Isochoric p-ρ-T Measurements on 1,1-Difluoroethane (R152a) from 158 to 400 K and 1,1,1-Trifluoroethane (R143a) from 166 to 400 K at Pressures to 35 MPa

The p--T relationships have been measured for 1,1-difluoroethane (R152a) and 1,1,1-trifluoroethane (R143a) by an isochoric method with gravimetric determinations of the amount of substance. Temperatures ranged from 158 to 400 K for R152a and from 166 to 400 K for R143a, while pressures were up to 35 MPa. Measurements were conducted on compressed liquid samples. Determinations of saturated liquid densities were made by extrapolating each isochore to the vapor pressure, and determining the temperature and density at the intersection. Published p--T data are in good agreement with this study. For the p--T apparatus, the uncertainty of the temperature is ±0.03 K, and for pressure it is ±0.01% at p>3 MPa and ±0.05% at p<3 MPa. The principal source of uncertainty is the cell volume (28.5 cm³), which has a standard uncertainty of ±0.003 cm³. When all components of experimental uncertainty are considered, the expanded relative uncertainty (with a coverage factor k=2 and thus a two-standard deviation estimate) of the density measurements is estimated to be ±0.05%.     

化学因子分析法测定液体推进剂A

基于测定推进剂Ａ现有分析方法准确度低,神经网络法对仪器要求高等不足,提出了的一种新的分析方法。该方法利用已知酸的电位滴定数据建立多元线性回归数学模型,利用化学因子分解该模型,对未知样进行浓度测定。实际测定结果表明本方法的最大分析误差不超过０．１７％,标准偏差不超过１．９％,满足样品分析要求。     

Ignitable Liquid Classification and Identification Using the Summed-Ion Mass Spectrum

Abstract

The mass spectra calculated by summing the intensities of each nominal mass over all chromatographic times, the summed ion spectra, were calculated for a set of 440 commercially available ignitable liquids that had been analyzed by gas chromatography–mass spectrometry. Each ignitable liquid is generally comprised of a mixture of chemicals, and the mixtures may be very complex in some cases, e.g., petroleum distillates, gasoline, etc. The summed ion spectra were evaluated to determine if they contained sufficient information content to allow their use for rapid and accurate identification of the ignitable liquid in a database or library. The summed ion nominal mass spectra were encoded in one bit per channel at 1% transition intensity and a set of 96,580 unique pairwise comparisons were made between spectra, resulting in an average of approximately 50 differing channels per comparison. A subset of 62 summed ion spectra were further compared by a similarity metric and found by cluster analysis to group closely along the ASTM ignitable liquid classification scheme. Receiver operator characteristic analysis of the use of the similarity index in combination with the summed ion spectra was shown to provide 99% probability of correct liquid identification and 95% probability of correct ASTM classification by primary and sub-class. Interlaboratory tests found 95% probability of correct liquid identification and 85% probability of correct ASTM classification at the primary class level. These results demonstrate the use of the summed ion spectrum as a first step in the rapid identification of an ignitable liquid by database or library searching.     

聚合物在离子选择电极上的应用

本文概述了聚合物膜离子选择电极的发展,制备、应用等方面的研究情况;将聚合物膜离子选择电极分为固态膜类和液态膜类,分别对其优缺点和发展前景加以分析;并讨论了聚合物在敏感膜中的作用,以及聚合物结构对敏感膜性能的可能影响。     

液滴在热液相介质中上升汽化时的传热与传质

本文分析了液滴在不互溶的液相介质中上升汽化时的传热和传质,导出了数模,进行了数值求解,获知在泡滴与液相接触的汽液边界处温度下降和浓度升高,存在着溶液的过冷(或过饱和)边界层。实验结果与数模计算结果表明,该模型能够较好地预測液滴汽化的整体特性。     

液氢管路绝热设计与效果分析

通过总结液氢管路绝热设计和使用的经验,着重分析了夹层气体压强与漏热和表观导热系数以及气体压强回升与时间的定量关系,提出了工程设计中绝热性能及真空寿命的确定方法.     

液芯有机光纤的研制

研制出了液态有机光纤.结果表明,有机溶液的拉曼光谱与普通样品池的方法相比,其强度增加102倍以上.     

基于van der Waals状态方程的剩余自由能模型

结合 Wong- Sandler的混合规则 ,即在无穷大压力下剩余 Helmholtz自由能与无穷小剩余 Gibbs自由能近似相等的关系 ,给出了一个基于 van der Waals状态方程的剩余自由能模型 ,由此得到可以描述汽液相平衡的活度系数模型。通过对 35个体系的考核表明 ,该模型可以较好的关联实验数据 ,包括极性与极性物系 ,其结果好于 Wilson、Mar-gules、NRTL与 Uniquac等模型的计算结果。同时 ,因为该模型基于 Wong- Sandler的混合规则 ,因此可以实现在理想溶液中 ,由 Wong- Sandler混合规则到 van der Waals混合规则平滑过渡。     

液位测控系统的可靠性设计

以系统的可靠性为目标对液位测控系统进行综合设计和技术改进。通过对软、硬件功能的合理分配和对关键技术难点解决方案的选择，以及兼容设计、降额设计、抗干扰设计等可靠性保障技术的应用提高了小型液位测控系统的技术指标和可靠性指标。同时，本文也为其它小型智能化仪表的可靠性保障设计提供了一种思路和方法。