重油纳米化助燃效果研究与表征

将复配的分散剂加入重油中制备得到重油纳米颗粒，采用氧弹热值对比法对所研制的纳米化重油进行实验室评价。研究结果表明，纳米化后的重油燃烧性能得到了改善，在掺水量为3％～12％时，重油的燃烧效率提高了2．5％～6．1％。通过TEM观察，纳米化后的重油呈水包油（O／W）型乳液结构，油水界面清晰，界面膜较厚，乳化油粒径约为20～50nm，油水分散均匀，并且分散后的重油粘度增幅小，掺水量在15％以内，粘度增幅不超过20％，并且随着掺水量的增加，乳化重油的粘度逐渐减少。另外，乳化重油稳定性好，室温下至少可保存6个月，在80℃下存放3天未发生破乳现象。     

钢铁企业锅炉改造的可行性分析与实践

根据旧有锅炉存在的问题提出了改造方案，并对其进行可行性分析，选择了符合企业实际情况的改造方案，从而取得了良好的经济效益。     

Experimental methods for measuring the oil-film thickness between the piston-rings and cylinder-wall of internal combustion engines

Computer models of the lubrication of piston-rings in internal combustion engines normally present an estimate of the minimum oil-film thickness between ring and cylinder wall as a function of crank angle. As a consequence, experimental measurements of film thickness play a critical role in the verification of theoretical models of piston-ring lubrication. A review is presented of the wide range of techniques that have been used to measure this important variable. The strengths and weaknesses of particular techniques are identified and a number of ways in which the techniques could be developed further are proposed     

催化裂化烟气转硫脱氮和助燃三功能催化剂FP-DSN的工业应用

烟气转硫、脱氮和助燃三功能新型催化剂FP DSN在中国石油天然气股份有限公司锦西石化分公司 1.4Mt/a重油催化裂化装置的工业应用表明 ,此种以La ,Ce ,Sr和Co等元素的氧化物或复合物为活性组分的催化剂 ,在其用量为催化裂化催化剂总藏量的 1%～ 2 %的情况下 ,有较强的脱除烟气中SOx 和NOx 的能力 ,大大减轻了烟气对反应器壁的腐蚀 ,减少了污染气体的排放 ,同时有CO助燃效果 ,装置可不使用其他专门的助燃剂。应用试验时 ,再生器烟气中SOx 的平均脱除率达 72 .85 %,NOx 的平均脱除率达 85 .90 %。该催化剂的使用对催化裂化产品的分布和质量无明显影响。该剂的应用为装置带来了可观的经济效益。     

Relationship Between Coal Powder and Its Combustibility

Coal‘s volatile component ,ash and fixed carbon content have different function in different stages of a combustion process,but the traditional coal classification can precisely show its combustion property.In this experiment coal‘s evaluation indeves(ignition index Di),(burn off index Df) were used to qualitatively show the ignition property and combustion ending property of coal samples.Meanwhile,considering actual heating circumstances in calciner(in cement plants),this thesis established the relationship among the ignition index,burn off index and coal‘s industrial analysis value,which makes it possible for the user to predict the quality of coal before using it and is very valuable in practice.     

高密实火药床燃烧转爆轰的数学模型

本文对以往燃烧转爆轰数学模型进行了评价.根据现代高性能火炮密实装药的特点,建立了能描述燃烧转爆轰(DDT)现象的一维反应两相流数学模型.其改进包括:考虑火药的可压缩性;提出了与DDT过程相适应的临界点火着火判据;利用熵不等式导出固相体积分数守恒方程;建立了颗粒守恒方程;引进了适合高压的非理想气体状态方程.最后给出了算例.     

Design and characterisation of a close-concentric annular reactor for kinetic studies at high temperatures

A novel annular reactor for kinetic studies at high temperature and flow conditions has been designed to keep eccentricity tolerances below 10%. In a previous work, we have shown that it is very important to keep such low eccentricity values in order to collect reliable kinetic data from this type of reactors. As proposed in this study, a modified reactor with the use of a spacer could guarantee an annular duct with low levels of eccentricity. Manufacturing tolerances or deformation effects giving rise to eccentricity can be significantly minimised when using this apparatus. The reactor has been both experimentally and theoretically characterised. Carbon monoxide oxidation was used as a model reaction under mass-transfer limited conditions revealing an eccentricity of ∼5%. With such small eccentricity levels, a concentric annular form can be assumed in the reactor analysis. Simple 1D or 2D models can therefore be inexpensively used in the evaluation of the kinetic data. Also, prior to the design of the annular reactor, a numerical investigation was carried out to clarify the effects of eccentricity, physical properties of the carrier gas and the annular aspect ratio on mass-transfer limitations. Contrary to expectations, a considerable increase in the fuel mass-diffusivity by carrier gas substitution did not change the mass-transfer rates for cases when eccentricity and aspect ratios were high.     

多缝式烧嘴点火器在攀钢烧结生产中的应用

多缝式烧嘴点火器具有燃烧效率高，火焰长度易调，炉膛温度分布合理等优点，经工业试验证明，该点火器能满足攀钢烧结点火工艺要求，并有明显节能效果。     

Change of characteristics of desulfurization and denitrification by combustion flue gas composition and electrode configuration under pulsed corona discharge

Laboratory-scale and parametric experiments of SO₂ and NO_x removal from the simulated combustion gas by pulsed corona discharge have been performed by changing the combustion gas composition and temperature, the electrode configuration of plasma reactor, and the polarity of high-voltage electrode. The following results are obtained: 1) the higher the concentration of H₂O and O₂, the higher the efficiency of desulfurization and denitrification at the same specific input; 2) the pulsed corona discharge with a voltage pulsewidth as short as 200 ns of negative polarity shows the possibility to attain almost 90 percent deSO_x and deNO_x efficiency at the specific discharge input of 20 J/g, which is almost the same as the specific input in the electron-beam process; 3) the deNO_x characteristics show a little temperature dependence in the range of 70 to 130°C, but the deSO_x efficiency increases rapidly in the temperature region below 100°C suggesting the thermochemical dependence of deSO_x reaction; 4) when desulfurization and denitrification proceed, the white dendritic powder deposits on the plasma reactor whose composition is identified to be 49 mol% (NH₄)₂SO₄ and 47 mol% of 2NH₄NO₃ · (NH₄)₂SO₄, and the ratio of SO₂, NO and NH₃ of the deposit is almost equal to that of supplied gas.     

洁净型煤技术开发研制

通过对洁净型煤技术的介绍，并对型煤质量及燃烧测试分析，认为洁净型煤技术是一种煤的高效洁净燃烧、改善环境空气质量及节约能源的有效技术。