保偏光纤偏振主轴准直方法研究

本文利用信号分析的方法,对保偏光纤主轴位置进行计算和讨论,提出一种准直方法,该方法能适应不同种类保偏光纤的偏振主轴的准直。     

延迟器级联型偏振控制器算法研究

利用邦加球图示法,推导了45°-0°-45°型偏振控制器的算法,得到偏振态变换时延迟量对应的计算公式。通过仿真对该算法进行验证,仿真结果表明:不论输入椭圆偏振光,线偏振光还是圆偏振光,该算法得到的输出偏振态与期望得到的输出偏振态一致,证明了该算法的合理性。     

对SEL-351A继电器方向元件的认识

通过对SEL-351A的零（负）序方向元件分别在接地方向、相间故障方向及三相短路故障方向的理论分析,结合电测试数据阐述了对SEL-351A继电器方向元件的认识。     

基于核函数的多极化HRRP识别

针对多极化雷达高分辨距离像(HRRP)识别中数据量大、分布复杂和识别算法复杂的问题,提出了基于核函数的识别方法.该方法首先定义了两种基于多极化HRRP的核函数,然后将其分别应用到核主分量分析(KPCA)中降维和提取特征,最后采用最近邻(1NN)分类器和支持矢量机(SVM)分类器对目标进行分类.该方法可以在不丢失极化信息的情况下,将多极化HRRP作为一个整体进行识别,降低了识别算法的复杂度.多极化HRRP数据的仿真实验结果显示,该方法的识别率比单极化HRRP提高7%～10%;与其他多极化HRRP识别方法相比,该方法不仅降低了提取特征的维数,而且还提高了识别性能.     

A low‐profile antenna with circularly polarized reconfigurable and omnidirectional radiation patterns

A low profile circularly polarized (CP) antenna with reconfigurable polarization is designed and presented, which can radiate omnidirectional patterns that can be switched between left‐hand circularly polarized (LHCP) and right‐hand circularly polarized (RHCP). A pair of arc‐shaped complementary dipoles is acted as reconfigurable elements by bridging four pin diodes at the dipole arced arms. A meander phase shift line is employed to connected the arc dipole arms and plate cavity to adjust the phase relationship of two sources. The proposed antenna exhibits the omnidirectional radiation pattern by combining six identical elements placed in a circular array configuration. 24 p‐i‐n diodes are exploited to six elements, by manipulating the dc bias voltage across the diodes, the polarization state of the antenna can be switched. The patterns of the antenna are similar to that of a dipole, but its size is only about Φ0.87 × 0.029λ₀ at 5.8 GHz. The overlapped bandwidth of measured 3‐dB axial ratio (AR) and 10‐dB return loss is 5.724‐5.87 and 5.738‐5.91 GHz for two polarization states, which are right on the target of ISM band. It can be well adapted to medical diagnosis systems.     

给水球墨铸铁管腐蚀特性及腐蚀对水质的影响

为研究给水球墨铸铁管腐蚀特性及腐蚀对水质的影响,以球墨铸铁管为主体制作三电极反应体系,以微生物为控制变量利用电化学工作站测定球墨铸铁管电化学腐蚀参数,同时分析腐蚀体系内水体水质变化.结果表明:非灭菌组自腐蚀电位66 d均值-0.515 V,自腐蚀电流密度均值7.61×10-4m A/cm~2,期间水质迅速变差,总铁质量浓度3 d后超标,色度和浊度最终分别达72、115 NTU.灭菌组自腐蚀电位66 d均值-0.471 V,自腐蚀电流密度均值5.26×10-4m A/cm~2,腐蚀强度较灭菌组稍缓,但水体最终变成"黄水".没有或失去防腐涂层而暴露于水体中的给水球墨铸铁管初期极易发生以电化学腐蚀为主的综合性腐蚀,严重影响水质.     

开口谐振环结构负折射率材料对电磁波偏振特性的影响研究

电磁波在经过负折射率材料以后,偏振状态会有所改变.对开口谐振环电磁响应特性了解的基础上,采用时域有限积分方法,分别研究了方形、六边形和圆形开口谐振环负折射率材料在不同频率处以及斜入射时对电磁波偏振特性的影响.仿真结果表明,不同的结构、频率和入射角度,电磁波偏振翻转的程度有所不同.研究结果可为电磁波偏振状态的调控提供一定的理论依据和借鉴.     

光纤熔融拉锥中拉力控制方法与电磁力仿真

针对保偏光纤耦合器熔融拉锥制造过程中拉力控制问题,提出一种新的计算机在线拉力控制方法.拉力控制系统由计算机、拉伸机构、圆光栅及控制电路组成,通过检测光纤支架的旋转角度、改变线圈中的电流,控制永磁铁与线圈间的电磁力,实现对拉伸力的实时控制.分析电磁力和拉力的关系,建立永磁铁和线圈的三维有限元模型,确定永磁铁的运动轨迹,并对通电线圈的磁场分布和电磁力进行仿真,得到线圈中的电流、支架旋转角度和拉力的关系式.仿真结果表明拉力控制良好,控制误差约为1.03%.     

PolSAR快速贝叶斯非局部均值相干斑抑制方法

从单极化合成孔径雷达(SAR)贝叶斯非局部均值算法出发,推导了极化相干矩阵在复Wishart分布下的块相似性度量函数,给出了无先验知识下的极化SAR贝叶斯非局部均值模型,并采用积分图实现了该算法的快速计算.最后,通过机载合成孔径雷达实测旧金山地区的极化SAR数据进行了验证.实验结果表明,文中方法能够有效抑制相干斑的同时,保持了极化特征,并大幅提升了运算效率.     

Effects of Al and Sn on electrochemical properties of Mg-6%Al-1%Sn （mass fraction） magnesium alloy as anode in 3.5%NaCl solution

Mg-6%Al-1%Sn（mass fraction） alloy is a newly developed anode material for seawater activated batteries. The electrochemical properties of Mg-1%Sn, Mg-6%Al and Mg-6%Al-1%Sn alloys are measured by galvanostatic and potentiodynamic tests. Scanning electron microscopy（SEM） with energy dispersive spectrometry（EDS） is used to characterize the microstructures of the experimental alloys. The results show that the Mg-6%Al-1%Sn alloy obtains more negative discharge potential（-1.38 V（vs SCE）） in hot-rolled condition. This is attributed to the fine dynamically recrystallized grains during the hot rolling process. After the experimental alloys are annealed at 473 K for 1 h, the discharge potentials of Mg-6%Al-1%Sn alloy are more negative than those of Mg-6%Al alloy under different current densities. After annealing at 673 K, the discharge potentials of Mg-6%Al-1%Sn alloy become more positive than those of Mg-6%Al alloy. Such phenomenon is due to the coarse grains and the second phase Mg2 Sn. The discharge potentials of Mg-1%Sn shift positively obviously in the discharge process compared with Mg-6%Al-1%Sn alloy. This is due to the corrosion products pasting on the discharge surface, which leads to anode polarization.