非金属电镀用导电漆的研制

介绍了导电漆、作为导电填料的片状镀银铜粉的制备工艺流程。分别研究了漆膜表面单位电阻与镀银铜粉的含量及其粒径以及钛酸酯偶联剂的含量之间的关系。结果表明,当镀银铜粉的粒径为400目、质量分数在57%~65%之间,钛酸酯偶联剂的质量分数为10%时,所得涂膜的导电性能最佳。加入含C-18的油酸可以使导电漆长期贮存而电阻值不变。经检测,所得涂膜具有良好的性能:附着力1级,硬度1 H,柔韧性1 mm,冲击强度50 kg/cm2,膜厚10~15μm,漆膜表面每厘米电阻0.15Ω,每分米电阻0.47Ω。指出了导电漆应用过程中的注意事项。     

Effects of oxidation on I2 doping of trans-polyacetylene as studied via e.s.r. and conductivity measurements

Oxidation of trans-polyacetylene lowers the activation energy for conduction from 16 kcal mol^?1 to 11 kcal mol^?1 for oxidation levels of (C₂H₂O_n)_x, n = 0.144, 0.207 and 0.550. Maximum conductivity levels for 0 < x < 0.144 doped with I₂ were almost identical. At long I₂ doping times all samples exhibited some loss of conductivity. E.s.r. experiments indicate that: (1) linewidth is directly proportional to oxygen content, and (2) iodine doping is not diffusion controlled. All data are consistent with a molecular picture of PAC consisting of highly reactive localized spin states that are selectively oxidized, and less reactive delocalized states that affect conductivity more strongly via doping.     

Comments on the characterisation of oxidation catalysts using TPR/TPO

Temperature programmed reduction (TPR) and oxidation (TPO) are used extensively in catalyst characterisation. In this paper, we examine the use of TPR/TPO cycles for the characterisation of a range of molybdates and single oxides. In particular we observe that the first cycle differs from that of subsequent analyses, even when the maximum temperature is limited to that used in the catalytic reaction. The effect is independent of heating rates and cooling atmospheres and has been demonstrated using different bed configurations. This observation has significance when these oxides are used in periodic flow reactors that involve many cyclical reduction/oxidation.     

High catalytic activity of PdOx/MnO2 for CO oxidation and importance of oxidation state of Mn

PdO_x/MnO₂ has been examined as a catalyst for CO oxidation using a conventional flow reactor at reaction temperatures between 50 and 150°C. In the reaction conditions of GHSV (gashourlyspacevelocity) of 1.22 × 10⁵/h and CO concentration of 2000 ppm, PdO_x/MnO₂ showed higher catalytic activity compared with PdO_x/Mn₂O₃, which had been previously reported as an effective catalyst due to the cooperative action of Pd and Mn₂O₃ for this reaction. The reason for higher activity of PdO_x/MnO₂ than PdO_x/Mn₂O₃ has been investigated using TPR (temperatureprogrammed reduction) and XPS studies. TPR showed that PdO_x/MnO₂ could be reduced by CO at much lower temperature than PdO_x/Mn₂O₃. During the experiment of reduction and oxidation, XPS showed that the valence of Mn in the PdO_x/MnO₂ was between 4+ and 3+, which is higher than that of Mn in the PdO_x/Mn₂O₃ catalyst of which the valence has been reported to be between 3+ and 2+. It is known that in this catalyst system the support supplies oxygen onto Pd, where the oxidation occurs with adsorbed CO, and the ability of the support to provide oxygen improves the performance of the catalyst. Therefore, it was concluded that the readiness of MnO₂ to be reduced with maintaining a higher oxidation state showed higher CO oxidation activity than Mn₂O₃ as support for PdO_x.     

Pore structure of bulk tungsten carbide powder catalysts

Bulk tungsten carbide catalysts are prepared by direct carburization/reduction of tungsten trioxide in methane-hydrogen mixtures. The catalytic properties of such catalysts have been studied by several authors. The porous structure of these catalysts is studied by adsorption of N₂, Kr, CF₄ and neohexane. Adsorption isotherms and hysteresis loops for the catalysts suggest the presence of a microporous structure made of parallel plates distant approximately by 20 Å. These results are compared to those obtained using such catalysts for hydrogen oxidation and where condensation in the porous structure was observed.     

水合肼生产中氧化反应的研究和应用

分析了尿素法生产水合肼的氧化反应历程及影响因素，改进了反应器，并找到了最佳的工艺控制条件：①控制n(尿素)：n(次氯酸钠)=(1．05～1．10)：1，各原料的消耗较低，总经济效益佳；②采用-5℃冷冻盐水移走尿素、次氯酸钠混合段内氯化反应放出的热量，控制物料混合终点温度在15～30℃；③采用列管式加热器，将氯化反应与水解反应在不同的设备中进行，水合肼的收率提高到83％～85％；④采用列管式加热器代替双夹套反应器，提高了加热强度，生产能力大，1套合成反应器可生产1万t／a80％的水合肼。     

基于主成分分析中的几类问题的计算公式及结论

讨论了主成分分析中的几类问题的计算方法,重点揭示在协方差矩阵中对角元素相同时的第一主成分及贡献率和对角元素不同时的主成分贡献率．经讨论后给出有关计算公式,并说明这些计算公式在多元统计分析中的实际作用     

基于模块化模型的自适应预失真技术

系统地比较和分析了OFDM传输系统里高功率放大器（HPA）预失真方法的优缺点,提出一种基于模块化模型的有记忆高功率放大器自适应数字预失真方法,该方法分别基于Wiener、Hammerstein和Wiener-Hammerstein模型各自构成一个有记忆HPA的自适应预失真器。从而避免了因分别估计Wiener-Hammerstein模型各个环节特性参数所带来的复杂性。使得有记忆高功率放大器的预失真设计变得简单了。     

Reserve estimation of an open pit mine under price uncertainty by real option approach

Reserve estimation is a key to find the correct NPV in a mining project. The most important factor in reserve estimation is the metal price. Metal price fluctuations in recent years were exaggerated, and imposed a high degree of uncertainty to the re-serve estimation, and in consequence to the whole mine planning procedure. Real option approach is an efficient method of deci-sion making in the uncertain conditions. This approach has been used for evaluation of defined natural resources projects until now. This study considering the metal price uncertainty used real option approach to prepare a methodology for reserve estimation in open pit mines. This study was done on a copper cylindrical deposit, but the achieved methodology can be adjusted for all kinds of deposits. This methodology was comprehensively described through the examples in such a manner that can be used by the mine planners.