碳纤维增强混凝土构件正截面计算的双界限系数法

以材料的力学性能分析为基础，利用双界限系数将碳纤维增强混凝土受弯构件划分成三种正截面的破坏形态，对每一种破坏形态，建立了单、双筋矩形截面极限承载力的计算式，使碳纤维增强混凝土构件正截面计算与现行的规范相一致。     

TRVs and fault clearing stresses in extra-high-voltage radial networks

To cope with the high rate of increase of power demand in the main industrialized districts in Japan, 550-kV transmission systems covering the districts have been reinforced, with most of the main power plants connected directly to these systems. Through 550-/300-kV substations, the majority of power to the districts is supplied by 300-kV systems. To limit the excess short-circuit capacity in the 300-kV systems, they tend to be reconstructed as so-called radial networks. In radial networks with high short-circuit capacity and relatively small number of transmission lines connected to the substation busbars, the rate of rise of TRV can be far higher than standard value. This paper analyzes the transient recovery voltages (TRV) in such extra-high-voltage radial networks in Japan, together with the relevant stresses to circuit-breakers during fault clearings. Future system conditions have also been introduced. As the typical rate of rise of the TRV values, more than twice that of today's standard ones are probable.     

渤中28－1（BZ28－1）油田N6H水平井动态分析

本文以渤中２８－１（ＢＺ２８－１）油田Ｎ６Ｈ水平井为例，从多方面对该井的动态和产能变化进行了系统分析，所用的方法对水平井动态分析有一定的指导意义。     

固定式塔吊基础设计与施工技术

潘家园小区工程建筑面积3．6万m^2，地下3层，地上28层。基槽标高-10.750m，地面至屋面女儿墙上口高度为83m，地上标准层层高2．8m。采用土钉墙护坡，坡度1：0．1，该工程的地质条件适宜桩基础的施工。     

Experimental study of composite cold-formed steel C-section floor joists

Twelve large-scale slab specimens and twenty-two companion push-out specimens were tested to study the behavior and capacity of composite slab joists consisting of cold-formed steel C-sections and concrete. Four shear transfer mechanisms, including surface bond, pre-fabricated bent-up tabs, pre-drilled holes, and self-drilling screws, were employed on the surface of the flange embedded in the concrete to provide shear transfer capacity. Results indicated that specimens employed with shear transfer enhancements showed a marked increase in strength and reduced deflection compared with those relying only on a natural bond between steel and concrete to resist shear. Of the three shear transfer enhancements investigated, bent-up tabs provided the best performance at both the strength and serviceability limit states, followed by drilled holes in the embedded flanges. The use of self-drilling screws resulted in the lowest strength increase. The correlation of shear transfer capacity of push-out specimens with the ultimate capacity of large-scale specimens indicated that the average experimental flexural capacity of the slab specimens was approximately 1.16 times the average predicted value based on push-out test results.     

Zeolite synthesis from paper sludge ash with addition of diatomite

BACKGROUND: This study aimed to investigate the synthesis of zeolites from paper sludge ash (PSA) with added diatomite to remove both NH₄⁺ and PO₄^3? for water purification. The PSA had low Si and significant Ca contents. Four types of diatomite: white (T‐W) and brown (T‐B) from deposits of marine origin in Takanosu, and white (S‐W) and gray (S‐G) from lacustrine deposits in Shonai, were added to NaOH solution to increase the Si content and thereby synthesize zeolites with high cation exchange capacity (CEC). RESULTS: The order of the amounts of Si extracted from the diatomite to the alkali solution was S‐W > T‐W = T‐B > S‐G, which correlates with the amorphous SiO₂ content of diatomite. The original ash without addition of diatomite yielded hydroxysodalite with CEC of about 1.0 mmol g^?1. For all samples, the addition of diatomite to the solution yielded zeolite‐P with a higher CEC, but the addition of excess Si inhibited the synthesis of zeolite‐P, and the CEC of the product was low. A product with high CEC including zeolite‐P was obtained in a solution with around 500 mmol L^?1 of Si concentration, and had the ability to remove both NH₄⁺ and PO₄^3?. CONCLUSION: Diatomite has the potential for used as an additive for the synthesis of high CEC zeolite from PSA. The product with zeolite‐P exhibited relatively high CEC, capacity for NH₄⁺ uptake, and the ability to remove PO₄^3? by precipitation, which is preferable for water purification applications. Copyright © 2008 Society of Chemical Industry     

Estimation of Load Capacity of Pipe Piles in Sand Based on Cone Penetration Test Results

Pipe piles can be classified as either closed- or open-ended piles. In the present paper, the load capacity of both closed- and open-ended piles is related to cone penetration resistance qc through an experimental program using calibration chamber model pile load tests and field pile load tests. A total of 36 calibration chamber pile load tests and two full-scale field pile load tests were analyzed. All the test piles were instrumented for separate measurement of each component of pile load capacity. Based on the test results, the normalized base resistance qb/qc was obtained as a function of the relative density DR for closed-ended piles, and of both the relative density DR and the incremental filling ratio (IFR) for open-ended piles. A relationship between the IFR and the relative density DR is proposed as a function of the pile diameter and driving depth. The relationship between IFR and DR allows the estimation of IFR and thus of the pile load capacity of open-ended piles at the design stage, before pile driving operations.     

世界乙烯工业及其进展

阐述了世界乙烯产能需求现状，近扑扩能增产预测，乙烯原料分析以及乙烯生产的技术进展。     

Computation of Bearing Capacity Factor Nγ?Terzaghi’s Mechanism

A procedure based on K?tter’s equation is developed for the evaluation of bearing capacity factor Nγ with Terzaghi’s mechanism. Application of K?tter’s equation makes the analysis statically determinate, in which the unique failure surface is identified using force equilibrium conditions. The computed Nγ values are found to be higher than Terzaghi’s value in the range 0.25–20%, with a diverging trend for higher values of angle of soil internal friction. A fairly good agreement is observed with other solutions which are based on finite difference coupled with associated flow rule, limit analysis, and limit equilibrium. Finally, the comparison with available experimental results vis-à-vis other solutions shows that, computed Nγ values are capable of making a reasonably good prediction.     

海底管道的沉降量计算

根据极限平衡和极限分析方法,建立了软黏土地基土体上海底管道的极限承载力计算公式。当地基处于极限状态时,基础作用于地基的全部荷载应该等于该地基土体的承载能力,根据这一关系式可以推导出海底管道沉降量的计算公式。通过对试验结果的分析,证实所采用的计算方法是可行的。