Fast determination of critical eluent composition for polymers by gradient chromatography

Gradient chromatography was applied in order to calculate the composition at elution for different methacrylates on normal phase columns. In addition the composition at elution was determined for polyethyleneoxide on a reverse phase column. It is shown that high molar mass polymers elute for a given homopolymer irrespective of their molar mass at the same eluent composition, which varies only slightly with gradient slope. In general the composition at elution in gradient chromatography is expected to be slightly lower than the true critical composition. For high molar mass polymers we found this composition to be close to the critical composition determined by isocratic experiments. The difference between the composition at elution and the true critical composition for a variety of polymethacrylates and for polyethyleneglycol was found to be only between 0.2 and 5%. Thus, after estimating the composition at elution, only a small number of additional isocratic experiments is needed to find the exact critical composition.     

Structural and Superconducting Property Variations with Nominal Mg Non‐Stoichiometry in MgxB2 and Its Enhancement of Upper Critical Field

By applying a combination of characterisation tools, changes in structural and superconducting properties with nominal Mg non‐stoichiometry in Mg_xB₂ are found. The non‐stoichiometry produces enhanced in‐field critical current densities (J_c's) and upper critical field / irreversibility field (H_c2/H_irr(T)) values. Upper critical fields of ～ 21 T (4.2 K) were obtained in nominal Mg‐deficient samples compared to ～ 17 T (4.2 K) for near‐stoichiometric samples.     

液晶光阀光电导层光吸收系数的研究

用化学气相沉积法制备了液晶光阀中光电导层———非晶硅薄膜,从实验中得出最佳制备工艺的参数取值。给出了用包络线法测量非晶硅薄膜光吸收系数的原理,测量了样品的光吸收系数随波长的变化规律。得到样品在最佳工艺条件下的光吸收系数高于1×103cm-1。     

Experimental Research on Erbium-doped Superfluorescent Fiber Source

The effects of the variations in fiber length, fiber mirror reflectance on efficiency and output power are experimentally investigated for erbium-doped double pass backward superfluorescent fiber sources (SFSs). The influence of fiber length on mean wavelength stability (MWS) has also been demonstrated. By incorporating a short section of un-pumped erbium-doped fiber (EDF) at the output port, the pump power dependent on MWS becomes independent of pumped EDF length. This is a novel phenomenon that hasn‘t been reported up to now,and should be helpful to SFS fabrication and theory analysis. By using a fiber Michelson interferometer as spectrum slicing component,a multi-wavelength fiber source (MWFS) with ～20 channels (from 1542nm to 1559nm) is got. The MWFS has a channel spacing of ～0. 8 nm which satisfies ITUstandard. The intensity fluctuation among channels is less than 0.5dB,and the extinction ratio of all channels is above 14dB. This kind of MWFS should be useful to wavelength division multiplexing systems.     

Ability of a contactless inductive device for the characterization of the critical current versus temperature in superconducting rings at temperatures close to TC

Critical current measurements for three polycrystalline rings of YBCO, three Bi-2223, and one YBCO + Ag were developed from a temperature close to 80 K to the critical temperature using a previously reported contactless inductive device based on the transformer method. These data were used to analyze the ability of this device to characterize, in superconducting rings, the Ginzburg-Landau, Ambegaokar-Baratoff, and De Gennes regimes as well as the crossover temperature between them.     

Critical heat flux on a flat plate heater located at the middle of a duct in forced flow of pressurized He II

Critical heat fluxes (CHFs) were measured for two types of rectangular ducts containing horizontal flat plate heaters. One has the flat plate heater of 6 mm wide and 20 mm long located on the inner lower wall at 50 mm from the inlet. The other duct has two horizontal flat plates of 6 mm wide and 20 mm long on inner upper and lower walls at 50 mm from the inlet. The equation of CHF for the forced convection containing a new nondimensional-parameter m introduced in order to calculate cross-sectionally averaged liquid temperature at the center of the duct was derived based on two fluid model, ordinary convection theorem and experimental results. It was confirmed that this correlation can describe not only the author's data on the duct but also other worker's data for channels with different shapes and sizes.     

Reliability Analysis of Single-Degree-of-Freedom Elastoplastic Systems. II: Suboptimal Excitations

A method for constructing an approximation of the critical excitation that drives an elastoplastic system from rest to a target threshold at a specified time instant, referred to as the “suboptimal excitation,” is presented in this paper. It is based on the observations gained from study of the critical excitations in the companion paper. Essentially, for the usual case of interest where the failure time is not small compared to the natural period, the duration of the positive and negative pulses of the critical excitation are roughly equal to half of the natural period. This consideration allows for a simple intuitive approximation of the critical excitation. The amplitudes of the positive and negative pulses are obtained in closed forms using energy balance. Numerical investigations show that the critical excitations are well approximated by the suboptimal excitations.     

Theoretical Analysis of Critical period in Microbend Fiberoptic Sensor

1IntrodctionThesdV8fltsg6Sofffi1CY0bCfldf山CY0ptlCS6fiS0f8f6lflt6llSltyffiDdU18tlflgsliddCtCCtlflg，simpletechnique，highrellabllltyandlowprice，thereformlcrobendfiberoptlcsensorIswidelyusedtomeasurementofstrain，stressandv比rationetc．Inpractice，thesensltlvltyofsensorIsaveryimportantparameter，andthesensltlvltyofmlcrobendf山eroptlcsensorIsmainlyrelat-6dtofoil0WlflgthY66f8CtofS［‘-：ffilCfob6fldsffiplltlld6：fillffib6yofthlCY0b6fldS6Ct10llSsfldffil-crobendperiod，andmlcrobendperio…     

双波段比色辐射温度计的波长选择

通过对比色测温法灵敏度温区特性和波比数判据的分析,讨论了比色波长的匹配原理,试图解决选择比色波长的理论依据。     

MPP中确定临界处理器数的方法

本文提出了并行求解问题时所应征用ＭＰＰ系统中临界处理器数的选择方法，该方法根据问题图中每一结点的时间特征进行选择，可操作性好，易于实现，特别适用于基于互连网络的ＭＰＰ系统和分布式系统。