凝析气井井筒动态预测方法

利用垂直管流公式,结合流体相平衡热力学闪蒸计算,运用状态方程模拟,给出凝析气井井筒动态预测新方法.根据该方法.结合油藏数值模拟计算的结果,可准确地预测不同生产时期凝析气井的井筒动态.     

热致液晶性纤维素衍生物及其热塑性塑料复合物熔体流变行为的研究

用毛细管流变仪研究了乙基纤维素（ＥＣ）及其高密度聚乙烯（ＨＤＰＥ）复合物，纤维素芳族酯（ＣＡＥ）及其聚碳酸酯（ＰＣ）复合物的剪切流变特性和机理。结果表明，ＥＣ对ＨＤＰＥ／ＥＣ复合物的粘度影响不大，而少量（５％）ＣＡＥ的加入使ＰＣ／ＣＡＥ复合物粘度大大下降，且复合物流变曲线呈现新的特征。     

Distinguished Scientific Awards for an Early Career Contribution to Psychology.

The Early Career Awards recognize the large number of excellent young psychologists. Recipients of this award may not have held a PhD for more than nine years. The areas considered in 1991 were animal learning and behavior, developmental, and personality. The winners for 1991 were Kent C. Berridge, Susan A. Gelman, and Randy J. Larsen. For each winner a citation, biography, and selected bibliography of their works are presented. (PsycINFO Database Record (c) 2010 APA, all rights reserved)     

碳纤维表面处理对铝电解用硼化钛阴极涂层性能的影响

硼化钛阴极涂层是铝电解用可润湿性阴极材料中的一种，具有优良的抗钠渗透性和对铝液润湿性，可以有效地延长铝电解槽寿命。碳纤维是硼化钛涂层材料的增强剂之一．对硼化钛阴极涂层的性能影响很大。本文研究了不同工艺的液相碳纤维表面氧化处理法对硼化钛阴极涂层抗拉强度和粘接强度的影响。采用PTIR检测碳纤维处理后表面含氧基团的变化，寻找影响硼化钛阴极涂层性能的原因，从而达到最有效地提高TiB2阴极涂层抗拉强度和粘接强度的目的。结果表明，采用工艺(1)(10％HNO3，80℃、恒温5min．超声波、5min)对碳纤维进行表面处理最合理，处理后碳纤维表面含氧基团的含量最高．用其制备硼化钛阴极涂层的抗拉强度、粘接强度最大。     

航空齿轮表面硬化层断裂性能研究

按照航空齿轮的具体工艺过程，对材料12Cr2Ni4A的拉伸试样和断裂试样进行设计和加工，通过三点弯曲实验，重点研究了齿轮材料硬化层的硬度分布，硬化试样拉伸力学性能参数和断裂性能参数，实验结果表明，所采用试样的加工工艺方案是可行的，所获得的Kc基本反映我国航空硬化齿轮材料的断裂性能特征，为定量预测航空硬化齿轮疲劳寿命提供实验和理论分析的依据。     

Experimental evaluation of the strength distribution of E-glass fibres at high strain rates

A bimodal Weibull distribution function was applied to analyse the strength distribution of glass fibre bundles under tensile impact. The simulation was performed using a one-dimensional damage constitutive model. The results show that there were two concurrent flaw populations in the fracture process. The regression analysis using the bimodal Weibull distribution function was in good agreement with experiment.     

Relative Contributions of the Male and the Female to Sexual Behavior and Reproductive Success in the Japanese Quail (Coturnix japonica).

Two contrasting investigative techniques provided evidence consistent with the interpretation that female quail (Coturnix japonica) regulate male copulatory behavior by the duration of their immobility and through this behavioral mechanism they also control the rate of fertilization of their eggs. In Experiment 1, copulation tests with males and females from different genetic lines showed that the type of female that participated in a copulatory test significantly influenced the latency of the male's grab, mount, and cloacal contact responses and also determined the efficiency of the male's copulatory behavior. These measures of male performance were correlated with female immobility in Experiment 2, which used a more homogeneous population of quail. Furthermore, 2 of these measures (copulatory efficiency and the latency to make cloacal contact) were correlated with fertilization rate. (PsycINFO Database Record (c) 2010 APA, all rights reserved)     

降凝剂对高蜡稠油的改性效果及机理研究

实验研究了工业品原油降凝剂WHP改善含蜡56.9%、其中96.6%为正构烷烃的胜利郑王庄稠油流动性的效果。WHP含乙烯/醋酸乙烯/乙烯醇嵌段聚醚三元共聚物30%-35%。在60℃将WHP加入稠油中,测定其凝点和32℃、0-42.6 s^-1范围5个剪切速率下的黏度,均随WHP加量的增加（50-300 mg/L）而降低,200 mg/L为最佳加量,在该加量下0.32 s^-1黏度由34.16 Pa·s降至79.2 mPa·s,凝点（℃）、屈服值（Pa）、稠度系数（Pa·s^n）分别由49.0、32.42、31.57降至39.5、0.1297、0.02142,流型指数由0.1176升至0.9790。由黏温曲线求出,加入200mg/L WHP使该稠油析蜡点由65℃降至58℃,反常点由70℃降至50℃。根据空白和加剂原油扫描电镜照片显示的蜡晶形态,利用共晶机理分析讨论了WHP这种高分子表面活性剂的降凝、降黏、改善流动性的作用。图3表3参5。     

Mycological and physical parameters for selecting suitable packaging material for pre- and post-irradiation storage of cereal grains in Ghana

Owing to the rough warehouse handling of storage sacks in tropical areas in Africa, a suitable storage sack should not support de novo growth of fungal spores because this would reduce the tensile strength of the packaging material and act as a springboard for infecting grain contents. This paper reports the effect of activity of saprophytic fungi on the tensile strength of jute and woven polypropylene sacks. New woven polypropylene sacks carried lower levels of fungal spores (1.3×10¹ cfu/72 cm²) than jute sacks (3.0×10³ cfu/72 cm²). The natural mould penetration and growth was examined on sections (4×5 cm) of both jute and woven polypropylene after previous incubation at relative humidities of 55, 60, 65, 70, 75, 80, 90 and 95% for 10 weeks by placing them on Sabouraud's Agar. There was a significant difference (P = 0.05 level of significance) between the higher penetration of mould growth on jute sacks and that obtained on woven polypropylene sacks. Saprophytic fungi (Aspergillus candidus, A. flavus, A. fumigatus, A. niger, A. japonicus, A. parasiticus, A. ustus, Fusarium oxysporium, F. moniliforme, Penicillium verucosum var. cyclopium, Rhizopus oryzae and Trichoderma viride) isolated from jute sacks reduced tensile strength, measured by an Instron Model 1026, by 50–75% after 10 weeks at 90% R.H. Same fungal species on woven polypropylene sacks did not alter the tensile strength. Woven polypropylene sacks did not absorb moisture whilst the moisture content of jute sacks increased by 5.3–6.0% in 10 weeks at 90% R.H. with concomitant increase in mould and yeast counts by 1–2 log cycles. Evidence is presented to show that there was a positive correlation between the final mycoflora on jute sacks and loss in tensile strength. No correlation, however, was found between the total aerobic bacteria on jute sacks and the concomitant reduction in tensile strength. Fungi therefore play a major role in the reduction of tensile strength of jute sacks. Sterilization by gamma irradiation (8.0 kGy) of jute and woven polypropylene sacks did not affect their intrinsic tensile strength. Woven polypropylene sacks therefore have many microbiological and physical advantages over the traditional jute sacks to merit their use for grain storage in tropical areas like Ghana.