石英砂的相变与换向器套筒铸件的变形

用呋喃树脂石英砂工艺生产牵引电机换向器套筒出现变形、裂纹等铸造缺陷,是由石英砂相变膨胀引起,后用高铬刚玉砂代替石英砂得到解决.     

Determination of heavy metals and volatile aromatic compounds in used engine oils and sludges

Assessment of contaminant releases during utilization of used oils is essential for the determination of environmental acceptability. These paper reports the results of the study examining a toxic metal leachability from used engine oil and sludge samples employing leaching test (TCLP). The leaching test indicated that lead in oil samples exceeded 5-ppm concentration level what qualified them as a toxic waste. The samples of contaminated sludge were found to contain high concentration of total lead, barium and chromium, but the leaching test showed concentration below regulatory limit. The total content of benzene, ethylbenzene, toluene, and xylenes (BETX), and naphthalene in used oil and sludge samples was also determined and was found not to be a significant factor to contamination.     

Initial stages of tin electrodeposition from sulfate baths in the presence of gluconate

Tin electrodeposition in its initial stages in acid sulfate/gluconate baths was studied with varying tin and gluconate concentrations using potential-controlled electrochemical techniques. The deposit morphology was observed by scanning electron microscopy (SEM). A comparison with tin electrodeposition from acid sulfate baths in the absence of gluconate was also carried out. Use of a highly acidic bath leads to nonuniform deposits, even in the presence of gluconate; at pH 4 deposits are uniform, brilliant and suitable for finishing applications. Tin crystallites have a well defined morphology which depends on bath agitation conditions. In the absence of agitation, the crystallites have the same tetragonal shape as in a sulfate bath without gluconate.     

Thermodynamic Criteria for the Maximum and Minimum Strength of Fibre-Reinforced Composite Materials

The overall performance and reliability of composite materials are, in most cases, dependent upon the behaviour of the reinforcement-matrix interface, particularly upon its ability to transfer stress.

A theory for predicting thermodynamic conditions for the maximum and zero-adhesion at the reinforcement-matrix interface is tested in this paper, based on experimental data. Proposed is a model of the relationship between mechanical properties of composite materials (tensile strength, flexural strength, Young's modulus and impact resistance) and energetic properties of matrix and reinforcement expressed by the energy ratio a = γ_l/γ₂.     

Influence of the composition of the binder and the carbonation on the zeta potential values of hardened cementitious materials

Electroosmotic experiments have been carried out on eight different mixes of hardened cementitious matrixes including concrete, mortar and pastes, different types of binders, carbonated and non-carbonated specimens and different test conditions. From these trials, the zeta potential values have been determined and the optimum experimental parameters and devices have been established. In addition, the influence of the composition of the binder on the zeta potential has been quantified indicating that higher amounts of Al₂O₃ in the binder lead to higher positive values of zeta potential, while the SiO₂ acts just on the opposite side. This has been explained in terms of the different i.e.p. (isoelectric point) for both oxides. Concerning the influence of carbonation, it increases the absolute value of the zeta potential toward more negative values; this behaviour has been attributed to the influence of the specifically adsorbed Ca²⁺ in the negative sites of the surface in the non-carbonated samples.     

用预分解技术改造Φ4×60m预热器窑的又一成功实例

介绍南京水泥工业设计研究院用预分解生产技术对山东水泥厂Φ4×60m预热器窑烧成系统进行的成功技术改造。技改设计指标为：熟料产量保证指标1500t／d，争取指标1700t／d，熟料热耗＜3762kJ／kg，熟料28d抗压强度＞60MPa。整个工程停产施工耗时仅用48d，烧成系统技改共耗资约3000万元。技改后一次点火投料成功，且点火当月即实现72h达标考核，所有设计指标均达标。     

Proposal of a uniform color scale for virgin olive oils

A new color scale was developed from a broad data set of 1700 virgin olive oil samples over four crop seasons, which can be considered highly representative of the whole color range of virgin olive oils available in Spain. This color scale provides a new set of 60 color standards, improving the results achieved by the old 60-color standards proposed by the bromthymol blue method. Seeking the greatest possibility of including a near match between colors of virgin olive oils and proposed standards, we developed our new color scale using a recent uniform color space, with standards placed in a regular rhombohedral lattice like the one employed by the Uniform Color Scales of the Optical Society of America. The average color difference between each of the 1700 virgin olive oils and its nearest standard is reduced from 8.17 CIELAB units, using the bromthymol blue standards, to 3.99 CIELAB units using the new standards. Within a color tolerance of 7.0 CIELAB units, 93.2% of our virgin olive oils can be classified with the new standards, but only 59.1% with the bromthymol blue ones. In the interest of future adoption, the performance of the new color standards should be tested by industry and researchers.     

月桂氮草酮研究进展

介绍了月桂氮草酮作为高效皮肤促渗剂的发展概况、合成工艺、研究进展及其应用前景。     

化工搅拌器的参数优选

本文提出了确定化工用搅拌器搅拌时间的一种简单试验方法,并用正交表安排寻找最佳搅拌参数的试验和整理试验数据,得到了有实用价值的结果。     

Differential geometry properties of lines of curvature of parametric surfaces and their visualization

We present algorithms for computing the differential geometry properties of lines of curvature of parametric surfaces. We derive a unit tangent vector, curvature vector, binormal vector, torsion, and algorithms to evaluate their higher-order derivatives of lines of curvature of parametric surfaces. Among these quantities, it is shown that the curvature and its first derivative of the lines of curvature lend a hand for the formation of curved plates in shipbuilding. We also visualize the twist of lines of curvature, which enables us to observe how much the osculating plane of the line of curvature turns about the tangent vector.