一种T形高压输电线路故障测距新方法

对T形线路的故障测距，现有方法都是先判断故障支路，再将3端线路等效成2端线路进行测距。但在 T节点附近短路，尤其是经高阻短路时，现有的测距方法由于无法正确判别故障支路而存在一定范围的测距死区。针对上述缺陷，分别假设故障发生在某一支路，由假定正常的2段支路端的电压、电流推算求得 T节点电压和注入假定故障支路的电流，从而分别求得3个故障距离。经证明，求得的3个故障距离有且仅有1个在0和对应支路总长度之间，该距离就是真实的故障距离，故障发生在对应支路上。该方法无需事先判别故障支路即可测距，在 T节点附近经高阻故障时无测距死区。其测距精度理论上不受过渡电阻和故障类型影响，无需故障前数据，且对滤波无高要求。EMTP仿真结果表明该方法正确、有效，测距精度高。     

Evaluation codes at singular points of algebraic differential equations

We use the special geometry of singular points of algebraic differential equations on the affine plane over finite fields to study the main features and parameters of error correcting codes giving by evaluating functions at sets of singular points. In particular, one gets new methods to construct codes with designed minimum distance. This work was partially supported by MCyT BFM2001-2251.     

Electrochemical noise analysis for estimation of corrosion rate of carbon steel in bicarbonate solution

We have investigated the electrochemical noise behavior of carbon steel in fully deaerated aqueous bicarbonate solutions, and discussed the optimum conditions of the noise analysis for estimating corrosion rate of the steel. Noise of the potential difference and of the short-circuit current between two identical steel coupons were successfully measured. The time-series noise patterns were transformed into frequency domain by fast Fourier transformation, and then their power spectrum densities (PSDs) at a frequency were determined to be compared with the corrosion rate. The PSDs of the potential and of the current varied with changing environmental factors of bicarbonate concentration, pH, and immersion time. The factors also controlled the corrosion rate of the steel. The PSDs were associated with the corrosion rate, and then it was found that the PSDs of the potential and of the current showed linear correlation with the corrosion rate in log-log scale. There was also linear relationship between the corrosion rate and a spectral noise resistance obtained from the PSDs of the potential and the current. The linearities of the three correlations were better at a lower analyzed frequency. Furthermore, the PSDs of the current and the noise resistance indicated more linear correlation with the corrosion rate than that of the potential. As the simplicity of the measurement system is additionally considered, it is concluded that the PSD of the current noise at an analyzed frequency of 3 mHz is the optimum conditions for estimating the corrosion rate from 10⁻² to 10⁰ A m⁻² in this study.     

Precipitation behavior of σ phase in fusion zone of dissimilar stainless steel welds during multi-pass GTAW process

The purpose of this study is to investigate the precipitation characteristics of σ phase in the fusion zone of stainless steel welds at various welding passes during a tungsten are welding (GTAW) process. The morphology, quantity, and chemical composition of the δ-ferrite and σ phase were analyzed using optical microscopy (OM), a ferritscope (FS), a X-ray diffractometer (XRD), scanning electron microscopy (SEM), an electron probe micro-analyzer (EPMA), and a wavelength dispersive spectrometer (WDS), respectively. Massive δ-ferrite was observed in the fusion zone of the first pass welds during welding of dissimilar stainless steels. The σ phase precipitated at the inner δ-ferrite particles and decreased δ-ferrite content during the third pass welding. The σ and δ phases can be stabilized by Si element, which promoted the phase transformation of σ→ϱ+λ₂ in the fusion zone of the third pass welds. It was found that the σ phase was a Fe−Cr−Si intermetallic compound found in the fusion zone of the third pass welds during multi-pass welding.     

佛尔哈德法测定氯化除汞上清液中的氯量

控制pH4-6，用锌粉还原氯化除汞上清液中的汞（Ⅱ）离子，取置换后液加入过量的硝酸银标准溶液，以硫酸铁铵溶液作指示剂，用硫氰酸钾标准滴定溶液滴定来测定氯量。该方法的检出限：0．25mg／100mL，回收率：98％-101％。     

带化学反应的膛口温度场方程分歧解

提出膛口系统是一种准耗散结构，并分析了符合耗散结构的条件，在分析分歧解线性稳定性的基础上，使用高维定态投影解定态分歧解，分歧解与实验结果吻合较好。     

江苏沙河抽水蓄能电站工程上进出水口设计

介绍了江苏沙河抽水蓄能电站上进出水口设计特点,上进水口体型参数的确定,工程处理措施,结构稳定分析和结构计算。     

Effect of chloride ions on immersion plating of copper onto porous silicon from a methanol solution

The effect of chloride ions (Cl⁻) during the immersion plating of copper onto porous silicon (PS) from a methanol (MeOH) solution has been studied. The presence of Cl⁻ in the Cu²⁺ solution was found to slow down the rate of copper deposition, as confirmed by inductively coupled argon plasma emission spectroscopy and X-ray photoelectron spectroscopy measurements. The threshold concentration of Cl⁻ at which the deposition of copper is very severely diminished was found to be 0.1 M. The inhibition effect is discussed on the basis of the rest potential values of PS and polarization curve measurements. They revealed that the rest potential of PS upon dipping in these solutions appears to direct the metal deposition. Current density-potential curves show that at Cl⁻ concentrations higher than 0.1 M, the reduction of Cu ions proceeds in two steps; the reduction of Cu(II) to Cu(I) followed by the reduction of Cu(I) to Cu(0). This suggests that Cu(I) species in MeOH solution can be stable over a certain potential range and this stability of Cu(I) is responsible for the inhibition of metal deposition. Fourier transform infrared spectroscopy and scanning electron microscopy (SEM) were also performed to investigate the structural changes and characterizations of PS samples after the plating process.     

从氯化铅渣中回收铅铋的研究

本文以柿竹园有色金属矿粗铋火法精炼、气化除铅产出的铅渣为原料，在常压下采用氯化钠水溶液进行浸出处理，有效地分离了铅和铋，并将铅制成了化工产品黄丹及硫酸铅     

Performance Characteristics of a Drying Heat Pump Using Superheated Steam

A complete mathematicalhumerical model is proposed, in order to simulate the performance characteristics of a novel concept of a drying heat pump based on the theory of minimum energy cyclcs. The drying heat pump involvcs vapour condensation in a Lava1 nozzle. removal of the liquid phase in a supersonic separator as well as compression of the working medium. which is superheared vapour.