨论数字移动通信中扩频码分多址技术，阐明了ＣＤＭＡ体制的优越之外，分析了ＣＤＭＡ的关键技术，全面介绍了ＣＤＭＡ系统设计的基本原则和ＩＳ－９５－Ａ空中接口标准的含义。     

Design and Characterization of the CLIMPAQ,Chamber for Laboratory Investigations of Materials,Pollution and Air Quality*

A test chamber has been developed in order to provide a small and simple emission testing facility capable of testing construction products in a climate where the important climatic parameters such as temperature, ventilation rate and air velocity can be varied independently around typical indoor values. The test chamber CLIMPAQ is made of panes of window glass. Other main surface materials are stainless steel and eloxated aluminium. The chamber has a volume of 50.9 litres and is designed to meet the requirements for quantifying air pollution. In this investigation human subjects acted as air pollution judges, and chemical characterization of the air pollution was carried out. Carpet, linoleum, wall paint and seal- ant were tested simultaneously in the CLIMPAQ and in four other chambers ranging from a full-scale chamber of 28 m³ to a field and laboratory emission cell of 3.5· 10^?5m³. Product ranking is the same in all chambers for the sensory measurements. Emission rates based on sensory measurements differ for all products less than 100 % except for tests in a 3-litre chamber where emission rates were higher. Chemical measurements differ up to approximately 10 times for the same product in different chambers. Deviations appear to be the result of different environmental parameters in the various chambers. Low air concentrations or high specific ventilation rates seem to increase emissions, while differences in air velocities and sink properties may also be the cause of differences in emission rates.     

用发生炉煤气进行快速热风烤窑的应用

用发生炉煤气进行快速热风烤窑的应用王善波，王志军（山东荣成市玻搪工程有限公司２６４３０９）ＰｒｏｄｕｃｅｒＧａｓＵｓｅｄｆｏｒＦａｓｔＨｅａｔｉｎｇｕｐＴａｎｋＦｕｒｎａｃｅ￥ＷａｎｇＳｈａｎｂｏ；ＷａｎｇＺｈｉｊｕｎ（ＳｈａｎｄｏｎｇＲｏｎｇｃｈｅ...     

大泵站超驼峰水位运行压缩空气断流系统的设计方法

阐述了压缩空气断流的原理，提出了压缩空气断流装置的一般构成和设计方法，首次应用气体喷射器作为压缩空气减压增量变换器，不但及时地增加了补气量，防止断流后流道压力的下降，而且大大减小了储气罐容积，使该项技术得以满足工程实际的要求，为同类泵站的技术改造     

武钢 3×10~4m~3/h 空分手动变负荷生产的探索与实践

对武钢引进的两台３×１０４ｍ３／ｈ空分设备，为改变其自动变负荷生产调节范围小、时间长的问题，采用了人工手动变负荷的操作方法。实践表明：扩大了增减产范围，缩短了调节时间，有十分明显的综合经济效益，可供大型空分变负荷生产借鉴参考。     

气囊内模制作桥面板在华丰湾防洪工程中的应用

采用气囊作内模进行浇筑桥面板混凝土 ,加快了预制桥面板施工进度 ,确保工程施工质量 ,并降低了工程施工成本     

Kinetics of phenol oxidation in a trickle bed reactor over active carbon catalyst

The wet air oxidation of phenol over a commercial active carbon catalyst was studied in a trickle bed reactor (TBR) in the temperature and oxygen partial pressure ranges of 120–160 °C and 0.1–0.2 MPa, respectively. The performance of the active carbon was compared in terms of phenol and COD destruction. The weight change of active carbon due to reaction was also measured. Finally, oxic phenol adsorption isotherms were assessed in batch conditions at 25, 125 and 160 °C. In order to use the conversion data obtained from the TBR for a kinetic study, special care was taken to check the kinetic control in the TBR experiments. Several kinetic models including power law or Langmuir–Hinshelwood expressions were considered to describe the catalytic oxidation of phenol over active carbon. The simple power law model with first order dependence on both phenol and oxygen concentration predicted satisfactorily the experimental data not only over the entire range of operating conditions studied, but also outside its validity range. Copyright © 2005 Society of Chemical Industry