西气东输管道工程《管道对接环焊缝全自动超声波检测》标准及与国外先进标准的对比

介绍了西气东输管道工程《管道对接环焊缝全自动超声波检测》标准的技术特点、主要内容,并对本标准与国外先进标准、国外先进企业标准进行了较详细的对比分析。本标准在检测工艺方面与ASTM E1961-98相近。验收部分是从缺欠的位置、缺欠自身高度和长度来加以限制,较为合理,具有科学性,与EN25817-92和ISO5817-92标准相当,比API1104-99标准偏严,与西气东输工程射线检测企业标准也基本相当。     

X60管线钢疲劳特性的研究

利用2、4和14mm的X60钢紧凑拉伸试样进行同样应力水平、固定应力比（R＝0．1）的疲劳裂纹扩展试验，揭示出高韧性管道钢的疲劳裂纹扩展存在显著的厚度效应。由于应力水平低，相应的离面应力也低，不足以导致分层开裂，因此，裂纹端部的三维应力约束随厚度增加而增大。4mm试样的疲劳裂纹速率远高于2mm试样，但厚度再增大，裂纹扩展速率不再有显著变化。进一步对表面裂纹试样进行疲劳裂纹扩展试验，并用勾线法纪录裂纹扩展情况，利用穿透裂纹的da/dN-ΔK曲线预测表面裂纹扩展，用2mm厚试样的数据控制裂纹表面长度的扩展，用14mm厚试样的数据控制裂纹底部沿厚度方面的扩展，得到了与表面裂纹扩展实验吻合很好的预测结果。     

输油管线防垢防腐及新药剂试验

讨论影响输油管线结垢和腐蚀的主要因素，从理论上分析了结垢形成，推导计算结垢量的公式。介绍了输油管线防止硫酸钡垢的清防方法。     

恒定水深拖拉铺管管线的三维大挠度静态应力分析

海洋管线具有复杂的工程结构,在恶劣的海洋环境中,承受着比陆地管线更为复杂的载荷。为了保证管线安全工作,需对其进行准确的应力分析。本文应用有限元法对恒定水深拖拉铺管的管线内力、应力及位移进行了计算,并将结果与已有的计算结果进行对比,进一步分析了各种海洋环境因素对管线弯曲效应的影响,取得了有一定实用性的成果,可供海洋拖拉铺管施工时参考。     

Heat Transfer Analysis for Gas-to-Liquids Transportation Through Trans Alaska Pipeline

Gas-to-liquids (GTL) technology involves the conversion of natural gas to liquid hydrocarbons. In this article, theoretical studies have been presented to determine the feasibility of transporting GTL products through the Trans-Alaska Pipeline System (TAPS). To successfully transport GTL through TAPS, heat loss along the route must be carefully determined. This study presents heat transfer and fluid dynamic calculations to evaluate this feasibility. Because of heat loss, the fluid temperature decreases in the direction of flow and this affects the fluid properties, which in turn influence convection coefficient and pumping power requirements. The temperature and heat loss distribution along the pipeline at different locations have been calculated. Fairly good agreement with measured oil temperatures is observed. The powers required to pump crude oil and GTL individually, against various losses have been calculated. Two GTL transportation modes have been considered; one as a pure stream of GTL and the second as a commingled mixture with crude oil. These results show that the pumping power and heat loss for GTL are less than that of the crude oil for the same volumetric flow rate. Therefore, GTL can be transported through TAPS using existing equipment at pump stations.     

长距离温泉输水管道设计

福州市首次把城市外围的温泉水引入市区,本文简要介绍长距离温泉输水管道设计中一些做法。     

天然气管网输配气量优化研究

天然气管网系统管理部门为了明确天然气管网的输气能力和提高天然气管网的利用率，需要对天然气管网系统的输配气量进行优化。为此，以天然气管网系统的最大流量为目标函数，同时考虑了管道强度、节点压力和流量限制等约束条件，建立了天然气管网输配气量优化的数学模型。在研究遗传算法和模拟退火算法的基础上，提出了一种由二者结合构成的具有全域搜索、快速收敛和鲁棒性强等特点的混合遗传算法。结合实例，采用这一新算法求解了天然气管网输配气量优化的数学模型。实例优化结果表明，所建立的数学模型和采用的混合遗传算法是可行和有效的，能够对天然气管网系统输配气量的调度运行起到指导作用。     

32位MIPS微处理器中乘法器的设计和实现

在Booth算法的基础上,结合MIPS 4KC微处理器中的流水线结构和乘法器的工作过程,提出了一种改进的Booth乘法器的设计方法,并采用全制定方法实现,用这种方法实现的乘法器单元具有面积小、单元电路可重复性好、版图设计工作量小、功耗低等特点.     

Connecting the second exhaust-heat boiler to the operating first one under the conditions of flow circuits of combined-cycle plants with two gas-turbine units and one steam turbine

Problems arising with connecting the second exhaust-heat boiler to the first exhaust-heat boiler under load in the case of flow circuits of combined-cycle plants of type PGU-450 are considered. Similar problems exist for two-boiler single-turbine units of type PGU-325 and for two-boiler single-turbine units of traditional steampower plants with an output of 200–300 MW upon connection of the second furnace of a two-furnace boiler to the operating first furnace. Analysis of the temperature-induced stressed state and of the cyclic strength of thick-walled elements of the steam-water conduit of PGU-450 and of two-furnace boilers of two-boiler single-turbine units with an output of 200–300 MW (the check valve, the inlet header of the water economizer) is used for determining the steam temperature differences in the high-pressure conduits to the steam turbine and the order of connection of the second exhaust-heat boiler to the operating fist one. Modes of enabling a two-boiler single-turbine unit of a combined-cycle plant, which are most “rigid” from the standpoint of thermal strength, are determined. __________ Translated from élektricheskie Stantsii, No. 2, February 2006, pp. 11–17.     

输气管道天然气连续取样器的研制及应用

文章针对国内管输天然气气质分析工作中取样环节所存在的问题，结合国外技术发展趋势，全面地介绍了输气管道天然气连续取样器的研制过程。实践证明，该装置较好地解决了天然气密度值偏差问题，满足管输天然气全分析的要求，同时，该装置的推广应用将会提高天然气的计量准确度。