中国的钛工业概况

对近年来轻水反应堆用锆合金材料的发展及其应用研究中一些主要技术问题和标准要求进行了综合述评。     

下喷式环流反应器环隙气含率影响因素

下喷式环流反应器是一种用于强化气-液两相反应过程的新型装置，虽然已在工业上有了较广泛的应用，但对其理论研究远未成熟，其工业装置的设计仍依赖于实验和经验。本文借助实验室自制实验装置，对下喷式环流反应器环隙气含率的影响规律进行了研究。首先，对喷射器的吸气量进行了测量，获得了不同条件下喷射器最大吸气量的性能曲线；在此基础上，分别研究了气相流量、液相流量以及喷射器安装位置对环隙气含率的影响规律。结果表明：气相流量和液相流量对气含率具有重要的影响，随着气相流量和液相流量的增大，气含率快速提高，而喷嘴位置对气含率的影响相对较小；考虑到增加气相流量和液相流量所需要的能耗和设备代价，通过增加液相流量来达到提高气含率的目的是优选方案。     

非冷冻碳化法工业化生产针状纳米碳酸钙

通过开发复合型结晶导向剂,在实验室试验和中试的基础上,实现了在非冷冻(高温35~75℃)、氢氧化钙高浓度(质量分数7%~12%)条件下碳化生产针状(晶须)纳米碳酸钙。将该方法应用在石家庄博达钙业有限公司2.5万T/A的轻质碳酸钙工业装置上,经扫描电镜、透射电镜、X射线衍射和比表面积测定分析表明,产品纳米碳酸钙的晶形为针状,粒度均匀、分布窄,粒径10~20 NM,长径比15~20,比表面积≥90 M2/G,总孔容≥0.26 ML/G。     

用MOCVD法制备铁系云母珠光颜料

以Fe(CO) 5为物源 ,在常压喷动流化反应器中 ,以金属有机化学气相沉积 (MOCVD)法对云母粉进行包覆 ,制备铁系 -云母珠光颜料。实验结果表明 :在沉积温度 2 5 0℃ ,氧气流量 3mL·s-1,沉积时间 5min时能得到棕色色泽的珠光颜料 ;随着沉积温度的提高和反应时间的延长 ,可获得红棕、金红、橙红、深红等不同色泽的珠光颜料。用色差仪测定颜料的明度值L 、红度值a 、黄度值b ;X衍射仪表征颜料的表面成分 ;酸滴定计算氧化物的涂覆率。探讨了温度、时间、氧量对珠光颜料表面成分和珠光光泽的影响     

氧泵型催化膜反应器中甲烷氧化偶联反应(Ⅰ)——氧泵型催化膜的制备及其反应性能

本文采用1％Sr/La_2O_3-Ag-YSZ氧泵型催化膜反应器进行了甲烷氧化偶联反应研究。比较了不同制备方法的催化膜的反应性能,结果发现浸涂法(Ag-YSZ管随旋转轴转动涂制)制备的膜性能最佳。研究了操作条件对甲烷氧化偶联反应的影响。研究证明,传递氧与气相氧同时进料是一种较好的反应方式。结果表明,利用该反应器不仅可以简化分离过程,而且还可得到更高的C_2烃选择性。     

DIRECT OXIDATION OF ETHYLENE TO ACETALDEHYDE IN A HOLLOW FIBER MEMBRANE REACTOR†

A hollow fiber membrane reactor, which resembles a tube-and-shell heat exchanger, was developed for homogeneous catalytic reactions with gas reactants and products. The gas stream flows through the tube side while the reaction takes place in the catalyst solution which fills the shell side. The separation load of product from the catalyst solution can be reduced by using a hollow fiber membrane reactor instead of a conventional bubble column reactor. The reactor operates in a plug-flow pattern with a large mass transfer area per unit volume of catalyst solution

This concept was investigated experimentally using the direct oxidation of ethylene to acetaldehyde reaction in an aqueous solution of palladium (H) chloride-cupric chloride with a silicone rubber membrane reactor and a polypropylene membrane reactor. It was experimentally demonstrated that membrane reactors could achieve higher production rates per unit volume of catalyst than the conventional sparged reactor. The experimental data were in good agreement with the predictions by the mathematical model. The conditions under which the membrane reactor will be more advantageous than the conventional sparged reactors can be readily ascertained with the analytical solution of the simplified membrane reactor model.     

EFFECT OF SUSPENDED FIBRES ON MACRO-MIXING AND MICRO-MIXING IN A STIRRED TANK REACTOR

The effects of suspended fibre on macroscale and microscale mixing in a small stirred tank reactor were studied under batch conditions using the competitive, consecutive azo coupling between 1-naphthol and diazotized sulfanilic acid. The mixing quality was determined from the distribution between the mono and bis substituted reaction products. Nylon (2 and 3 millimeters in length) and fully bleached softwood kraft pulp (FBK) fibre suspensions were examined at volumetric concentrations up to the limit that complete suspension motion could be maintained in the vessel at impellet rotational speeds of 7 and 10s^-1. The adsorption of the product dyes on the fibre was found to be proportional or very nearly proportional to their concentrations in the aqueous phase and did not interfere with the assessment of mixing in the suspension.

Suspended fibres were found to slightly increase the 'critical feed time' of the diazotized sulfanilic acid, corresponding to an increase in the macromixing or bulk blend lime of the vessel. Continued increase in the fibre concentration led to the formation of a well mixed cavern centered on the impeller and the creation of stagnant regions adjacent to the vessel walls. The departure from the Newtonian fibre-free case is due to changes in the flow through and distribution of the energy dissipative regions in the vessel. The most effective location for chemical addition to ensure good microscale mixing remains in the impeller vicinity.     

Study of the copper leaching in the wet oxidation of phenol with CuO-based catalysts: Causes and effects

Catalytic wet oxidation of phenol as a model pollutant has been performed in a three phase fixed-bed reactor (FBR) by using a commercial catalyst based on copper oxide in order to analyze the variables affecting significantly the copper leaching. It has been found that temperature has an almost negligible influence in the range studied (70–160 °C). On the contrary, an important effect of the pH value was noticed. The copper leaching reduces when the pH of the solution fed to the reactor increases, being almost negligible at pH ≥ 5. Moreover, the composition of the reaction media also influences the leaching. Higher copper concentrations than those expected by the effect of the acid aqueous media have been measured in the reactor effluent when phenol, catechol, hydroquinone, p-benzoquinone and maleic acid are present in the reaction media. On the contrary, oxalic acid has a negative influence on the leaching, since it captures the copper in solution to form copper oxalate which precipitates on the catalyst surface. For a previously acidified medium, the acetic and formic acids do not have any other effect on the copper leaching. It has been also demonstrated that as copper in solution decreases, so does phenol conversion, because the homogeneous catalysis contributes significantly to the oxidation reactions even in fixed-bed reactors.     

微孔无机膜反应器研究

主要介绍了无机膜在化学反应中的应用－－膜反应器研究，对膜反应器的特点、类型、应用、影响因素以及与其它反应器的比较进行了评述，并对其应用前景进行了展望。