HPP－1型皮革加脂剂的研制和应用

本文概述了以磷酸化蓖麻油和羟化磷脂为基础的皮革加脂剂的研制，讨论了合成反应、产品配伍、应用试验等工艺过程。     

钢铁表面锌系磷化膜的研究

本文采用ＳＥＭ和ＴＥＭ等测试手段，研究了四功能处理液不同条件下在钢铁表面上形成锌系磷化膜的形貌，晶体结构；采用ＥＤＳ研究了磷化膜的化学成发，通过实验确定了Ｚｎ／Ｐ值在２．１２～３．２０时，磷化膜具有良好的耐蚀性。     

磷酸异戊酯萃取U,Np,Pu性能的研究

测定磷酸异戊酯（ＴｉＡＰ）对Ｕ（Ⅵ）、Ｎｐ（Ⅳ）、Ｎｐ（Ⅴ）、Ｎｐ（Ⅵ）、Ｐｕ（Ⅳ）和Ｐｕ（Ⅲ）的萃取性能及对Ｔｈ（代替Ｐｕ）的萃取容量。研究了二乙三胺五乙酸（ＤＴＰＡ）络合剂对上述核素形成配合物的条件。结果表明，在用ＴＢＰ和ＴｉＡＰ作萃取剂时，可用ＤＴＰＡ络合Ｎｐ（Ⅵ）、Ｐｕ（Ⅲ）．从而改善乏燃料后处理中Ｕ产品对Ｎｐ、Ｐｕ和Ｐｕ产品对Ｎｐ的去污。     

用铸造废砂制备磷酸盐泡沫陶瓷的研究

以经过活化处理后的铸造废砂为主要原料，以磷酸和磷酸盐为发泡固化剂，再配以必要的添加剂，通过混合搅拌、浇注成型、烧结强化工艺制造的磷酸盐泡沫陶瓷具有高强和多孔特征。研究表明：影响材料性能的主要因素有废砂活性、磷酸、添加剂、烧结工艺以及混合料中的铝硅比等。技术经济分析表明了这项工艺技术具有废物利用量大．生产过程简单，产品用途广泛，对铸造行业的废弃物资源化具有积极意义。     

Effects of substituted aromatic heterocyclic phosphate salts on properties,crystallization, and melting behaviors of isotactic polypropylene

Nucleation effects of 2,2′‐methylene‐bis (4,6‐di‐tert‐butylphenyl) phosphate metal salts as a nucleating agent for isotactic polypropylene (iPP) were investigated with differential scanning calorimeter and polarized optical microscope, and their effects on mechanical, optical, and heat resistance properties of iPP were also studied. The results showed that monovalent metal salts of substituted aromatic heterocyclic phosphate such as sodium salt, lithium salt, and potassium salt had a good performance. With 0.2 wt % of sodium salt, lithium salt, or potassium salt incorporated into iPP, the crystallization peak temperature of iPP could be increased by 13.5, 13.6, and 15.0°C, respectively; the mass fraction of crystallinity of iPP could be increased by about 5%; and crystallization rate was enhanced increasingly. Meanwhile the tensile strength and flexural modulus of iPP could be increased by about 10 and 30%, respectively, and the clarity and heat distortion temperature of iPP could also be improved significantly. But bivalent and trivalent metal salts of substituted aromatic heterocyclic phosphate had little effect on properties of iPP. Meanwhile the morphology study showed that the addition of monovalent sodium salt could decrease the spherulite size of iPP significantly. © 2006 Wiley Periodicals, Inc. J Appl Polym Sci 100: 4868–4874, 2006     

饲料级磷酸氢钙标准样品的研制

简述了饲料级磷酸氢钙标准样品的研制过程，并对样品作了稳定性试验，对搅拌设备的搅拌均匀性和物料的均匀性进行了测定，并由国家认可实验室进行了定值数据的监测。通过对比实验证明了国家实验室之间的无差异性。实验数据表明了所测定的饲料级磷酸氢钙产品是稳定和均匀的，同时简要介绍标准样品的研制程序，为开发其他化工行业标准样品奠定了基础。     

Different effects of tri(acryloyloxyethyl) phosphate on the thermal degradation of photopolymerized epoxy acrylate and polyurethane acrylate films

