钛合金的银脆,镉脆敏感性及其控制

利用慢应变速率拉伸技术（ＳＳＲＴ），并结合恒载实验，较全面地研究了Ｔｉ－６Ａｌ－４Ｖ合金的银脆行为、固态与液态镉脆行为，确定了应变速率、接触条件、热处理制度、试样取向、温度等因素对Ｔｉ－６Ａｌ－４Ｖ合金银脆与镉脆敏感性的影响，探讨了Ｎｉ阻挡层对控制Ｔｉ－６Ａｌ－４Ｖ合金和ＴＣ１１合金银脆开裂的作用。     

二极管端泵浦连续激光器激活介质长度与透过率的优化

从准三能级系统的速率方程出发,推导出了二极管(LD)端泵浦连续工作端面泵浦固体激光器的速率方程,提出了计算连续LD端面泵浦激光器输出功率的方法,并表示成激活介质长度和透过率的函数,由此得到在泵浦功率一定情况时的优化设计步骤。数值计算结果与我们的实验结果和文献[3],[4]的实验数据符合甚好。     

积极开展泵站技术改造

为探索山丘地区中小型泵站技术改造的经验，选定南康县四个小型泵站作为泵站改造的试点站，进行现场测试，根据测试成果，分析各站存在的问题及效率偏低的原因，并拟定各站技术改造的措施，经实施后取得了较好的效果，本文就南康县泵站改造的实际效果阐明泵站改造的必要性及其改造过程中值得注意的问题。     

Effect of heating-rate on failure temperature of pre-loaded brass H62

The response and failure of brass H62 specimens subjected to different levels of pre-loaded stresses and heating rates were investigated using a Gleeble-1500 thermal-mechanical material testing system. The metallographs of the tested material were also observed and analyzed. It is found that the increase of either pre-loaded stress or heating-rate decreases the failure temperature. Metallographic analysis shows that high heating-rate may cause stronger local thermal inconsistency （LTI） and remarkably increase the microdefects in the material, which may markedly degrade the macroscopic mechanical properties of the material.     

Modelling the rate of secondary succession after farmland abandonment in a Mediterranean mountain area

Secondary succession after farmland abandonment has become a common process in north Mediterranean countries, especially in mountain areas. In this paper, a methodology is tested which combines Markov chains and logistic multivariate regression to model secondary succession after farmland abandonment in environments where abiotic constraints play a major role, like mountain areas. In such landscapes, a decay in the succession rate with time is usually found, as the best locations are progressively occupied. This is frequently addressed using non-stationary Markov chains. Here, we test if the combination of logistic multivariate regression with Markov chains, however, allows for spatially distributed transitions probabilities based on abiotic factors and therefore, it is able to reproduce the preferential colonization of the most favourable locations. The model is tested in the Ijuez Valley in the Spanish Pyrenees, which underwent generalized land abandonment during the 1950s. Results confirm a substantial improvement in the prediction success of the Markov-logistic model when compared to the standard Markov chain approach. As a result, the decay in the succession rate can be successfully modelled. The specific results for our study area are discussed further in an ecological context. The methodology proposed is applicable to any landscape where vegetation dynamics are constrained by environmental factors. However, the inclusion of land use as an explanatory factor would be necessary in human-managed landscapes.     

Analysis and Optimization Laminar Viscous Flow Through a Channel

Optimizing of laminar viscous flow through a pipe by two dimensionless values is investigated analytically. Dimensionless entropy generation and pumping power to heat transfer rate ratio are used as basis for constant viscous and the temperature dependence on the viscosity. For this matter we calculate entropy generation and pumping power for a fully developed in a pipe subjected to constant wall temperature for either constant viscosity and the variable viscosity. The variation entropy generation increase along the pipe length for viscous fluid is drawn, either the variation summation dimensionless entropy generation and the pumping power to heat transfer rate ratio are varying the fluid inlet temperature for fixed pipe length and are varying pipe length for fixed fluid inlet temperature are drawn. For low heat transfer conditions the entropy generation due to viscosity friction becomes dominant and the dependence of viscosity with the temperature becomes essentially important to be considered.     

辽宁省节水工作存在问题及对策

辽宁省是水资源严重短缺的省份之一，水资源不足已成为制约全省经济社会可持续发展的瓶颈。通过对全省大型取用水户的调查分析，找出了辽宁省节水工作中存在的问题，提出了节约用水工作的对策和建议。     

底水油藏射孔优化设计

为了优化底水油藏的生产参数，研究了不同产量时射孔长度的优化方法。采用球面流和径向流相结合的模型推导了临界产量和无水采油量的计算公式，分别以临界产量和无水采油量为标准，对胜利油田桩西区块底水油藏上6口油井的射孔长度进行了优化设计，优化结果表明，对于底水油藏应首先按照临界产量对射孔长度进行优化设计，如果得到的最大临界产量不符合实际生产的要求，就应按照无水采油量进行射孔优化设计。研究表明，当油井产量超过临界产量后，以临界产量为标准得到的优化射孔长度会减小油井的无水采油量。     

Split and collectorless flotation to medium coking coal fines for multi-product zero waste concept

The medium coking coal fines of − 0.5 mm from Jharia coal field were taken for this investigation. The release analysis of the composite coal reveals that yield is very low at 10.0% ash, about 25% at 14% ash and 50% at 17% ash level. The low yield is caused by the presence of high ash finer fraction. The size-wise ash analysis of − 0.5 mm coal indicated that − 0.5 + 0.15 mm fraction contains less ash than − 0.15 mm fraction. Thus, the composite feed was split into − 0.5 + 0.15 mm and − 0.15 mm fractions and subjected to flotation separately. The low ash bearing fraction (− 0.5 + 0.15 mm) was subjected to two stages collectorless flotation to achieve the concentrate with 10% ash. The cleaner concentrate (18.9%) with 10% ash was recovered which has an application in metallurgical industries. The concentrate of 30.2% yield with 12.5% ash could be achieved in one stage collectorless flotation which is suitable for use in coke making as sweetener. As the − 0.15 mm fraction contains relatively high ash, collector aided flotation using sodium silicate was performed to get a concentrate of 23.6% yield with about 17% ash. The blending of this product with cleaner tail obtained from − 0.5 + 0.15 mm produces about 35.0% yield with 17% ash and that can be utilized for coke making. The reject from the two fractions can be used for conventional thermal power plant or cement industries using a 23.5% ash after one stage collector aided flotation and the final tailings produced content ash of 61.6% can be used for fluidization combustion bed (FBC). This eventually leads to complete utilization of coal.     

黑钨矿细泥浮选时有机螯合剂的活化作用

黑钨矿细泥的有效浮选仍是有待解决的选矿难题。本文试图采用有机螯合剂作活化剂，以实现黑钨细泥浮选药剂低耗高效的目的。