表面活性剂对HCl-FeCl3溶液中锌精矿在浆萃取浸出率的影响

The effects of surfactant on the solvent extraction in leaching sphalerite were investigated. It is found that sodium dodecyl sulfonate is the effective surfactant in improving the zinc recovery from sphalerite in the aqueous FeCl3-HCl-tetrachloroethylene system. Through the measurements of surface tension and viscosity of the sphalerite slurry modified with different surfactants, it is concluded that sodium dodecyl sulfonate in the concentration range of 0.05 to 0.2g L-1 can improve the viscosity of sphalerite slurry in the water, decrease the surface tension of leaching solution, prevent the aggregation of ore particles, and give very high zinc extraction .     

利用废旧锌锰电池制取锌盐和氧化锌的研究

以废旧锌锰电池为研究对象,采用湿法回收技术,制备ZnSO4.7H2O,ZnCO3和ZnO。结果表明,Zn溶解时间随着H2SO4浓度而变,当H2SO4浓度为3 mol/L时,溶解耗时仅为5 h,ZnSO4.7H2O产率可达93.44%。在Na2CO3,NaHCO3,(NH4)2CO3三种沉淀剂中,(NH4)2CO3的沉淀效果最好,制备的ZnCO3颗粒细小,在1 073.2 K条件下,其分解效率可达88.75%。     

锌釉SiO2-Al2O3性状图的基础研究

研究了锌釉的SiO2-Al2O3性状图。该实验是在确定锌釉的塞格尔式和SiO2、Al2O3变化图的情况下进行，即固定塞格尔式中碱性成分的摩尔量，而按照SiO2、Al2O3变化图有规律的改变SiO2、Al2O3的含量。分别在1100℃、1150℃、1200℃三个温度下，采用氧化气氛烧成制得样品。用肉眼法对样品进行表观效果分析，从而得到相应条件下的锌釉SiO2-Al2O3性状图。     

Structural Modulations in Monoclinic Tricalcium Silicate Solid Solutions Doped with Zinc Oxide, M(I), M(II), and M(III)

Structural modulations in solid solutions of C₃S doped with various amounts of ZnO were investigated via the selected-area electron diffraction method. Three monoclinic modifications (M(I), M(II), and M(III)) were identified in the solid solutions. The modifications had pseudohexagonal subcells that were modulated to form supercells. Coordinates of the reflections attributable to the supercells could be expressed by the following linear combinations of vectors of the reciprocal lattices: m₁(−2 a */5.4 + 2 b */5.4 − 7 c */5.4) for M(I), m₂(− a */5 + b */5 − c *) for M(II), and m₃(− a */6 + b */6 + 7 c */6) for M(III), m₁ and m₂=±1 and ±2, and m₃=±1, ±2, and ± 3. All the monoclinic modifications possessed structural modulations of a one-dimensional type. The modulation waves could be detected as wavy contrasts by high-resolution transmission electron microscopy.     

用锌渣制备高纯氧化锌

介绍了利用锌渣为原料生产高纯氧化锌的方法。采用黄铁矾法除去大部分铁，通过控制ｐＨ值进一步除铁，用锌粉或锌屑还原除去重金属，用氨水为沉淀剂，最终可使氧化锌的含量达９９．８６％以上。     

Sintering of Ceramic Particulate Composites: Effect of Matrix Density

Composites consisting of a fine-grained, polycrystalline zinc oxide matrix and <10 vol% coarse, rigid silicon carbide inclusions were prepared by the same mixing procedure and then compacted to produce samples with matrix densities of 0.45 and 0.68 of the theoretical. The samples were sintered under identical temperature profiles in separate experiments that employed either a constant rate of heating of 4°C/min or near isothermal heating at 735°C. The ratio of the densification rate of the composite matrix to the densification rate of the unreinforced zinc oxide was found to be independent of the initial matrix density. This ratio increased significantly with temperature in the constant-heating-rate experiments but was relatively constant in the isothermal experiments. The results indicate that microstructural coarsening may be an important mechanism for explaining the reduced sinterability of polycrystalline matrix composites.     

Regeneration of zinc particles for zinc–air fuel cells in a spouted-bed electrode

Fuel cells wherein zinc particles form a negative electrode and a gas-diffusion electrode (air electrode) is the positive electrode, are under development. Such cells are dependent on the regeneration of the zinc particles (and electrolyte). This paper describes experiments on electrolytic cells equipped with spouted bed cathodes for use in this application. Experiments have been carried out on laboratory scale cells to determine the operability of cells for growing 'seed particles in the range from 0.4 to 1 mm to measure cell voltage and current efficiency (and thereby energy consumption rate), and to identify a suitable material that could be used as a diaphragm (separating the spouted bed from the oxygen evolving anode). A larger cell, capable of producing up to 10 kg Zn per day, was designed and built. The larger cell was run successfully fifteen times and showed cell voltages and energy consumption rates comparable with those of smaller cells.     

国内外活性氧化锌的进展

叙述了活性氧化锌的简史，特点、应用、生产方法的进展，活性的测定方法及标准。     

Influences of zinc oxide and an organic additive on the electrochemical behavior of pure aluminum in an alkaline solution

The corrosion behavior of pure aluminum in inhibited and uninhibited 4 MKOH was investigated by means of hydrogen collection, polarization curve measurement and electrochemical impedance spectroscopy (EIS). The results showed that the corrosion of pure aluminum was greatly inhibited by the addition of ZnO and dimethyl amine epoxy propane (designated as DE). EIS and EDAX analyses revealed that ZnO produces its effect by depositing on the aluminum surface, which increases the overpotential of hydrogen evolution. It was also found that the addition of DE could greatly improve the deposition of zinc layers.     

活性纳米ZnO的制备

用成本低廉的锌焙砂为原料 ,通过直接沉淀法首先合成前驱物碱式碳酸锌 ,然后烘干分解得到活性纳米ZnO粉体。TG -DTA表明前驱物为碱式碳酸锌 ,XRD估测颗粒尺寸为 90nm ,产品气敏度为 17.8。