可控震源重锤-活塞杆动态行为规律与扰动控制研究

针对工程应用中可控震源振动器扰动量大、信噪比低等问题,结合重锤运动轨迹检测试验,通过理论计算与数值模拟,开展了重锤-活塞杆动态行为规律研究;在此基础上,开展振动器扰动控制研究,提出竖直进油方式振动器,与横向进油时的结果开展对比仿真分析,并进行竖直进油振动器扰动试验验证。结果表明:横向进油方式下,重锤受绕z轴的转动力矩作用且活塞杆存在变形,导致重锤上某点的运动轨迹为空间曲线,增大了振动器的扰动量,因此,横向进油方式是导致振动器扰动大的直接原因;竖直进油方式下,重锤不再受转动力矩影响且活塞杆变形得到极大改善,有效降低了振动器扰动量。研究结果对改善输出信号品质、提高输出信号分辨率具有重要的工程意义,建议在振动器的设计中采用竖直进油方式。     

轻音乐对驾驶疲劳的双向影响

目的本实验探索驾驶负荷累积与轻音乐对驾驶疲劳的影响。方法采用2(驾驶负荷累积)×2(音乐条件)×3(模拟驾驶阶段)混合设计,对32名驾驶员被试进行模拟驾驶实验,采集驾驶员驾驶速度和他们的垂直搜索广度与瞳孔直径。结果第45-60 min时,对于无驾驶负荷累积的被试,轻音乐组车速显著快于无音乐组,轻音乐组垂直搜索广度显著大于无音乐组;对于有驾驶负荷累积的被试,轻音乐组的瞳孔直径小于无音乐组(边缘显著),轻音乐组的车速慢于无音乐组。结论轻音乐对无累积疲劳的驾驶员具有唤醒作用,加快他们的车速,扩大垂直搜索广度,对驾驶绩效具有积极的影响;轻音乐对有累积疲劳的驾驶员会产生催眠作用,缩小瞳孔直径,车速减慢,对驾驶绩效具有消极的影响。     

室温核辐射探测材料PbI2晶体生长及退火改性研究

以多晶碘化铅(PbI_2)为原料,采用垂直布里奇曼法进行单晶生长,研究了PbI_2单晶的生长特性,随后对单晶进行真空退火和气氛退火,并测试了生长态、真空退火态以及气氛退火态3种不同状态下晶体的光致发光谱(PL)、I-V特性以及红外透过率。研究表明,在碘蒸汽中气氛退火后的碘化铅单晶质量较高,PL谱中激子(EX)峰的半峰宽有所下降,红外透过率从生长态的10%提升至30%左右,电阻率从生长态的3.3×10~9Ω·cm提高至5.6×10~9Ω·cm,可以有效提高晶体的探测效率。气氛退火有利于提高碘化铅的单晶质量,使其各项性能更加适用于室温核辐射探测器。     

Erosion coupled dynamic mesh analysis for location of maximum erosion in 90-degree bends for gas-solid flows

The progressive change in the surface geometry of the component due to erosive wear affects the correct estimation of erosive wear performance and service life of the components handling particulate flows. The current study focuses on determining the change in the location of higher erosion on the bend surface during the pneumatic conveying of solids with continuous geometric modification due to erosive wear. Computational fluid dynamics (CFD) based erosion-coupled dynamic mesh methodology is adopted to simulate the time-dependent surface modification of the 90° bend geometry due to erosive wear. Available experimental data are used to validate the numerical results. Further, the erosion distribution and the location of the maximum erosion for different flow velocities, particle sizes, and bend radius ratios with the increase in solid throughput are investigated. It has been found that the modification in the bend geometry due to erosion influences the location of the maximum erosion. The increase in thickness loss due to erosion increases the variation in the location of the maximum erosion. Furthermore, an equation for predicting the location of maximum erosion of bend geometry is obtained based on the bend radius ratio and the thickness loss.     

