STN—LCD的新进展

STN-LCD采用新的取向层,消除了残象;采用新的驱动波形,消除了串扰;采用二(口恶)烷、卤化物、链烯基、醚和二苯乙炔,改进了液晶料材的性能,使STN-LCD获得高的对比度、快的响应速度、低的驱动电压;采用有源矩阵驱动方法,消除了帧响应,使STN-LCD获得高的对比度、高的亮度及视频响应速度;使用温度跟踪电路,自动跟踪STN-LCD的阀值电压,使STN-LCD获得宽的工作温度。     

Comparison between normal and reverse thin crystalline silicon solar cells

The newly developed ingot growing techniques, as the three-grain and the columnar multigrain ingot processes, are now offering the possibility of slicing thinner wafers (≤ 100 μm). In this paper we present the results obtained on p type large area (≥ 100 cm²) and 100 μm thick wafers by using both conventional and reverse cell manufacturing technologies.The conventional cells are provided with aluminium or boron BSF plus screen-printed silver mirror or a silver-aluminium net; the reverse cells have a FSF and the deep back junction completely covered by a screen-printed or CVD silver layer.The constructing parameters have been chosen on the base of one and two dimensions modeling and both raw material and devices have been completely characterized.This work shows that very thin wafers do not introduce serious problems for the conventional manufacturing of solar cells. The efficiencies of the normal and of the reverse cells are found to be comparable and are of the same order than those of thicker cells, however at a significant lower cost. The main obtained result has to be related to the demonstration of a cell manufacturing feasibility starting from very thin wafers.     

上下行信号平衡与蜂窝小区设计

本文从无线电通信基本要素出发 ,阐述上行信号和下行信号的无线传播 ,得出上下行信号平衡链路方程 ,并以我国普遍使用的TACS系统和GSM系统为例 ,着重讨论了信号平衡与蜂窝小区设计之间的关系。     

低旋流进气直喷燃烧系统在195柴油机上的应用研究

介绍了低旋流进气直喷燃烧系统应用于１９５柴油机的试验结果，着重探讨了燃烧室结构尺寸和供油系统主要参数对柴油机性能和燃烧放热规律的影响。研究表明，这种燃烧系统应用于小缸径直喷柴油机具有良好的推广前景。     

Partial scan design and test sequence generation based on reduced scan shift method

This paper presents a partial scan algorithm, calledPARES (PartialscanAlgorithm based onREduced Scan shift), for designing partial scan circuits. PARES is based on the reduced scan shift that has been previously proposed for generating short test sequences for full scan circuits. In the reduced scan shift method, one determines proch FFs must be controlled and observed for each test vector. According to the results of similar analysis, PARES selects these FFs that must be controlled or observed for a large number of test vectors, as scanned FFs. Short test sequences are generated by reducing scan shift operations using a static test compaction method. To minimize the loss of fault coverage, the order of test vectors is so determined that the unscanned FFs are in the state required by the next test vector. If there are any faults undetected yet by a test sequence derived from the test vectors, then PARES uses a sequential circuit test generator to detect the faults. Experimental results for ISCAS'89 benchmark circuits are given to demonstrate the effectiveness of PARES.     

一种新的带优先权控制的ATM交换结构

本文在Ｋｎｏｃｋｏｕｔ交换结构的基础上，探讨一种新的ＡＴＭ交换结构，使其本身带有优先权控制功能，以适应不同业务对信元丢失率及时延的不同要求。这种结构既能最大限度地有效利用系统资源，又能满足不同用户对业务质量的不同要求，并能降低交换结构复杂度。     

含氮化合物废气选择性催化氧化技术研究进展

通过对当前含氮化合物废气治理技术的对比分析,总结选择性催化氧化的相关技术优势。根据对含氮化合物的种类及来源分析,介绍氨气、腈类、胺类及其他含氮化合物的催化净化技术。重点总结催化剂的种类、研发进展和在实际使用中可能遇到的问题,同时展望含氮化合物废气选择性催化氧化技术的研发方向。     

The effect of pre-wetting on dynamic contact angles

A roll-coating experimental system is used to study the effect of pre-wetting on dynamic contact angles, the interfacial displacement depth, and the associated phenomenon of air entrainment. The system consists of a roll, which is horizontally rotating in a liquid pool. The dynamic contact angle is recorded by a macrophotography system. The test liquids are glycerol solutions with viscosities in the range 104 < μ < 748 mPa · s. The value of (μV/ρg)^0.5 is taken as the characteristic length to be used in the dimensionless relationships which correlate experimental measurements. The effect of base layer entry angle into the liquid pool on the dynamic contact angles and other flow parameters is studied. Comparison is made with measurements in dry tape-coating and other pre-wet roll–coating systems.     

异步时序型PAL解析方法的研究及解析结果分析

本文就异步时序现ＰＡＬ的解析，提出了一种状态图遍历算法。     

用于多种组装技术的厚膜导体复合结构

厚膜导体Ｐｄ－Ａｇ／Ａｕ、Ｐｔ－Ｐｄ－Ａｕ／Ａｕ平面复合结构，Ｐｄ－Ａｇ／Ａｕ立体复合结构可使多种组装技术相互兼容。立体复合结构还可有效地降低导体线电阻，减少线损耗。而且，其超声键合性尤佳