The effects of glycol methacrylate as a dehydrating agent on the dimensional changes of liver tissue

The dimensional changes of liver sections during the course of processing with glycol methacrylate (GMA) or with ethanol are described. Tissue processing with ethanol served as a control. During prolonged processing steps (24 h each), linear shrinkage of tissue specimens dehydrated with GMA at room temperature was 13.2%. Subsequent infiltration with GMA resulted in trivial swelling, and polymerization in slight shrinkage (2.3%). In comparison, processing with cold GMA resulted in shrinkage during dehydration (about 10.8%), a slight swelling in pure GMA, followed by shrinkage during polymerization (2.2%). Short routine processing schedules resulted in similar shrinkage/swelling patterns, although precise values differed slightly. In all experiments, ethanolic dehydration resulted in smaller dimensional tissue changes than did GMA dehydration. The dimensional changes of tissue sections during stretching on water, mounting and drying compensated for the major part of the shrinkage manifested during processing.     

Possibilities and extension of XRD material response analysis in failure research for the advanced evaluation of the damage level of Hertzian loaded components

Due to clearly distinguishable damage symptoms, it is differentiated between the surface and sub‐surface failure mode of rolling bearings. Material states red out by X‐ray diffraction (XRD) residual stress measurements point to a variety of loading conditions especially at raceway surfaces that are associated with several competing failure mechanisms. The corresponding lifetime reduction can range from the lower fatigue strength region to material ratcheting in extreme cases. Relevant position of the microstructural changes and nature of the failure mechanisms are characterized. The time alteration of the XRD material parameters measured at or near the surface and at the depth of the maximum equivalent stress correlates, in a different manner, with the statistical parameter of the 10 % bearing life. Both failure modes are illustrated by concrete examples. Contaminated lubricant and boundary lubrication, which represent practically important surface‐induced failures, are discussed in more detail. Gray staining, i.e. shallow pitting, often occurs without distinct indication of global material aging by means of XRD characteristics. Here, scanning electron microscopy observations and electron microprobe analyses point to corrosion fatigue as acting surface failure mechanism. The interaction between material and lubricant under complex loading regimes particularly of mixed friction and corrosion opens further failure research areas in the field of tribology.     

Schäden durch kerbinduzierte Schwingbrüche

Failures by notch induced fatigue fractures Notches produce local stress concentrations and promote the formation of fatigue cracks. Characteristic types of notches as a result of design, manufacturing and operation are presented and remedial measures are discussed. Examples demonstrate the effect of different kinds of notches on various components.     

Coupling GIS with Hydrologic and Hydraulic Flood Modelling

Geographic Information Systems (GIS) have been recognised as a powerful means to integrate and analyse data from various sources in the context of comprehensive floodplain management. As part of this comprehensive approach to floodplain management, it is very important to be able to predict the consequences of different scenarios in terms of flooded areas and associated risk. Hydrologic and hydraulic modelling plays a crucial role and there is much to gain in incorporating these modelling capabilities in GIS. This is still a rather complex task and research is being done on the full integration of these models. Interfacing between these models and GIS may be a very efficient way of overcoming the difficulties and getting very good results in terms of engineering practice. This paper presents results based on the use of Intergraph GIS coupled with Idrisi GIS. Using these two systems substantially increased the flexibility of using GIS as a tool for flood studies. A lumped (XSRAIN) and a distributed (OMEGA) hydrologic models were used to simulate flood hydrographs. The well known HEC-2 Hydraulic model was used to compute flooded areas. These models were applied in the Livramento catchment with very good results. The computation of flooded areas for different flood scenarios, and its representation in GIS, can be used in the assessment of affected property and associated damages. This is a very useful GIS-based approach to floodplain management.     

^17O系统的R矩阵分析

采用多道多能级R矩阵理论,全面系统地分析~(17)O系统中10.5 MeV激发能以下有关~(16)O(n,n)~(16)O·~(16)O(n,a)~(13)C和~(13)C(a,a)~(13)C的全部实验数据。有关~(16)O的中子反应截面计算值被收入中国评价数据库CENDL-2和美国的评价数据库ENDF/B-6。对在R矩阵分析中如何确定本底、道半径和边界条件等问题予以讨论。     

在役加氢反应器试验板脆化和氢损伤的测定与研究

充分利用了带主焊缝的役后试板，在国内首次开展回火脆化、氢介质下断裂韧性与疲劳扩展的研究，结果表明，加氢反应器焊缝有明显的脆化表现。同时，核查了反应器开停车升温速度和降温速度规定，以及确定了裂纹允许尺寸的参考数据，为今后安全运行提供了充分的依据。     

钨系延期药预点火反应机理研究

通过程控升温模拟点火条件，根据ＤＳＣ图谱分析，找出主要反应区的温度范围。研究结果表明，钨系延期药预点火反应是一个真正的固－固反应。     

DETERMINATION OF TOTAL NITROGEN IN BARLEY AND MALT BY COMBUSTION METHOD—COLLABORATIVE TRIAL

A combustion method, relying on the Dumas principle, for the determination of total nitrogen in barley and malt, has been collaboratively tested by the Analysis Committee of the European Brewery Convention. Repeatability, r₉₅, and reproducibility, R₉₅, values were 0.063 and 0.116% of dry matter, respectively, for samples with nitrogen contents in the range 1.23 to 1.86% N of dry matter. There was no significant difference between these values for barley and malt. The Analysis Committee approved the adoption of the combustion method for inclusion in Analytica EBC as an alternative method.     

Reconstruction of a discontinuous function from a few fourier coefficients using bayesian estimation

The goal of this paper is the application of spectral methods to the numerical solution of conservation law equations. Spectral methods furnish estimates of the firstn Fourier coefficients of the solution. But since the solutions of conservation law equations can have discontinuities, the estimate of the solution by summing the firstn terms of the Fourier series will haveO(1/n) error, even if the Fourier coefficients are known to high accuracy. But if the solution could be accurately reconstructed from its Fourier coefficients, spectral methods could be used effectively in these problems. A method for doing this is to assume a probability distribution for functions. Functions which are smooth away from the discontinuity are assumed to be likely, and those which are not smooth away from the discontinuity are assumed to be unlikely. Then a reconstruction algorithm is chosen by minimizing the expected error over all algorithms. It is possible to put the smoothness assumptions mentioned earlier into an infinite-dimensional Gaussian probability distribution, and then the minimum-error algorithm is well-known and fairly simple to construct and apply. If the Fourier coefficients of the reconstructed function are known exactly, then this approach gives very good results. But when used with Fourier coefficients obtained from a spectral approximation to Burgers' equation, the results were much less impressive, probably because the coefficients were not known very accurately. It is possible to construct filters that reconstruct a function using Legendre or Chebyshev coefficients for information instead Fourier coefficients. It is found that the performance of these filters is similar to the Fourier case.