卫星编队飞行中的队形设计研究

目前关于卫星编队飞行的研究有显著的增加。多颗从属卫星(从星)在近距离内与主卫星(主星)组成特定的队形以完成相应的任务,是卫星编队飞行的特点及潜在优势。卫星在编队飞行时,其队形定义为以各颗卫星质心为顶点所构成的几何形状,而队形设计则是根据队形的几何形状求出各卫星的轨道根数(其中主星的轨道根数可以根据任务的要求事先确定)。基于相对轨道根数法,根据卫星相对运动方程,提出了“自然队形”的概念及队形设计的一般方法,并给出了具体的例子。     

A numerical model for induction heating processes coupling electromagnetism and thermomechanics

This paper presents a mathematical and numerical model developed for coupling the various physical phenomena (electromagnetic, thermal and mechanical) taking place in axisymmetrical induction heating processes. All three electromagnetic, thermal and mechanical models are time dependent and take full account of the electromagnetic and thermal non‐linear effect especially with magnetic materials. The electromagnetic problem is discretized and solved in the workpiece, air and inductors. The heat transfer equation and the mechanical equilibrium equations are solved in the workpiece only, both using a finite element method. The mechanical model can take into account thermoelastic–plastic behaviour for the part. The model has been successfully applied to several cases of induction heating. Comparisons between numerical and experimental results show an excellent agreement. Copyright © 2003 John Wiley & Sons, Ltd.     

Reduction of low-frequency pressure fluctuations in wind tunnels

The determination of dynamic wind loads on buildings, i.e. pressure and deflection, has gained increasing interest (European Prestandard ENV 1991-2-4, Eurocode 1: basis of design and actions on structures—Part 2-4: actions on structures—wind actions, European Committe for Standardization, Brussels, 1995; DIN 1055 Teil 4 Lastannahmen für Bauten, Verkehrslasten, Windlasten bei nicht schwingungsanfälligen Bauwerken, 1991; N. Hölscher, M. Hortmanns, J. Sahlem, Praxisnahe Erfassung von Windwirkung an Industrie- und Hochbauten, Windwirkung im Bauwesen, Braunschweig, 7, Dreiländertagung D-A-CH 2001, Windtechnologische Gesselschaft, 2001 [1], [2] and [3]). Therefore, the spectral distributions of velocity and pressure fluctuations in wind tunnels are an important quality aspect. While velocity fluctuations can be manipulated by the obstacles used to create the turbulence, pressure fluctuations are influenced by acoustic noise as well. Especially, the first eigenfrequency of the longitudinal mode of the wind tunnel tends to disturb the pressure spectrum.In this paper, a solution for the reduction of low-frequency acoustic pressure fluctuation is presented and its application in the atmospheric boundary layer wind tunnel at the IAG is shown.     

Determination of Boundary Shear Stress and Reynolds Shear Stress in Smooth Rectangular Channel Flows

A method for computing three-dimensional Reynolds shear stresses and boundary shear stress distribution in smooth rectangular channels is developed by applying an order of magnitude analysis to integrate the Reynolds equations. A simplified relationship between the lateral and vertical terms is hypothesized for which the Reynolds equations become solvable. This relationship has the form of a power law with an exponent of n = 1, 2, or infinity. The semiempirical equations for the boundary shear distribution and the distribution of Reynolds shear stresses are compared with measured data in open channels. The power-law exponent of 2 gave the best overall results while n=infinity gave good results near the boundary.     

Trace element evaporation during coal gasification based on a thermodynamic equilibrium calculation approach

Thermodynamic equilibrium calculations using the HSC-Chemistry program were performed to determine the distribution and mode of occurrence of potentially toxic and corrosive trace elements in gases from coal gasification processes. The influence of temperature, pressure and gas atmospheres on equilibrium composition was evaluated. In these reducing conditions, the behaviour of the trace elements is complex, but some form of organization can be attempted. Elements were classified into three groups. Group A includes those elements that, according to thermodynamic data at equilibrium, could probably be condensed in coal gasification. Mn is classified in this group. Group B contains those elements that could be totally or partially in gas phase in gas cleaning conditions, and can be divided into two subgroups, depending on whether the cleaning conditions are hot or cold. Co, Be, Sb, As, Cd, Pb, Zn, Ni, V, Cr are elements in this group. Group C contains those elements that could be totally in gas phase in all the possible conditions, including flue gas emissions. Se, Hg and B are the elements that make up this group.     

Investigation of Boundary Shear Stress and Pollutant Detachment from Impervious Surface during Simulated Urban Storm Runoff

Pollutant detachment rates have been determined for four chloride salts during simulated urban storm runoff. Under rainfall and/or overland flow conditions, chloride mass flux was measured and related to boundary shear stress of the test surface. Washoff coefficients, presumed to depend only on pollutant characteristics, were computed based on the slopes of dimensionless mass flux versus dimensionless time plots. Washoff coefficients were found to vary among and between the chloride compounds studied. In general, higher overland flow rates produced lower boundary shear and lower washoff coefficients. The combination of simulated rainfall and overland flow resulted in an increased boundary shear and an increased washoff coefficient. An empirical washoff coefficient based on a load characteristic curve derived from an exponential washoff relationship was also computed from the runoff data and compared with the previous washoff coefficient. A linear correlation between these two washoff coefficients was observed. The magnitude of the latter coefficient under simulated rainfall was consistent with reported values obtained from field data.     

金属材料中的稀土元素

本文论述了俄罗斯对稀土元素在高强度钢、高温合金、铝合金、镁合金、粉末冶金和磁性材料中的应用及其发展。     

Restricted overlapping balancing domain decomposition methods and restricted coarse problems for the Helmholtz problem

Overlapping balancing domain decomposition methods and their combination with restricted additive Schwarz methods are proposed for the Helmholtz equation. These new methods also extend previous work on non-overlapping balancing domain decomposition methods toward simplifying their coarse problems and local solvers. They also extend restricted Schwarz methods, originally designed to overlapping domain decomposition and Dirichlet local solvers, to the case of non-overlapping domain decomposition and/or Neumann and Sommerfeld local solvers. Finally, we introduce coarse spaces based on partitions of unity and planes waves, and show how oblique projection coarse problems can be designed from restricted additive Schwarz methods. Numerical tests are presented.     

Study of trace elements in coal and mining wastes and its significance in China

In the world energy about 26% of all was dedved from coal combustion. Nearly 80% of the electricity produced in China is generated from coal. Coal will play the most important role in the coming 50 years as the past century in China. However one consequentially of the mining and combustion of coal is the mobilization of trace elements, especially trace metals, which have environmental and human health significance. Information on concentrations and distributions of potentially toxic elements in coal, and information On the modes of occurrence of these elements and the relations of the minerals in coal can help to predict the behavior of the potentially toxic trace metals dudng cleaning, combustion, weathering, and leaching.     

FEM model of the ohmic resistance of IP-SOFCs

In the present work, the ohmic resistance of an integrated planar-SOFC (IP-SOFC) has been evaluated by developing a model whose equations have been solved numerically through an FEM method. The model allows to estimate the distribution of voltage and current density in the cell. A comparison between simulated and experimental data of area specific resistance is reported, which shows satisfactory agreement. The mathematical model has also been used to carry out some parametric studies for optimisation purposes. Indeed, a reduction in cell pitch length and an increase in electrode thickness are predicted to lead to a reduction in ohmic losses in IP-SOFCs.