有环网络编码关键理论问题研究

同无环网络编码研究相比,有环网络编码的理论存在更多研究空白.在实际网络中,网络编码信息流很可能交错形成环路,造成环路中链路之间逻辑因果关系混乱,时延的引入成为必须.因此,有环网络中网络编码呈现出与无环网络中不一样的特性.由于有环网络编码是网络编码实用化研究的一个关键和难点,而且有环有时延网络更接近实际网络情况,因而有环网络的研究具有较大理论和实用意义.本文从有环网络编码的数学理论框架、有环网络编码容量、码构造算法、多源有环网络编码等几个方面综述了有环网络编码的研究现状和需要进一步研究的方向.     

一种基于循环谱特征识别的频谱感知算法

针对传统循环谱计算复杂度高的问题,提出一种基于循环谱特征识别的频谱感知算法,该算法采用自相关矩阵替代频域平滑方法计算信号的谱特征,在降低算法复杂度的同时,能够准确区分噪声与有用信号,利用软件无线电构建测试平台,用以验证算法的有效性.实验结果表明,该算法能够准确检测出频谱空穴,准确度大于90％,并能降低时间复杂度,可以满...     

Impact of ZnO gate interfacial layer on piezoelectric response of AlGaN/GaN C-HEMT based ring gate capacitor

We report on a piezoelectric response investigation of AlGaN/GaN circular high electron mobility transistor (C-HEMT) based ring gate capacitor as a new stress sensor device to be potentially applied for dynamic high-pressure sensing. A ring gate capacitor of C-HEMT with an additional ZnO gate interfacial layer was used to measure the changes in the piezoelectric charge induced directly by the variation of piezoelectric polarization of both gate piezoelectric layers (AlGaN, ZnO) for harmonic loading at different excitation frequences. Our experimental results show that about 10 nm thick piezoelectric ZnO layer grown on ring gate/AlGaN interface of C-HEMT can yield almost a 60% increase in the piezoelectric detection sensitivity of the device due to its higher piezoelectric coefficient. A three-dimensional CoventorWare simulation is carried out to confirm the increase in the measured piezoelectric response of ZnO based ring gate capacitor of C-HEMT.     

Static pull-in analysis of microcantilevers based on the modified couple stress theory

This paper investigates the deflection and static pull-in voltage of microcantilevers based on the modified couple stress theory, a non-classic continuum theory capable to predict the size effects for structures in micron and sub-micron scales. It is shown that the couple stress theory can remove the gap between the experimental observations and the classical theory based simulations for the static pull-in voltage.     

A label-free amperometric immunosensor based on horseradish peroxidase functionalized carbon nanotubes and bilayer gold nanoparticles

In this work, a novel label-free amperometric immunosensor has been constructed for detecting α-1-fetoprotein (AFP) based on nanocomposite of horseradish peroxidase (HRP) labeled carbon nanotubes (CNTs). First, the gold nanoparticles (AuNPs) were electrodeposited on the surface of the glass carbon electrode by electrochemical reduction of gold chloride tetrahydrate (HAuCl₄) to immobilize horseradish peroxidase labeled carbon nanotubes (HRP-CNTs). Then HRP-CNTs bioconjugate was immobilized on the surface of the electrodeposited AuNPs layer by the combination of forces (coordination and electrostatic force). Subsequently, it was immersed into gold colloidal nanoparticles (GNPs) solution, which was used to immobilize antibody biomolecules (anti-AFP). Enhanced sensitivity was obtained by using bioconjugates featuring HRP labeled (HRP-CNTs), which had lager specific surface area and good electronic catalysis (current response signal) compared to carbon nanotubes. Under optimized conditions, the linear ranges were from 0.2 to 200 ng mL⁻¹ with a detection limit of 0.067 ng mL⁻¹ (at an S/N of 3). The proposed immunosenor showed good precision, acceptable stability and reproducibility and could be used for the detection AFP in normal human serum, which provided a potential alternative tool for the detection of protein in clinical diagnosis.     

