河口水流、波浪、潮流、泥沙、河床变形二维数学模型

根据河口“波浪掀沙，潮流输沙”的泥沙运动机制，引入“波浪幅射应力”反应波浪对水体和泥沙的驱动力．考虑波浪对底部泥沙作用力、波浪对水流挟沙能力的影响及风场对水流和泥沙运动的影响．同时考虑泥沙粒径大小、水体含盐度、含沙量及水流紊动程度等因素对絮凝沉速的影响．用ＡＤＩ算法求解沿水深平均方程，破开算子法解悬移质不平衡输沙方程及河床变形方程，引入通度概念处理岸滩不规则边界，建立河口水流、波浪、潮流、泥沙、河床变形二维数学模型．通过实测资料及卫星摇感图像对所建数学模型进行检验，表明它可以较好地预测河口泥沙的运动     

压电超声微电机混合结构定子的固有频率特性分析

压电超声微电机是依靠定子振动变换能的功率器件，定子性能将直接关系到微电机能否实现，本文采用Ｒａｙｌｅｉｇｈ－Ｒｉｔｚ方法来分析机械中经常采用的多层膜结构（混合结构）定子的固有振动特性，推导中考虑了平面应力和弯曲应力对固有频率的影响，模拟计算和实验结果符合得较好，此外还讨论了定子有关参数对固有频率的影响。     

Measurements of Stress Intensity Factors of an Interface Crack Under Mixed Mode Loading

The optical method of caustics has been utilised to measure both the stress intensity factor for a crack lying along the interface of an aluminium/epoxy bimaterial specimen, and the mode mixity arising from the difference in the elastic properties across the interface. Measurements were carried out by using a novel modification to the method whereby caustics are produced and measured from both sides of the specimen, so compensating automatically for the distortion induced in the specimen due to misaligned loading fixtures. A flat reflective surface across the interface was obtained by adhering a reflective coating to the specimen. Verification that this coating does not affect measurement accuracy was obtained by comparing stress intensity factors measured from coated and uncoated monolithic aluminium specimens where good agreement was found to exist between both measurements.     

Pullout tests of epoxy-coated reinforcement in concrete

The bond strength and slip of epoxy-coated reinforcing bars in concrete have been evaluated by carrying out single pullout and double pullout tests. In extended single pullout tests, slip measurements were made while tensile force was applied to reinforcing bars embedded in concrete. In double pullout tests, 20 cycles of load were applied at levels of steel stress between zero and 0·5 times characteristic steel strength. Strains were measured by electrical resistance strain gauges glued inside the bars. Both epoxy-coated and uncoated bars were used in the investigation, to obtain comparative results. The strain gradient along the bar was found to be less for the coated reinforcement. In general, the epoxy coating was found to increase slip in bond and thereby reduce the bond performance of coated bars.     

滁州市农贸市场超长预应力楼盖的设计分析

滁州市农贸市场超长预应力楼盖温度应力有限元分析及设计原则。     

可压缩体的滑移线场理论

从理论上建立了可压缩体的滑移线场理论，并给出了解析实例。研究表明：在平面应变条件下，可压缩体内的两族滑移线不仅不正交，而且随着平均正应力的不同而变化；可压缩体的平面应变问题可以直接采用现有的致密体的滑移线场来求出。     

徐淮地区煤矿井筒破裂机理研究

从徐淮地区井筒破裂的特点出发，分析引起井壁破裂的根本原因，据此提出井筒的破裂机理，为选择防治井筒破裂的方法提供依据     

Finances and Well-Being: A Dynamic Equilibrium Model of Resources.

This study of 513 Dutch farmers tested a dynamic equilibrium model of resources (an extension of the conservation of resources theory; S. E. Hobfoll, 1989, 1998, 2001). With structural equation modeling, the advantages of a 3-wave longitudinal design were comprehensively used, such as addressing bidirectional causal effects and within-individual vs. between-individual change. This allowed for a careful analysis of the management function of resources in the stress process. Results showed that well-being had stronger within-person stability than finances. Increased levels of financial problems temporarily increased psychological distress but not self-reported illness. Conversely, farmers with higher stable baselines of psychological distress also had higher baselines of self-reported illness and experienced more negative changes in their financial situation. (PsycINFO Database Record (c) 2010 APA, all rights reserved)     

-50℃用20MnMoD钢锻件及其焊接接头性能

研究了-50℃的20MnMoD钢锻件及其焊接接头在不同热处理状态时的综合力学性能。结果表明,-50℃的20MnMoD钢锻件具有良好的低温韧性,可与-50℃级正火型低温压力容器钢15MnNiNbDR配套使用。     

压裂斜井时射孔处雁形裂缝产生及干扰分析

在已射孔的斜井压裂过程中，射孔孔眼处会出现一系列的几乎相互平行的雁形裂缝。这些裂缝的延伸、连接受到地层应力及裂缝本身的影响，情况较为复杂，但它们的延伸和连接对压裂的成功与否至关重要。笔者对裂缝模型进行简化，将复变函数理论与位错理论相结合，并且考虑了裂缝表面有流体压力作用且裂缝之间存在相互干扰的情况下，建立了无限大介质中裂尖应力强度因子的数学模型，利用该模型可对雁型裂缝之间的相互干扰进行力学分析。应用数值方法对所建立的数学模型求解，得到裂尖的应力强度因子及转角，来预测裂缝连接情况。该结果可用来指导压裂井的射孔施工。