Tri(acryloyloxyethyl) phosphate (TAEP) was blended in different ratios with epoxy acrylate EB600 and polyurethane acrylate EB270 to obtain a series of UV curable flame retardant resins. The thermal degradation mechanisms of their cured films in air were studied by thermogravimetric analysis, in situ Fourier‐transform infrared spectroscopy, and direct pyrolysis/mass spectrometry measurements. The results showed that the phosphate group in TAEP first degraded to form poly(phosphoric acid) before the degradation of EB600. Then, the formed poly(phosphoric acid) effectively promoted the conversion of EB600 to form char, which prevented the sample from further burning. However, urethane group in EB270 degraded simultaneously with phosphate group in TAEP, leading to not effectively increase the conversion of EB270 to char during the thermal degradation. It was thus found that the addition of TAEP more effectively improved the thermal stability, flame retardance, and the char yield during combustion of EB600 than those of EB270. © 2006 Wiley Periodicals, Inc. J Appl Polym Sci 99: 3130–3137, 2006     

六铝酸钙材料的合成及其显微结构研究

分别采用轻质碳酸钙和活性氧化铝 ,或纯铝酸钙水泥和活性氧化铝为初始原料 ,反应烧结合成了六铝酸钙 (CA6)材料 ,研究了原料和成型压力对合成材料的烧结性能和显微结构的影响 ,同时借助于XRD、TG -DSC、SEM和EDAX等测试手段对其反应过程、物相变化和显微结构进行了分析和观察。研究结果表明 :(1) 130 0℃时 ,合成材料的主晶相为刚玉相和CA2 ,并开始有CA6形成 ;温度升至14 0 0℃ ,CA6大量生成 ;15 0 0℃时反应完成 ,产物全部为CA6相。 130 0～ 15 0 0℃时 ,上述反应表现为体积膨胀过程 ,试样的体积密度和径向线收缩率随温度的变化不大 ;而高于 15 0 0℃时 ,试样明显趋向烧结 ,体积密度升高 ,线收缩率加大。采用纯铝酸钙水泥和活性氧化铝合成的试样的体积密度均高于采用轻质CaCO3 和活性氧化铝的 ,尤其在烧成温度高于 15 0 0℃时。坯体的成型压力对这两种合成试样的烧结性能均没有显著影响。 (2 )合成六铝酸钙材料的晶粒形貌与合成工艺有关 ,制备片状晶粒的六铝酸钙材料需满足两个条件 :一是晶核有足够的发育空间 ,二是从晶核生长形成片状结构需足够的物质扩散。采用纯铝酸钙水泥和活性氧化铝为原料的试样 ,其CA6晶核很容易发育成片状晶形 ,且随着坯体成型压力的增加 ,片状CA6有向等轴状发展的趋势 ;采用     

Simulation of Fe-Al compounds developed during single superphosphate manufacture

In order to analyse iron phosphate complexes and gel-like phases encountered in the single superphosphate process, experiments were performed with a free-Al, Fe apatite crystal of Durango from Mexico phosphate rock and sulfuric acid. Reaction products were studied by X-ray diffraction and surface analysis methods namely X-ray photoelectron spectroscopy and scanning electron microscopy. Results show that in a free Al, Fe-system, part of the Ca(H₂PO₄ )₂.H₂O (MCPM) forms before precipitation of any CaSO₄(CS) and gel-like phase such H₂SO₄.yH₃PO₄.xH₂O is formed. When iron is added, the precipitation rate of (CS) and (MCPM) increases and Fe₃(H₃O)H₈(PO₄)₆.6H₂O is formed. When Fe and Al are added, a gel-like phase is quickly formed with a molar ratio that changes with time and develops into crystalline compounds. The composition of this gel may be represented as a mixture of two phases: H₂SO₄.yH₃PO₄.xH₂O and a gel containing Al-Fe-Si.     

有广阔市场前景的化工产品—过氧化钙

本文叙述过氧化钙的性质,并以实例说明过氧比钙在水产养殖、食品加上、果蔬保鲜。环境保护、农作物栽培、橡胶及化工等奋方面的应用。