Surface plasmon resonance (SPR) sensors for the rapid, sensitive detection of the cellular response to osmotic stress

Cells regulate their volume in response to changes in osmolarity of both, their extracellular and intracellular environments. As stability of the cell volume is a compelling exigency for cellular integrity, techniques for a sensitive, time-resolved volume measurement of adherently grown mammalian cells attract considerable interest, especially in the field of cell physiology and biology. In this study we apply a surface plasmon resonance (SPR) based biosensor for the comparative analysis of the volume responses of two renal epithelial cell types to non-isotonic challenges. The on-line, label-free and non-invasive biosensor format shows distinct similarities and differences in the reaction kinetics of the two cell types. Furthermore regulatory volume responses to the osmotic stimuli as well as their inhibition by Gd³⁺ ions can be observed with a high time-resolution. Limit-of-detection measurements indicate the high sensitivity of the sensor capable of detecting cellular volume responses of adherently grown mammalian cells to osmotic stimuli well below a bioanalytical relevant value of 5 mOsm/kg.     

钢材料电磁应力传感器技术研究

现代结构普遍大量使用铁磁性钢材料作为承载构件,其受力状态直接关系到结构整体的安全性。由于应力对钢材料磁特征参量的影响比较显著,故在分析了基本原理的前提下,设计了一种管筒式电磁应力传感器。采用有限元仿真技术FLUX软件检验磁路设计的合理性,并提出了实验与仿真相结合的方法对传感器输出电压进行标定。通过实验与仿真计算结果对比,验证了该种方法的正确性,为该种应力检测传感器提供了一种高效的标定方法,使其更加具有市场价值。     

Utility of an image-based canopy reflectance modeling tool for remote estimation of LAI and leaf chlorophyll content at the field scale

This paper presents a physically-based approach for estimating critical variables describing land surface vegetation canopies, relying on remotely sensed data that can be acquired from operational satellite sensors. The REGularized canopy reFLECtance (REGFLEC) modeling tool couples leaf optics (PROSPECT), canopy reflectance (ACRM), and atmospheric radiative transfer (6SV1) model components, facilitating the direct use of at-sensor radiances in green, red and near-infrared wavelengths for the inverse retrieval of leaf chlorophyll content (C_ab) and total one-sided leaf area per unit ground area (LAI). The inversion of the canopy reflectance model is constrained by assuming limited variability of leaf structure, vegetation clumping, and leaf inclination angle within a given crop field and by exploiting the added radiometric information content of pixels belonging to the same field. A look-up-table with a suite of pre-computed spectral reflectance relationships, each a function of canopy characteristics, soil background effects and external conditions, is accessed for fast pixel-wise biophysical parameter retrievals. Using 1 m resolution aircraft and 10 m resolution SPOT-5 imagery, REGFLEC effectuated robust biophysical parameter retrievals for a corn field characterized by a wide range in leaf chlorophyll levels and intermixed green and senescent leaf material. Validation against in-situ observations yielded relative root-mean-square deviations (RMSD) on the order of 10% for the 1 m resolution LAI (RMSD = 0.25) and C_ab (RMSD = 4.4 μg cm^− 2) estimates, due in part to an efficient correction for background influences. LAI and C_ab retrieval accuracies at the SPOT 10 m resolution were characterized by relative RMSDs of 13% (0.3) and 17% (7.1 μg cm^− 2), respectively, and the overall intra-field pattern in LAI and C_ab was well established at this resolution. The developed method has utility in agricultural fields characterized by widely varying distributions of model variables and holds promise as a valuable operational tool for precision crop management. Work is currently in progress to extend REGFLEC to regional scales.     

Influence of the measurement conditions on the sensitivity of SnO2 gas sensors operated thermo-cyclically

The conductance of several tin oxide gas sensitive layers was simultaneously measured in thermo-cyclic and isothermal operation mode at various concentrations of CO and propene in air, respectively. Different measurement conditions were set by the cycle time, the gas flow rate, the humidity and the thickness of the sensitive layer. The sensor response is expressed by the conductance-over-time profiles (CTPs), the gas sensitivity or by the sum of the CTP sampling points. The resultant sensitivities from the CTPs were found to be higher than those of the isothermal measurements. The CTPs considerably change with the kind of gas as well as with the variation of the measurement conditions. This is discussed for both types of target gases with respect to the temperature, the adsorbates assumed and the reaction kinetics in relation to the gas transport conditions in the porous gas sensitive layer.