世界乙烯工业及其进展

阐述了世界乙烯产能需求现状，近扑扩能增产预测，乙烯原料分析以及乙烯生产的技术进展。     

连轧管机轧辊轴承的调整、维护及保养

本文介绍了应用于MPM连轧机轧辊上的四列圆锥滚子轴承的结构特性及其调整、维护、保养，旨在提高轴承的使用寿命。     

ZPG系列盘式真空过滤机的研制与应用

详细介绍了ZPG系列盘式真空过滤机的主要特点、基本原理和主要技术参数。对盘式真空过滤机的过滤理论进行了系统的研究 ,以及为提高过滤系数和降低滤饼水分所采取的关键措施。与传统的真空过滤机进行了对比 ,表明ZPG系列盘式真空过滤机的滤饼水分可以降低 1 %～ 3 % ,过滤系数提高 3 0 %～5 0 % ,过滤每吨精矿的能耗可以降低 5 0 %左右 ,使得ZPG系列盘式真空过滤机在国内各大冶金矿山得到全面推广使用 ,创造了巨大的经济效益和社会效益。     

Computation of Bearing Capacity Factor Nγ?Terzaghi’s Mechanism

A procedure based on K?tter’s equation is developed for the evaluation of bearing capacity factor Nγ with Terzaghi’s mechanism. Application of K?tter’s equation makes the analysis statically determinate, in which the unique failure surface is identified using force equilibrium conditions. The computed Nγ values are found to be higher than Terzaghi’s value in the range 0.25–20%, with a diverging trend for higher values of angle of soil internal friction. A fairly good agreement is observed with other solutions which are based on finite difference coupled with associated flow rule, limit analysis, and limit equilibrium. Finally, the comparison with available experimental results vis-à-vis other solutions shows that, computed Nγ values are capable of making a reasonably good prediction.     

聚脲基脂及其在电机轴承上的应用

对电机轴承专用聚脲基脂的特点及其在电机轴承上的应用效果进行了分析和探讨。正确使用电机用润滑脂是保证电机正常工作，减少电机故障的关键措施之一。采用电机专用聚脲基脂后，电机轴承工作温度明显下降，电机故障率明显减少。     

Reversible changes of the fill factor in the ZnO/CdS/Cu(In,Ga)Se2 solar cells

The reversible persistent changes of the fill factor (FF) induced by the illumination and voltage bias along with changes in the electronic properties of the ZnO/CdS/Cu(In,Ga)Se₂ photovoltaic devices have been studied. Admittance spectroscopy and capacitance–voltage characterization reveal a correlation between the FF and the space charge distribution within the absorber. Our experiments provide evidence that a major source of FF loss in efficient devices is caused by excess negative charge close to the interface. We explain the persistent changes in the net acceptor concentration in the interface region by the relaxation effects due to compensating donors—the same mechanism, which leads to metastable changes of the doping level in the bulk of the absorber.     

福州洪山大桥支座整体更换施工的方法和措施

本文针对国道316线福州洪山大桥支座整体更换工作中所采用的主要施工方法和措施进行介绍,对类似桥梁的养护工作具有指导意义。     

钻井井架力学性能分析

钻井井架作为钻机系统设备中的关键部分,其力学性能直接关系到整套钻机系统的安全生产。文章推导了常用于分析钻井井架力学性能的理论,即线性屈曲、几何非线性和双重非线性理论。提出同时用这三种理论对钻井井架进行综合比较分析,从而合理地预见井架力学性能的方法。以A形钻井井架为例,进行了详细的分析,得到了井架的失稳形式、极限承载、破坏特征及薄弱部位,为钻井井架的设计、优化与评定提供了参考。     

Flammability ranking of foliage species by factor analysis of physical and chemical pyric properties

In this paper, factor analysis is introduced to evaluate the flammability of 55 foliage species that may be used in China for construction of the fuel break network of forest strips with lower flammability. Six pyric parameters, i.e. air dry moisture content, absolute dry moisture content, ignition point, ash content, caloric value and extractive content, are measured and used as variables for factor analysis. The covariance analysis shows that four principal factors can be extracted to reflect the flammability in different physical and chemical senses. In terms of the contributions of the four factors to the variances and the physical significance of the relevant parameters, the four factors are, respectively, termed as ‘flaming factor,’ ‘air dry factor,’ ‘ash factor’ and ‘absolute dry factor.’ The stability of the factor analysis method is examined by a different number of samples considered, and the variation degrees of the orderings indicate that the method has high reliability to measure the total flammability of foliage species. The results of the flammability evaluation are verified by comparison with the recommended tree species in the Chinese technology standard. Copyright © 2008 John Wiley & Sons, Ltd.     

1270轧机弹性曲线的回归及参数估计

首先介绍了轧机弹性曲线的基础知识及 1 2 70轧机AGC系统的基本结构 ,然后论述了数据采集的方法 ,最后根据最小二乘法得到轧机弹性曲线的回归模型及刚度系数的实验结果。