新型超微晶软磁合金FePCCuMoSi微观结构缺陷的正电子湮没研究

用正电子湮没方法研究了新型超微晶软磁合金的微观结构缺陷，样品选用的是在不同温度下退火的Ｆｅ８１Ｐ１２Ｃ３Ｃｕ１Ｍｏ０．５Ｓｉ２．５合金，结果表明，合金的微观结构构陷大小，密度随退火温度有规律地变化，这种现象可能与非晶的晶化过程有关。     

Modelling aerodynamic sound in the airways of a human body: A possible diagnostic tool

The sound generated aerodynamically by a pillow-like body simulating an obstacle in the human airway is observed through a soft wall from outside the duct. It is intended to provide a physical basis for an attempted medical diagnostic technique for detecting an obstacle by observing the sound during breathing. So far at least two kinds of sound have been identified: One is sound of the half-jet flow formed downstream of the obstacle, and the other is sound due to unsteady motion of the separation point on the curved surface of the obstacle. For simulating the flow condition downstream of the vocal cords during inhalation, cases with an obstacle at various positions relative to a jet flow are also examined. In this case, the sound due to the downstream obstacle exhibits a complicated dependence on the geometry and flow parameters. Nevertheless, increase in the sound, or more correctly, deformation in the sound power spectrum, due to the presence of an obstacle is detectable from outside, opening up possibilities of its use as a diagnostic aid. Dedicated to the late Professor Itiro Tani on the occasion of 5ACFM, Taejon, Korea     

Fe73.5Cu1Nb3Si13.5B9非晶合金的晶化动力学

用ＤＴＡ结合ＸＲＤ了Ｆｅ７３．５Ｃｕ１Ｎｂ３Ｓｉ１３．５Ｂ９晶合金的晶化动力学。表明，该事金在５００℃时析出α－Ｆｅ（Ｓｉ）相。晶化初期激活能最小为２４２ｋＪ／ｍｏｌ，它随晶化量的增加，在ＸＣ为０．４－０．８时，呈极大值为５２０ｋＪ／ｍｏｌ。在６２４℃时析出Ｆｅ２Ｂ相。     

AN EXPERIMENTAL AND NUMERICAL INVESTIGATION OF THE STARTING FLOW OF A UNIFORMLY ACCELERATING CIRCULAR CYLIINDER

The starting flow around a uniformly accelerated circular cylinder is investigatedby flow visualization techncque and solving N-S equations numerically in detail.The results ofthe starting flow are similar with those of the impulsively started one.At lower Re_α,numbers the“phenomenon a”is revealed;the“phenomenon β”appears at higher Re_α numbers,but withonly one secondary vortex.At the early stage of the starting vortex formation,the flow islaminar;at the later stage,the flow transforms into turbulent flow.The velocity distribution inthe flow field is measured with the multiwires installment.The calculational results are comparedwith the results of experiment,and both are in agreement with each other.     

核桃软糖的防粘结研究

主要针对核桃软糖在气温稍高、湿度较大的环境中容易粘结，造成质量下降和贮藏期缩短的现象，通过改进配方和工艺，防止和延缓核桃软糖粘结，延长了产品的贮藏时间。     

计算机软件在多媒体化学教育中的应用

本文阐述了计算机软件在多媒体化学课件开发中的应用，着重介绍了一些普通软件及专业化学软件的特点及功能。     

“三软”煤层综放面特殊情况下支架拆除及沿空留巷

超化煤矿21091(西)综采工作面因出水造成工作面停产,在不超前15 m铺金属网的情况下进行支架拆除,并把原工作面留做炮采面切巷。根据实际情况制定了施工方案,并介绍了实施情况。     

垫层载荷试验应注意的几个问题

介绍了垫层上载荷试验的类型，通过工程实例对不同类型垫层上的载荷试验应注意的问题进行了分析和探讨，这对通过载荷试验确定双层地基承载力具有一定的实际意义，可供同类工程参考借鉴。     

三相异步电动机运行指标的分析

利用电机学理论分析了影响电机起动转矩、起动电流、最大转矩和最小转矩的因素。     

形状记忆聚氨酯的结构与性能研究

以 2 ,4 -甲苯二异氰酸酯 (2 ,4 -TDI)、不同分子量的聚己二酸丁二醇酯 (PBAG)和 1,4-丁二醇 (BDO)为原料合成了具有形状记忆功能的聚氨酯材料。通过DSC、弯曲实验和力学实验 ,研究了形状记忆聚氨酯的性能 ,发现软段高度结晶和硬段聚集形成硬段微区是其具有较好形状记忆性能的必要条件。