高质量的一级光栅1．55μmDFB激光器

本文详细叙述了ＤＦＢ激光器的设计要点和新的工艺。采用一级全息光栅和二步液相外延法批量研制出高稳定单纵模工作的１．５５μｍ分布反馈激光器（ＤＦＢ—ＬＤ）。外延片成品率＞４０％。器件特性：２５℃时阈值电流２０ｍＡ，单面光功率＞１０ｍｗ，主边模抑制比ＳＭＳＲ达４３ｄＢ（λ／４相移光栅），谱线宽度△ν－２０ｄＢ＝０．３ｎｍ，调制速率＞１．８ＧＨｚ。可靠性测试显示：高温监测光谱稳定，２５°Ｃ时阈值退化率△Ｉｔｈ／ｔ＜０．３ｍＡ／ｋｈ，对应器件预估寿命将超过１０万ｈ。     

康山金矿地质地球化学特征及其成因

康山金矿产在豫西熊耳山古隆起区的结晶基底太华群和盖层中元古界熊耳群地层接触界面附近，矿体严格受构造破碎蚀变带控制。流体包裹体，稳定同位素等研究表明，成矿物质来自太华群变质岩，成矿流体的性质与变质热液截然不同，而与花岗岩浆热液相近似。该矿床的形成与燕山期发生的同构造－花岗岩浆期热液活动有关，金沉淀成矿阶段有大气水的混入。     

Isolation and preliminary characterization of Pichia pinus mutants insensitive to glucose repression

A new method for the isolation of glucose repression-insensitive mutants in the methylotrophic yeast Pichia pinus was developed. The method is based on screening of small suspension samples derived from 2-deoxyglucose-resistant colonies for alcohol oxidase activity. Alcohol oxidase activity was evaluated by determination of formaldehyde excreted by cells. Mutants with glucose non-repressible alcohol oxidase and catalase synthesis were obtained. All mutants grew poorly on D -xylose compared to the wild type, whereas growth on L -arabinose was similar to the wild type. Changes in the glucose transport system were suggested to be responsible for altered growth characteristics and defective glucose repression.     

Application of SiC-Si functionally gradient material to thermoelectric energy conversion device

Because of its high–temperature chemical stability, SiC ceramic is a promising material for high-temperature device applications such as thermoelectric energy converters. However, the electrical conductivity of SiC ceramic is too low for it to be used as a thermoelectric energy converter at the cold junction. Therefore, we propose a SiC-Si functionally gradient material (FGM) in order to improve the electrical conductivity of the SiC ceramic at the cold junction. An SiC rod was fired in a temperature gradient furnace. One end of the SiC rod was maintained at 2473 K and the other end was maintained at 1973 K for 30 min. After firing, the porous SiC edge fired at 1973 K was dipped into molten Si in order to infiltrate molten Si into the porous SiC. The microstructure of the FGM is classified into three regions: the SiC-Si composite material; the porous SiC ceramic; and the densified SiC ceramic. The electrical conductivity, the Seebeck coefficient and the thermal conductivity for each region of SiC-Si FGM was measured at 300 K; a figure of merit was calculated. The figure of merit of the SiC-Si FGM at the cold junction, at room temperature, was 10⁸ times higher than that of a nongradient SiC ceramic.     

Discrete Modeling and Suggested Measurement of Heat Transfer in Gas-Solids Flows

This article presents a two-dimensional transient model for gas-solids flow and heat transfer through pipes using the coupled Computational Fluid Dynamics and Discrete Element Method approach. Numerical simulations have been conducted to examine the modification of fluid thermal structure due to the presence of particles in a pneumatic transport pipeline. Modeled results have demonstrated the key role of transversal motion of rebounding particles in the pipe cross section in altering fluid temperature. Further implementation of this modeling technique in air-drying processes is discussed and possible experimental methods for the measurement of in situ particle and fluid motion and temperature profile are cited.     

多孔粒状铵油炸药在边坡预裂爆破中的应用

通过工程实践，介绍了利用多孔粒状铵油炸药进行边坡预裂爆破的设计原理及施工工艺。该技术能确保预裂爆破质量。简化施工工序，大幅度降低爆破成本。技术经济指标优越。     

TRVs and fault clearing stresses in extra-high-voltage radial networks

To cope with the high rate of increase of power demand in the main industrialized districts in Japan, 550-kV transmission systems covering the districts have been reinforced, with most of the main power plants connected directly to these systems. Through 550-/300-kV substations, the majority of power to the districts is supplied by 300-kV systems. To limit the excess short-circuit capacity in the 300-kV systems, they tend to be reconstructed as so-called radial networks. In radial networks with high short-circuit capacity and relatively small number of transmission lines connected to the substation busbars, the rate of rise of TRV can be far higher than standard value. This paper analyzes the transient recovery voltages (TRV) in such extra-high-voltage radial networks in Japan, together with the relevant stresses to circuit-breakers during fault clearings. Future system conditions have also been introduced. As the typical rate of rise of the TRV values, more than twice that of today's standard ones are probable.     

Extraction of penicillin G from simulated media by an emulsion liquid membrane process

The extraction of penicillin G from simulated media was performed by water/oil/water (w/o/w) emulsion liquid membranes (ELMs) and studied under various operational conditions in a batch system. The degree of extraction achieved was between 80% and 95% under specific conditions. A concentration of greater than nine times the initial concentration of penicillin G in the external phase was obtained in the internal phase. The pH of the internal aqueous solution, containing a basic salt, was theoretically calculated on the basis of the amount of penicillin G transported into the internal phase. The calculated results agreed with the experimental data well and were used to select a suitable type and concentration of a basic salt in the internal phase to give a pH within the range 5 to 8 where penicillin G was stable after the termination of extraction. The extraction of penicillin G was successfully performed by the ELM process with sodium carbonate in the internal phase.     

Immobilized α-amylase from Bacillus licheniformis: a potential enzymic time—temperature integrator for thermal processing

Biphasic and nth-order models were tested as to their usefulness to fit experimental inactivation data of Bacillus licheniformis α-amylase, immobilized on glass beads, and were discussed with respect to their suitability to characterize the considered enzymic system as a time—temperature integrator (TTI) to evaluate heat processes. Both isothermal and non-isothermal inactivation experiments were carried out. Model (kinetic) parameters (rate constant k, activation energy E_A and reaction order n) were estimated using a non-linear regression procedure. The results obtained, especially the activation energy of about 293 kJ mole^–1, indicated a potential use of this system as a TTI for heating processes in the temperature range of 96–108°C.     

An analytical expression for the power coefficient of an ideal horizontal-axis wind turbine

The paper shows that an analytical evaluation of the power coefficient C_p for an ideal horizontal-axis wind turbine can be made via an expression giving the direct relationship of C_p and the axial induction factor a. The results obtained agree closely with those obtained numerically from the usual integral expression involving several variables.