气相法聚乙烯BCG-Ⅱ型催化剂的开发和应用

对气相法聚乙烯BCG-Ⅱ型催化剂的组成、粒径分布及催化剂的淤浆聚合性能进行了研究。研究结果表明，BCG—Ⅱ型催化剂的活性较高，聚合物堆密度适中，应用在Unipol乙烯气相聚合工艺装置上操作良好，所生产的树脂颗粒均匀。干爽且流动性好，产品质量合格、稳定。     

美国能源部的浆态床F－T合成技术

浆态床Ｆ－Ｔ合成技术是美国能源部Ｆ－Ｔ合成技术的主要开发项目。本文就浆态相Ｆ－Ｔ合成催化剂的开发、中试示范实验和浆态反应器的化工基础研究作一扼要的介绍。     

隔膜电解制备Mn^3＋的研究

对电解媒质ＭｎＳＯ４在有隔膜条件下电解制备Ｍｎ３＋过程进行了研究。结果表明，无论均相还是非均相隔膜电解，在常温２０℃、４０％Ｈ２ＳＯ４介质中，当电流密度、ＭｎＳＯ４浓度、电解时间在很宽的范围变动时，电流效率保持很高，至少在８５％以上。     

无隔膜槽中ACF电极成对电解脱色活性艳蓝KN-R

采用恒电流模式,同时以活性炭纤维(ACF)为阳极和阴极,在无隔膜电解槽中研究了不同电流密度下蒽醌染料活性艳蓝KN-R的电化学脱色。结果表明在1.0~1.5mA.cm-2时,电解槽中发生阳极电氧化和阴极电还原同时进行的成对电解脱色。成对电解的发生,可以提高电解槽的工作处理能力。当电流密度为1.1mA.cm-2时,脱色率达到87%。     

油田废水电解杀菌研究

采用电解杀菌技术处理油田废水，研究了电解时间、电流强度、极板间距以及电极联结方式等因素对废水中硫酸盐还原菌杀灭效果的影响。结果表明，油田废水经3min电解杀菌，硫酸盐还原菌杀灭率高达99．90％。随着电解时间的增加，硫酸盐还原菌的杀菌率进一步提高；电流强度增加，硫酸盐还原菌的杀灭率升高。在电流强度保持不变的情况下，随着极板间距增加，极板之间电压升高，更有利于杀灭硫酸盐还原菌。在极板间电流强度相同的条件下，两种电极联结方式的杀菌率差别不大，杀菌率均在99．9％以上。     

New analysis of non-newtonian turbulent flowndashyield-power-law fluids

The writers' new analysis of non-Newtonian turbulent flow is extended to the yield-power-law model. As the value of the exponent of the yield-power law decreases from unity, the calculated friction factor begins by converging toward the Newtonian line at high velocity, then parallels it, and finally diverges downward. This prediction agrees with previously unexplained experimental results.     

A Fully Continuous Supercritical Fluid Extraction System for Contaminated Soil

A fully continuous lab scale supercritical fluid extraction system has been designed, built and tested. The system continuously pumps carbon dioxide under supercritical conditions and soil slurry into a counter‐current contacting column. Delhi Loamy Sand, spiked with approximately 10 mg/g of naphthalene, was used as the testing soil. The soil slurry ranged from 0.0028 g dry soil per g slurry to 0.072 g/g. The operating temperature was 43°C and the operating pressure was 7.7 MPa. Near steady state, fully continuous flow was achieved with runs lasting as long as 2 h. All carbon dioxide samples contained measurable quantities of naphthalene and the measured mass transfer coefficients were as high as 4.6×10^?4 s^?1.     

泥磷回收制磷危险性分析与防治

泥磷回收制磷属于化学危险品生产,由于黄磷本身的易燃特性和生产中其他因素的诱导,极容易发生泄漏引发火灾和灼伤。介绍了泥磷的产生和泥磷回收制磷的工艺特点。应用系统安全工程的原理和方法,辨识了泥磷回收制磷生产的潜在危险性;辨识了泥磷回收制磷生产过程中的物质危险性、装置危险性和工艺危险性。运用预先危险性分析法（PHA）对泥磷回收制磷的主要危险、有害因素进行分类和分级。根据对主要危险、有害因素分类和分级的结果,提出技术措施和管理措施来提高企业安全生产管理水平和预防生产性事故的发生。     

堆场疏浚泥颗粒分选特性初步量化方法

为了准确评估堆场存储能力和合理选择疏浚泥处理工艺,以泥沙运动学为理论基础,将疏浚泥颗粒分为d0.005 mm、0.005 mm≤d≤0.01 mm和d0.01 mm 3个粒组,分析了各粒组相对含量的沿程变化规律,明确了堆场疏浚泥分选的主要原因是d0.01 mm粒组与0.005 mm≤d≤0.01 mm粒组的相对运动;以分选系数量化堆场疏浚泥分选的显著程度,以偏离系数量化原泥颗粒组成对堆场疏浚泥分选的影响,分析了分选系数、偏离系数分布与堆场疏浚泥土性分布的关系,提出了堆场疏浚泥分选特性的初步量化方法。研究结果表明:随着离吹填口距离的增大,分选系数沿程减小,呈幂函数分布,堆场疏浚泥分选性沿程减弱,吹填口附近分选系数最大,颗粒分选显著,粒度差异大,退水口附近分选系数趋近于零,分选不明显,颗粒分布均匀;偏离系数沿程先减小后增大,呈勺形分布,反映堆场前、后段疏浚泥土性与原泥相差较大,而堆场中段疏浚泥土性与原泥接近;分选系数、偏离系数的沿程分布与堆场疏浚泥土性分区具有良好的相关性。     

Absorption of carbon dioxide in alkanolamines in the presence of fine activated carbon particles

The rates of absorption of CO₂ into water and 0.1 kmol/m³ aqueous solutions of MEA, DEA and AMP were measured in a stirred cell with a flat gas-liquid interface in the presence of fine activated carbon particles. Experiments showed that the rates of absorption increased significantly with increases in the loading of activated carbon up to about 6 kg/m³ and thereafter remained constant.