四唑嘧磺隆水分散粒剂在稻田环境中的残留动态

为评价除草剂四唑嘧磺隆在水稻上使用后的残留动态及环境安全性，在北京海淀区进行了50％四唑嘧磺隆水分散粒剂在水稻上的残留动态和最终残留试验研究。样品经丙酮提取抽滤后，再经液液分配及氧化铝柱净化、浓缩、定容后，用紫外检测器的液相色谱进行测定。其有效成分四唑嘧磺隆的最低检出量为0．02ng，在稻田水、土壤、鲜植株、稻壳、糙米样品中的平均回收率为82．4％-105．0％，变异系数为1．1％～14．1％，符合农药残留分析的要求。结果表明：四唑嘧磺隆在水稻植株上的半衰期为2．4d，在土壤巾的半衰期为5．5d，在稻田水中的半衰期为1．9d，施药后7d四唑嘧磺隆在水稻植株上的消解达到80％以上。50％四唑嘧磺隆水分散粒剂按80、120g／hm。使用，施药1次，收获时，四唑嘧磺降在糙米、稻壳、稻草、土壤中的残留量均未检出。     

Effect of Pretreatment Atmosphere on CuO/TiO2 Activities in NO + CO Reaction

Using TiO₂ as carrier, CuO/TiO₂ catalysts with different CuO loading were prepared by the impregnation method. The catalytic activities in NO+CO reaction were examined with a micro-reactor gas chromatography reaction system and the methods of TPR, XPS and NO-TPD. It was found that the catalytic activities were affected by pretreatment atmosphere, i.e. H₂ atmosphere > reduction–reoxidation > 10%CO/He > reaction gas (fresh sample). NO decomposition was better by low-valence Cu species than by high-valence Cu species, i.e. Cu⁰>Cu⁺>Cu²⁺. The XPS results indicated that Cu species on CuO/TiO₂ were Cu⁰, Cu⁺, normal Cu²⁺(Cu²⁺(I)) and chain-structured Cu²⁺(Cu²⁺(II)) as –Cu–O–Ti–O–. The activities of Cu²⁺(II) were much higher than that of Cu²⁺(I), but both species were very unstable in the reaction atmosphere and easily reduced by CO, which accounted for the variable activities of fresh catalysts with increasing reaction temperature. In NO+CO reaction, the redox process was a cycle of Cu⁺–Cu²⁺(I) at low reaction temperature but was a cycle of Cu⁰–Cu⁺ at high reaction temperature. As shown by NO-TPD, high catalytic activities could be attributed to the following factors, e.g. oxygen caves on the catalyst’s surface after pretreatment with H₂ and reduction–reoxidation, formation of Cu⁰ after pretreatment with H₂, and increment of Cu species dispersion and formation of Cu²⁺(II) after pretreatment with reduction–reoxidation.     

硅压阻式气压高度计的设计与实现

采用硅压阻式压力传感器,以ATmega88PA为控制器设计了气压高度计。内嵌全温度范围的曲面拟合算法进行温度补偿及线性化处理,解决了压力传感器的温漂和非线性问题,并用海拔高度与气压的关系计算高度。测量结果通过RS-485接口发送给上位机。测试结果表明,该气压高度计压力测量误差优于0.50‰,分辨率为0.01 h Pa,线性度为0.999 9;标准大气环境下高度测量误差为0.16 m,线性度为0.999 8。该气压高度计具有质量小、功耗低、精度高、工作可靠等优点。     

吡虫啉在蔬菜中残留量高效液相色谱测定方法

建立了用高效液相色谱法测定出口蔬菜中吡虫啉农药残留量的方法。试样用酸性乙腈提取,C18柱净化,乙酸乙酯洗脱,反相高效液相色谱-紫外检测器测定,检测波长为270nm。方法的最低检测限为0.05mg/kg,0.1～0.5mg/kg水平添加回收率的范围是86.67%～100.33%,相对标准偏差为3.19%～9.95%。     

大庆常压渣油催化裂解反应规律研究

采用小型固定流化床实验装置,以大庆常压渣油为原料,针对Ca-Al裂解催化剂,详细分析了催化裂解气体产品和液体产品的组成,考察了反应温度、剂油比、水油比和停留时间对裂解产物分布的影响。发现各操作条件对大庆常渣催化裂解产物分布具有不同程度的影响,其中反应温度的影响最大;随反应温度的升高,乙烯产率单调增加,而丙烯、丁烯和总低碳烯烃产率均存在一个最大值。在优化的操作条件下,乙烯质量产率可达25%,总低碳烯烃质量产率超过50%。     

治理铬渣的两个关键

铬渣中存在的酸溶性六价铬是解毒效果能否持久的关键，而铬渣中游离氧化镁消化是利用铬渣作建筑材料时必须高度重视的问题，论述了湿法解毒、高温解毒和非熔融的综合利用法等方法，对铬盐行业的铬渣治理有指导作用。     

农药残留薄层色谱分析中的显色技术

农药残留特别是剧毒有机磷农药残留一直是国内外农药科技工作者比较关注的一个课题。显色技术是农药残留薄层分析技术发展迅速的关键 ,对显色技术作了较为系统全面的介绍     

GOR-C降烯烃催化剂的工业应用

大庆炼化公司林源生产指挥部催化裂化装置原料油为典型石蜡基原油的常压渣油，生产的催化汽油中的烯烃含量较高，为此试用长岭炼化公司催化剂厂生产的降烯烃催化剂GOR-C。结果表明，降烯烃效果明显，产品分布无明显变化，能满足现有生产要求，经济效益显著。     

Ultrapyrolysis of automobile shredder residue

A fast pyrolysis (Ultrapyrolysis) process was employed to convert automobile shredder residue (ASR) into chemical products. Experiments were conducted at atmospheric pressure and temperatures between 700 and 850°C with residence times between 0.3 and 1.4 seconds. Pyrolysis products included 59 to 68 mass% solid residue, 13 to 23 mass% pyrolysis gas (dry) and 4 to 12 mass% pyrolytic water from a feed containing 39 mass% organic matter and 2 mass% moisture. No measurable amounts of liquid pyrolysis oil were produced. The five most abundant pyrolysis gases, in vol%, were CO (18–29), CO₂ (20–23), CH₄ (17–22), C₂H₄ (20–22) and C₃H₆ (1–11), accounting for more than 90% of the total volume. The use of a higher organic content ASR feed (58 mass%) resulted in less solid residue and more pyrolysis gas. However, no significant changes were noted in the composition of the pyrolysis gas.     

厌氧污泥处理含铬废物的研究

利用城市污水处理厂的厌氧污泥对含铬废物进行解毒研究,结果表明,在厌氧条件下,厌氧污泥对重铬酸钾溶液和铬渣进行解毒后,滤液中的Cr6+质量浓度极低,大大低于《污水综合排放标准》的0.5 mg/L。厌氧污泥的解毒效果与含铬物料的量、解毒时间等因素有关。