小型静压桩压桩力系数取值方法的探讨

由于《建筑桩基技术规范》 (JGJ94 - 94 )和《锚杆静压桩技术规程》 (YBJ2 2 7- 91)表达的不少概念和立足点有着根本区别 ,因此目前在小型静压桩设计、施工、质量检测和施工验收时相关人员在引用规范和规程时出现了不尽统一的现象。本文根据相应规范、规程的有关规定 ,结合现场试验 ,进行分析探讨 ,提出了小型静压桩压桩力系数的取值方法。     

泄压注浆法在治理小型突水中的运用

七煤集团建设工程公司在施工辽阳铧子石膏矿主、风井井筒时 ,多次采用泄压注浆法成功通过中小型含水层 ,对小型突水进行了有效封堵 ,取得了较好的经济效益     

压阻式压力传感器及其应用电路设计

介绍了压阻式传感器的工作原理以及相关应用电路，并给出了一个应用示例加以说明。     

Process optimisation in sunflower oil extraction by supercritical CO2

A continuous process for the extraction of sunflower oil using supercritical CO₂, featuring multiple extractors, one oil separator and three cascaded CO₂ recovery vessels operating at different pressures, was devised and studied. For every single equipment of the plant making up the process a mathematical model was built. Experimental tests—consisting in measurements of oil solubility in supercritical CO₂—were carried out in a laboratory-scale apparatus to characterise the behaviour of sunflower oil in the separation from the supercritical fluid. The mathematical model of the whole process was coded in the commercial gPROMS process modelling environment where both its simulation and optimisation—this latter assuming the overall oil production cost as the objective function—were carried out. The process- and economics-related results are discussed and compared with those obtained with traditional and cold-pressing extraction.     

确定异常高压气藏地质储量和可采储量的新方法

基于文献[1]的定容，封闭，异常高压气藏的物质平衡方程式，提出了确定异常高压气藏原始地质储量，可采储量和采收率的新方法，通过实例的应用和对比表明，提供的新方法是适用的有效的。     

低渗透油藏生产井关井测压时间的计算与应用

低渗透油藏的生产井压裂后，在单井试油试采过程中，压力恢复测试关井时间不同，其中有些井压力恢复曲线不能出现边界反应段，渗流不能反映地层中真实流动特征。针对这种情况，基于长庆绥靖油田塞39井区长：低渗透油藏大量试井和实际生产资料，利用现代试井解释理论，研究合理关井时间的界限及其计算方法。结果表明，当油井关井测压时间达到3倍地层径向流开始出现的时间后，利用此时的压力数据解释地层参数和地层压力，其结果的误差小于5％，同时能较准确地判断边界类型。计算的理论曲线和霍纳法解释值非常接近，对于塞39井区，若预先知道某生产井地层有效渗透率值，可从理论曲线查出压力恢复试井的关井时间，否则，建议按照该井区地层有效渗透率（大约在6mD左右），将不稳定试井测试时间控制在25d以上为宜。图4表3参14     

低压低渗气藏钻探过程中的保护方案

针对鄂尔多斯塔巴庙区块低压低渗气藏物理特性复杂的情况，推荐一套切实可行的气层保护方案。即实行全面钻井液监控；采用欠平衡钻井技术；储层保护前期研究；采用与地层流体配伍性好的阳离子钻井液体系；降低钻井完井液的滤失量，API滤失量小于5mL、高温高压滤失量小于15mL、固相含量小于8％、含砂量小于0．3％；根据储层裂缝的宽度和走向使用保护剂；对裸眼完钻的气层利用洗井清除井壁附近的污染带，恢复储层原始渗透率；固井作业防止气窜；采用具有抑制地层水敏、速敏保护气层的优质射孔液；水力压裂优化压裂设计，严格压裂施工。总之，气层保护技术是一个系统工程，任何一个环节的问题，都将对气层产生伤害．因此需加强气层保护研究，做到在钻开气层到投产的每道工序都采取积极有效的气层保护措施。     

Application of a Compaction Simulator to the Design of a High-Dose Tablet Formulation. Part I

The compaction properties of an investigational drug are studied by the use of a compaction simulator. The effects of punch velocity over the range of 30-640 mm^-1 on the compaction properties of the pure drug and a variety of formulas incorporating a high dose of the active compound have been investigated. The data were analyzed by applying the Heckel equation. The pure drug was found to have a high yield pressure at a relatively low punch velocity of 31 mm^-1. As the punch velocity was increased there was a decrease in crushing strength, primarily as a result of increasing yield pressure. These findings indicate that the pure drug predominantly consolidated by fragmentation and elastic deformation, with a slow plastically deforming component. The information obtained on the consolidation mechanism of the pure drug and, subsequently, on model formulas were instrumental in the design and selection of a robust formula and granulation process. The advantages of conducting dosage form design and characterization studies during the early phase of tablet formulation using means such as a compaction simulator are emphasized in this investigation.     

Processing and properties of zirconia-toughened alumina ceramics

Al₂O₃:ZrO₂ ceramics have been prepared from physically mixed pure oxide powders. The results indicate that careful processing of the starting powders and a two-stage sintering process can avoid expensive processing methods like hot pressing/hot isostatic pressing used for achieving high densification. The mechanical properties were measured and the resultant microstructure studied to explain the toughening behaviour of this material.     

超高增压柴油机与斯特林发动机复合运行的分析

本文对超高增压柴油机与斯特林发动机的复合运行进行了初步的探讨,陈述了这种复合运行作为未来发动机技术发展方向之一的可能性。