Heat transfer of a row of three butane/air flame jets impinging on a flat plate

Experiments were performed to investigate the heat transfer characteristics of a row of three premixed, laminar, butane/air flame jets impinging on a water-cooled flat plate. The between-jet interference was found to reduce the heat transfer rate in the jet-to-jet interacting zone due to the depressed combustion. The interference became stronger when the jet-to-jet spacing and/or the nozzle-to-plate distance were/was small. The positive pressure existed in the between-jet interacting zone caused the asymmetric flame and heat transfer distribution of the side jet. The meeting point of the spreading wall jets of the central and the side jets did not occur at the midpoint of the neighboring jets, but at a location shifted slightly outwards. The maximum local heat flux and the maximum area-averaged heat flux occurred at a moderate nozzle-to-plate distance of 5d with a moderate jet-to-jet spacing of 5d. The lowest area-averaged heat flux was produced when both the jet-to-jet spacing and the nozzle-to-plate distance were small. Comparing with a single jet under the same experimental conditions, the heat transfer rates in both the stagnation point and the maximum heat transfer point were shown to be enhanced in a row of three-jet-impingement system. The present study provided detailed information on the heat transfer characteristics of a row of three in-line impinging flame jets, which had rarely been reported in previous study.     

Model for Nanoscopic Domain Formation in Dipalmitoyl-PC/Dilauroyl-PC/Cholesterol Mixture

We describe the lyotropic liquid crystalline phase transitions in the lipid mixture dipalmitoil-PC/dilauroy-PC/cholesterol by 3D spin-1 lattice model. The formation of nanoscale domains with the characteristic size about 300 nm was studied in experiments on confocal fluorescence microscopy (CFM) (G. V. Feigenson and J. T. Buboltz, Biophys. J. 80, 2775 (2001)). The structure parameters of the lamellar vesicle in dipalmitoil-PC-rich phase, corresponding to these regions, are verified by numerical Monte Carlo simulations on the lattice. We point its superconductivity analogy properties at the region of phase stability for composition-dependent nanoscopic region.     

Control of Wind-Induced Self-Excited Oscillations by Transfer of Internal Energy to Higher Modes of Vibration. II: Application to Taut Cables

In Part I of this paper, a theoretical basis is presented using a two-degrees-of-freedom model. In this second part of the study, the passive control and the two types of semiactive controls introduced in Part I are examined numerically for a taut cable experiencing wind-induced galloping motion. The passive and the semiactive control schemes for taut cables show a good similarity with the results obtained for the two-degrees-of-freedom model. The potential of using these control schemes in practical applications to flexible structures is demonstrated.     

S1240一次呼叫转移命令不成功故障的排除

对S1240交换机一次呼叫转移命令不成功故障排除的过程进行了分析。     

甲基丙烯酸三氟乙酰氧乙酯的聚合

对甲基丙烯酸三氟乙酰氧乙酯(TFAOEMA)的阴离子聚合及原予转移自由基聚合进行了研究。常用的阴离于引发剂如丁基锂、1，1-二苯基已基锂等很难引发TFAOEMA的阴离子聚合，而碱性较弱的引发剂如三乙基铝却容易引发，且产率较高。以氯化亚铜、五甲基二乙基三胺、溴代丙酸乙酯为引发体系的TFAOEMA的本体原子转移自由基聚合符合活性聚合特征。但在四氢呋喃为溶剂的原子转移自由基聚合中却存在活性中心失活现象。以末端含卤素的聚甲基丙烯酸甲酯为大分子引发剂，引发TFAOEMA的原子转移自由基聚合，得到了含氟双嵌段聚合物。     

Influence of the Transport Properties of the Crystal/Heat Transfer Surface Interfacial on Fouling Behavior

One method to reduce fouling is to extend the induction time by a defined modification of the interfacial interactions between the heat transfer surface and the crystalline deposit. Since these interactions are a result of both molecular and mechanical forces, two approaches for fouling mitigation have been developed: (a) Modification of the energy related properties of the heat transfer surface and (b) Modification of the geometry related properties of the heat transfer surface.     

利用Excel表格进行供暖系统计算

利用Excel表格进行供暖工程设计计算，可以减少工作量，提高工作效率。介绍了房间热负荷和供暖管道水力计算方法。     

Bedload Transport in Alluvial Channels

Hydraulic, sediment, land-use, and rock-erosivity data of 22 alluvial streams were used to evaluate conditions of bedload transport and the performance of selected bedload-transport equations. Transport categories of transport-limited (TL), partially transport-limited (PTL), and supply-limited (SL) were identified by a semiquantitative approach that considers hydraulic constraints on sediment movement and the processes that control sediment availability at the basin scale. Equations by Parker et al. in 1982, Schoklitsch in 1962, and Meyer-Peter and Muller in 1948 adequately predicted sediment transport in channels with TL condition, whereas the equations of Bagnold in 1980, and Schoklitsch, in 1962, performed well for PTL and SL conditions. Overall, the equation of Schoklitsch predicted well the measured bedload data for eight of 22 streams, and the Bagnold equation predicted the measured data in seven streams.