电信网络管理的望族——TMOS

电信管理及运营支撑是爱立信公司为公用电信网提供的有关管理及运营支撑功能的综合方案，本文介绍了其中的公网管理系统和蜂窝移动网络管理系统。     

Adaptive control in a heating vessel: A comparative study

This paper presents experimental results obtained in temperature adaptive control of a heating vessel. A non-linear model of the process showed that the feed flow rate causes severe variations in time constant and process gain. An extended horizon self-tuning controller and two different model reference adaptive controllers were tested. The influence of design parameters on control performance for each algorithm was assessed. The control system was disturbed with load and setpoint changes.     

Basic concept and decentralized autonomous control of super‐distributed energy systems

New small‐scale dispersed generation systems, such as fuel cells and micro gas turbines, have made remarkable advances lately and they will be applied practically in the near future. Although a large number of researches on the introduction of small‐scale dispersed generation systems have been carried out, only a small number of small‐scale dispersed generation systems are considered in these researches. Therefore, little is known about problems to be solved when a large number of small‐scale dispersed generation systems are introduced into electric power systems. This paper deals with a super‐distributed energy system that consists of a great number of dispersed generation systems such as fuel cells, micro gas turbines, and so on. The behavior of a customer with a dispersed generation system is simulated as the Ising model in statistical mechanics. The necessity of a distribution network in super‐distributed energy systems is discussed based on the Ising model. The feasibility of decentralized autonomous control using vicinity information is also investigated on the basis of stability analysis of the Hopfield neural network model. © 2005 Wiley Periodicals, Inc. Electr Eng Jpn, 151(1): 43–55, 2005; Published online in Wiley InterScience ( www.interscience.wiley.com ). DOI 10.1002/eej.10368     

Series resonant ZCS‐PFM DC‐DC power converter with high‐frequency high‐voltage transformer link for high‐power magnetron drive

This paper presents a single lossless inductive snubber‐assisted ZCS‐PFM series resonant DC‐DC power converter with a high‐frequency high‐voltage transformer link for industrial‐use high‐power magnetron drive. The current flowing through the active power switches rises gradually at a turned‐on transient state with the aid of a single lossless snubber inductor, and ZCS turn‐on commutation based on overlapping current can be achieved via the wide range pulse frequency modulation control scheme. The high‐frequency high‐voltage transformer primary side resonant current always becomes continuous operation mode, by electromagnetic loose coupling design of the high‐frequency high‐voltage transformer and the magnetizing inductance of the high‐frequency high‐voltage transformer. As a result, this high‐voltage power converter circuit for the magnetron can achieve a complete zero current soft switching under the condition of broad width gate voltage signals. Furthermore, this high‐voltage DC‐DC power converter circuit can regulate the output power from zero to full over audible frequency range via the two resonant frequency circuit design. Its operating performances are evaluated and discussed on the basis of the power loss analysis simulation and the experimental results from a practical point of view. © 2005 Wiley Periodicals, Inc. Electr Eng Jpn, 153(3): 79–87, 2005; Published online in Wiley InterScience ( www.interscience.wiley.com ). DOI 10.1002/eej.20126     

Optimal Control of Solar Sludge Dryers

Optimal control (OC) methodology is used to develop a control policy for a batch-operated solar sludge dryer with ventilation as the dominant control. Batch performance criteria and instantaneous optimization criteria are developed for two economic environments: quota limited and capital limited. The general formulation, as well as simplifications resulting from the multiplicative form of the evaporation (drying) rate model, are presented. The multiplicative form results in a single constant number, called here “control intensity,” which is used to guide the on-line control decisions. These decisions turn out to be independent of the dry solids content (DSC) of the sludge. Further simplification, by assuming a strictly constant weather, is used to demonstrate the general effects of the economic and physical (weather) environment on the solution.

The OC approach is used to address, via simulation under realistic weather conditions, several design, operation, and pricing problems. In particular, the following have been considered: sizing of the ventilation fans, determination of a fair fee for sludge disposal, finding the best final DSC, and evaluating the effect of the price of electricity. Regarding the particular location represented by the data, it has been shown that the installed capacity of the ventilation fans should be increased and that there seems to be sufficient economic incentive for solar drying.     

SW233 PIN驱动器自动测试系统的研制

介绍了一种集成电路自动测试系统，该系统采用计算机并口作通信接口，用VB6编程，实现了对外围测试电路的控制，用IEEE-488接口卡控制测试仪器，可对SW233电路的36个参数进行自动测试，并将测试结果自动保存在数据库中。该测试系统具有自动化程度高、操作方便、测试结果精确等特点。     

Multiobjective dynamic load-dispatching method for optimal operation of power systems

A new practical method is proposed which gives a quasi-optimal solution of the dynamic load-dispatching problem formulated by a multiconstraint multiobjective optimization problem. Here, the multiple constraints are rate reserve constraints and power flow ones, and the multiple objectives are fuel cost and CO₂ emission. The proposed method is an integration of the following three techniques: (1) “Group Dispatch Scheme,” which is developed by the authors, is used to satisfy a violated constraint easily. This scheme consists of three steps. The first step is to classify all generators into two groups. One is the group which should be more loaded to satisfy the violated constraint, and the other is the should-be less loaded group. The second step is to add some load to the former group, and to subtract the same load from the latter. The third step is to dispatch each group load to each groups generators, respectively; (2) the dynamic load-dispatching algorithm is used which provides, in practical time, quasi-optimal generation trajectories; (3) the conventional weighting parametric method is used to obtain a Pareto optimal solution of multiobjective problems. The effectiveness of the method is clarified by a computer simulation on the actual power system of Kansai Electric Power Company.