利用大流量液压支架控制顶板事故的发生

通过对工作面端面冒顶原因及支护系统的分析得出，加大液压支架的流量可以加快移架速度，降低冒顶事故率，提高生产效率。     

水乳型丙烯酸酯建筑防水胶的研制(Ⅱ)

摘 要 研究水乳型丙烯酸酯建筑防水胶与水泥的配比及共混性能、共混固化物胶膜的力学性能、耐冷热性能及老化性能。     

微重力落塔电磁悬吊、释放技术研究

论述了微重力落塔电磁悬吊、释放、提升机构的关键技术,电磁释放过程的特性分析以及微重力落塔实际试验的情况。分析说明:悬吊、释放性能的好坏决定了试验落舱的微重力水平,也是微重力落塔试验能否成功的关键技术。     

提高特高含水期油藏采收率的方法及应用效果

针对胜索油田二区9-10单元的层间非均质和平面非均质性，运用水动力学方法，采用周期注水及增压注水改善单元的水驱油效果。经过6a的实施，单元的开发形势趋好，单元采收率提高9.62%，增加可采储量341.5kt，对同类型非均质性油藏改善水驱油效果，提高最终采收率具有借鉴意义。     

对氧化物熔体浮区中重力对流的数值模拟

利用有限元分析方法数值模拟了界面形状对氧化物高温熔体碟形浮区中的温度分布和重力对流速率的影响，发现界面形状对重力对流速率有较大的影响，对于凸面，相对于炉圈平面5％的偏离使重力对流速率增大25％，偏离越大，重力对流速度越大，对于凹面，5％的偏离使重力对流速率减小15．7％，偏离越大，重力对流速度越小。     

Differentiation between epigeic and hypogeic fauna in gravel streams

The ‘hyporheic zone’ is described. According to the classical definition, water below the sediment surface is groundwater and the hyporheic interstitial zone is part of the phreatic system. This ignores the vertical distribution of the epigeic benthic fauna. The uppermost layer of the sediment (bed sediments) of the hyporheic zone is dominated by epigeic faunal elements and is therefore part of the surface system. In contrast to hypogeic species, the depth penetration of epigeic species is limited. Possible explanations are discussed.     

改进的FD—TD法分析二维理想导体TM近区散射问题

本文针对一般ＦＤ－ＴＤ方法分析计算二维理想导体散射问题所遇到散射体边角处难以精确处理的缺点进行了改进。将边角处总场近似解析解直接引入ＦＤ－ＴＤ法差分公式，得到了有关修正系数，为了检验此方法的有效性，有无限长导体方柱为例分别用一般ＦＤ－ＴＤ法和本文的ＦＤ－ＴＤ方法进行了分析研究，并与ＭＯＭ法进行了比较，所得结果说明改进后的ＦＤ－ＴＤ方法对分析计算导体边角附近电流分布特性是较有效的。     

全面留矿法采场顶板支护和落矿爆破工艺的研究

本文介绍的接杆锚杆护顶技术和上向眼大孔距多排微差爆破落矿技术，解决了逐昌金矿全面留矿法采矿工艺中存在的采场顶盘围在面积冒落和采场落矿爆破效果差、效率低这两个问题。     

Microstructural transformations of heat affected zones in duplex steel welded joints

The influence of the welding thermal conditions exemplified by heat input and heat treatment after welding on the structure of the heat affected zone (HAZ) UNS S31803 has been analysed. The post weld treatment was used to create the precisely defined thermal conditions for the decomposition of primary phases in the HAZ, by a multi-layer welding thermal cycle stimulation. Detailed analyses of the microstructure and chemical composition of the phases in the different post welded conditions were performed by scanning electron microscopy (SEM) combined with energy dispersive spectrometry (EDS) and transmission electron microscopy (TEM). Three types of secondary precipitates have been observed: secondary austenite (γ₂), carbides: M₂₃C₆ and M₇C₃. The dependence of the secondary austenite volume fraction and morphology in the HAZ on thermal cycle have been interpreted. The eutectoid decomposition of the primary phases in the analysed thermal conditions was confirmed.     

箕状凹陷坡折带成因及对同生断层和沉积的控制,以南襄盆地南阳凹陷为例

坡折带是沉积地貌突变的古构造枢纽带。南襄盆地南阳凹陷南部控凹铲状正断层在非平面上滑动造成凹陷北部盖层缓坡弯折,构成盆内沉积区域的分界线,是同生断层集中发育和沉积相发生突变的地带。特定的坡折带类型揭示了同沉积断裂的活动和分布特征,制约着沉积物的分散过程和砂体堆积。在不同的盆地演化阶段,同生断层与沉积相带控制着不同圈闭类型的形成。