基于SS序列集成电路不规则模块布图算法

针对Single-Sequence的集成电路布图,在SS编解码应用对芯片中各单元的摆放进行优化,从而达到芯片面积利用率最大化.重点介绍了利用SS序列解决不规则模块摆放问题,使得SS布图功能更灵活多变.     

基于CCD的垂线坐标仪的设计

针对矿井井壁变形引起的径向位移测量问题,提出了一种基于CCD的垂线坐标仪的设计方案,给出了垂线坐标仪的结构及其在井壁变形监测系统中的布置,详细介绍了垂线坐标仪的软、硬件设计。该垂线坐标仪利用CCD采集光信号并将其转换为视频信号,采用LPC932对采集的视频信号进行二值化处理及计数,并将处理结果发送至地面计算机进行分析,从而得到矿井井壁变形引起的径向位移量。测试结果验证了该垂线坐标仪的稳定性和精确性。     

System supports for protocol and application adaptation in vertical handoffs

In overlay networks, the network characteristics before and after a vertical handoff would be drastically different. Consequently, in this paper, we propose an end‐to‐end based scheme to support protocol and application adaptation in vertical handoffs. First, we proposed a Vertical‐handoff Aware TCP, called VA‐TCP. VA‐TCP can identify the packet losses caused by vertical handoffs. If segments losses are due to vertical handoffs, VA‐TCP only retransmits the missing segments but does not invoke the congestion control procedure. Moreover, VA‐TCP dynamically estimates the bandwidth and round‐trip time in a new network. Based on the estimated bandwidth and round‐trip time, VA‐TCP adjusts its parameters to respond to the new network environment. Second, during a vertical handoff, applications also need to be adapted accordingly. Therefore, we design a programming interface that allows applications to be notified upon and adapt to changing network environments. To support our interface, we utilize the signal mechanism to achieve kernel‐to‐user notification. Nevertheless, signals cannot carry information. Thus, we implement the shared memory mechanism between applications and the kernel to facilitate parameters exchange. Finally, we also provide a handoff‐aware CPU scheduler so that tasks that are interested in the vertical‐handoff event are given preference over other processes to attain a prompt response for new network conditions. We have implemented a prototype system on the Linux kernel 2.6. From the experimental results, our proposed protocol and application adaptation mechanisms are shown to effectively improve the performance of TCP and applications during vertical handoffs. Copyright © 2008 John Wiley & Sons, Ltd.     

蒙古国都日根水电站鱼道建设的启示

通过对国内外鱼道发展现状和趋势的分析,对几种常用鱼道的优缺点做了比较,结合都日根水电站所在秦诺哈拉依赫河鱼类生长繁殖特点,采用了垂直竖缝式加小底孔相结合形式的鱼道设计。实践证明此鱼道设计有效保护了鱼类及河流生态的预期作用,具有一定的科学性、实用性和可推广性,对我国中小河道枢纽建设具有一定的参考价值。     

基于Heritrix与Lucene的垂直搜索引擎研究

垂直搜索是针对某一个行业的专业搜索引擎,是搜索引擎的细分和延伸,是对网页库中的某类专门的信息进行一次整合,定向分字段抽取出需要的数据进行处理后再以某种形式返回给用户。该文结合使用Heritrix与Lucene对学校新闻网站网页进行抓取并建立索引,建立相对应的新闻垂直搜索引擎系统。     

发现含有第一类项目约束的频繁集的快速算法

与Apriori-like类型的算法相比,Zaki提出的基于垂直数据库结构及基于网络理论的算法将关联规则挖掘的运行速度提高了一个数量级,并且这些算法非常适合挖掘低支持度、长模式的关联规则。以Ecalt算法为原型,讨论了如何将项目约束引入关联规则挖掘过程的问题,从理论上证明了引入约束后的Eclat＋算法可以大大提高算法的效率和速度,并对相关的算法进行了比较。