Application of a Compaction Simulator to the Design of a High-Dose Tablet Formulation. Part I

The compaction properties of an investigational drug are studied by the use of a compaction simulator. The effects of punch velocity over the range of 30-640 mm^-1 on the compaction properties of the pure drug and a variety of formulas incorporating a high dose of the active compound have been investigated. The data were analyzed by applying the Heckel equation. The pure drug was found to have a high yield pressure at a relatively low punch velocity of 31 mm^-1. As the punch velocity was increased there was a decrease in crushing strength, primarily as a result of increasing yield pressure. These findings indicate that the pure drug predominantly consolidated by fragmentation and elastic deformation, with a slow plastically deforming component. The information obtained on the consolidation mechanism of the pure drug and, subsequently, on model formulas were instrumental in the design and selection of a robust formula and granulation process. The advantages of conducting dosage form design and characterization studies during the early phase of tablet formulation using means such as a compaction simulator are emphasized in this investigation.     

Isolation and preliminary characterization of Pichia pinus mutants insensitive to glucose repression

A new method for the isolation of glucose repression-insensitive mutants in the methylotrophic yeast Pichia pinus was developed. The method is based on screening of small suspension samples derived from 2-deoxyglucose-resistant colonies for alcohol oxidase activity. Alcohol oxidase activity was evaluated by determination of formaldehyde excreted by cells. Mutants with glucose non-repressible alcohol oxidase and catalase synthesis were obtained. All mutants grew poorly on D -xylose compared to the wild type, whereas growth on L -arabinose was similar to the wild type. Changes in the glucose transport system were suggested to be responsible for altered growth characteristics and defective glucose repression.     

对我国酱油酿造几项新技术应用之浅见

本文概述了三十年来我国酿造酱油工业开展研究的六项新技术在现阶段的投产可行性，及进一步研究方向的看法。     

多孔粒状铵油炸药在边坡预裂爆破中的应用

通过工程实践，介绍了利用多孔粒状铵油炸药进行边坡预裂爆破的设计原理及施工工艺。该技术能确保预裂爆破质量。简化施工工序，大幅度降低爆破成本。技术经济指标优越。     

Extraction of penicillin G from simulated media by an emulsion liquid membrane process

The extraction of penicillin G from simulated media was performed by water/oil/water (w/o/w) emulsion liquid membranes (ELMs) and studied under various operational conditions in a batch system. The degree of extraction achieved was between 80% and 95% under specific conditions. A concentration of greater than nine times the initial concentration of penicillin G in the external phase was obtained in the internal phase. The pH of the internal aqueous solution, containing a basic salt, was theoretically calculated on the basis of the amount of penicillin G transported into the internal phase. The calculated results agreed with the experimental data well and were used to select a suitable type and concentration of a basic salt in the internal phase to give a pH within the range 5 to 8 where penicillin G was stable after the termination of extraction. The extraction of penicillin G was successfully performed by the ELM process with sodium carbonate in the internal phase.     

Ti-silicalite as catalyst for gas-phase ammoximation of cyclohexanone with molecular oxygen

The catalyst behaviour of titanium silicalite, which was found the most active and selective catalyst for liquid-phase ammoximation of cyclohexanone to the corresponding oxime with hydrogen peroxide, was investigated in the gas-phase ammoximation with molecular oxygen in and compared with those of pure silicalite and samples of vanadium and chromium silicalites. The results showed that Ti-silicalite is a selective catalyst not only in the reaction with hydrogen peroxide but also in the reaction with molecular oxygen. However, a big limitation was found in the poor activity of the silicalites which do not allow to reach high oxime yields.     

Sicherer und wirtschaftlicher Betrieb von Kraftwerken – Ergebnis der Forschung im Bereich Werkstoffe,Auslegung und Instandhaltung

Safe and Economic Operation of Power Plants – Research Results in the Field of Materials, Design and Maintenance Components of power plants which undergo high temperatures are subjected to complex loading situations. The requirements on the used materials result from the special operation conditions of the plants and have to be adjusted to the steadily growing requirements on higher efficiency of the complete power plant as well as to those of safe and economic operation. The expenses for control and downtimes are directly connected with economic efficiency and availability. However, in case of new procedures or components it is not possible to revert to the existing know‐how. Different failure mechanisms than known before can occur. The same goes for the load situation. Therefore the knowledge base has to be extended to in‐advance or even parallely running scientific examinations that life assessment and maintenance strategies can be applied which guarantee the operational reliability and the efficiency of the plant. The main emphasis of these F&E works has to be put on condition monitoring based on actual operational data, the standard materials’ and component’s behaviour (deformation, damage and failure behaviour) in connection with design of components and the related material laws. In the framework of applied AVIF projects, following problems are handled:. – qualification of materials by determinating parameters related to practise. – optimal design of components by making available material laws and numerical tools. – economic manufacturing of components by qualifying processing methods such as welding. – The results can be transferred to concepts for safe and economic operation of power plants, especially for newly introduced materials for which there is no operational experience available.     

马鞍山煤矿瓦斯地质理论在防突工作中的应用

总结了实际工作中防突管理的经验和问题 ,探讨了科学理论与具体实际的有机结合与统一 ,采取针对性强的有效措施 ,确保突出矿井的安全生产     

All updateable objects in working memory are updated whenever any of them are modified: Evidence from the memory updating paradigm.

In a series of experiments, participants were required to keep track of 1 or 2 working memory (WM) objects, having to update their values in 80% of the trials. Updating cost, defined as the difference between update and non-update trials, was larger when 2 objects were involved compared with when there was only 1 object was involved. This finding was interpreted as evidence that the updating process encompasses both objects in WM, even though only 1 of them is actually updated. This feature of WM updating is limited to objects defined as "updateable," throughout the trial sequence. The results are explained by the need to reprogram the phonological loop when updating or the need for desynchronization followed by resynchronization of WM contents. (PsycINFO Database Record (c) 2010 APA, all rights reserved)     

回顾与展望──庆祝建院40周年

介绍了我院资源开发工程系的历史、现状和前景，指出了面临的问题及摆脱困境的途径。