A semi-analytic boundary element method for parabolic problems

A new semi-analytic solution method is proposed for solving linear parabolic problems using the boundary element method. This method constructs a solution as an eigenfunction expansion using separation of variables. The eigenfunctions are determined using the dual reciprocity boundary element method. This separation of variables-dual reciprocity method (SOV-DRM) allows a solution to be determined without requiring either time-stepping or domain discretisation. The accuracy and computational efficiency of the SOV-DRM is found to improve as time increases. These properties make the SOV-DRM an attractive technique for solving parabolic problems.     

灌河潮流界位置确定与港口防淤探讨

盐城市位于江苏省中部,地处黄海之滨,承接里下河腹部区的排水,区内入海河流众多,在这些入海河流上大多建有挡潮闸坝。但由于盐城市近海为淤积型海岸,闸坝的建设改变了河口的自然状态,造成港口下游淤积严重,排水不畅。灌河作为江苏省沿海唯一下游没有建挡潮闸的重要入海河流,仍为自然状态,下游港口未淤积。本文通过对灌河水体涨、落潮中氯离子含量的监测,找出海水上溯的最大距离,确定其影响范围,为其它入海流河流的防淤提供借鉴。     

三维精细积分法地震正演及边界条件

 将任意差分精细积分法用于三维波动方程地震正演，关键在于如何消除数值计算中有限波场区域边界引起的边界反射。文中采用Berenger给出的电磁波完全匹配层吸收边界条件，推导出三维波动方程任意差分精细积分法地震正演的完全匹配层吸收边界条件计算公式，并给出了完全匹配层吸收边界条件算例。计算结果表明，此方法压制边界反射效果明显。三维波动方程地震正演模拟实例表明，完全匹配层吸收边界条件的任意差分精细积分法为复杂区地震波传播规律研究提供了一种实用的正演模拟工具     

Effect of pH on the Crystallization of Homogeneously Precipitated Nanosized PZT Powder

Nanosized lead zirconate titanate (PZT) powder with Zr:Ti ratio in the morphotropic phase boundary region was synthesized by homogeneous precipitation of metal ions. The powder precipitated at 90°C and at pH 6.7 resulted single-phase perovskite lead zirconate titanate powder when calcined at 550°C and above for 4 hours in air. The solution pH and the precipitation temperature strongly affect the composition of the calcined powder. The results obtained by structural characterization of homogeneously precipitated powder were compared with that obtained from the conventional precipitation method using ammonia in terms of crystallization, homogeneity, and microstructure. The homogeneously precipitated powder showed smaller particle size, minimum agglomeration and uniform shape on calcination and annealing. Powdered samples that precipitated by homogeneous precipitation crystallized directly to perovskite PZT, without any intermediate pyrochlore phase formation. In contrast, the NH₃ precipitated powder converted to perovskite PZT via metastable pyrochlore and it showed phase segregation upon annealing at higher temperatures. The reaction kinetics has been studied by X-ray diffraction, differential thermal analysis, and differential scanning calorimetry.     

Flow Control Through the Use of Topography

In this work, optimal shaft shapes for flow in the annular space between a rotating shaft with axially-periodic radius and a fixed coaxial outer circular cylinder, are investigated. Axisymmetric steady flows in this geometry are determined by solving the full Navier-Stokes equations in the actual domain. A measure of the flow field, a weighted convex combination of the volume averaged square of the L₂-norm of the velocity and vorticity vectors, is employed. It has been demonstrated that boundary shape can be used to influence the characteristics of the flow field, such as its velocity component distribution, kinetic energy, or even vorticity. This ability to influence flow fields through boundary shape may be employed to improve microfluidic mixing or, possibly, to minimize shear in biological applications.     

Symmetric BEM formulations for 2-D steady-state and transit potential problems

This paper presents a new concept for symmetric boundary element method (SBEM) applicable to 2-D steady-state and transit potential problems. Two kinds of SBEM formulations are derived. Symmetry is obtained simply through matrix manipulation, and no hypersingularity appears. Therefore, SBEM is much easier than the traditional symmetric Galerkin BEM. Compared with the traditional asymmetric BEM, the present SBEM can reduce the computational cost for time domain problems only. However, when applied to BEM/FEM coupling procedure, SBEM can reduce the computational cost for both steady-state and time domain problems. Three numerical examples are included to illustrate the effectiveness and accuracy of the present formulations.     

Transition to turbulence in rotating-disk boundary layers—convective and absolute instabilities

This work is an experimental study of mechanisms for transition to turbulence in the boundary layer on a rotating disk. In one case, the focus was on a triad resonance between pairs of traveling cross-flow modes and a stationary cross-flow mode. The other was on the temporal growth of traveling modes through a linear absolute instability mechanism first discovered by Lingwood (1995, J Fluid Mech 314:373–405). Both research directions made use of methods for introducing controlled initial disturbances. One used a distributed array of ink dots placed on the disk surface to enhance a narrow band of azimuthal and radial wave numbers of both stationary and traveling modes. The size of the dots was small so that the disturbances they produce were linear. Another approach introduced temporal disturbances by a short-duration air pulse from a hypodermic tube located above the disk and outside the boundary layer. Hot-wire sensors primarily sensitive to the azimuthal velocity component, were positioned at different spatial (r,θ) locations on the disk to document the growth of disturbances. Spatial correlation measurements were used with two simultaneous sensors to obtain wavenumber vectors. Cross-bicoherence was used to identify three-frequency phase locking. Ensemble averages conditioned on the air pulses revealed wave packets that evolved in time and space. The space–time evolution of the leading and trailing edges of the wave packets were followed past the critical radius for the absolute instability, r _{c A} . With documented linear amplitudes, the spreading of the disturbance wave packets did not continue to grow in time as r _{c A} was approached. Rather, the spreading of the trailing edge of the wave packet decelerated and asymptotically approached a constant. This result supports the linear DNS simulations of Davies and Carpenter (2003, J Fluid Mech 486:287–329) who concluded that the absolute instability mechanism does not result in a global mode, and that linear-disturbance wave packets are dominated by the convective instability. In contrast, wave-number matching between traveling cross-flow modes confirmed a triad resonance that lead to the growth of a low azimuthal number (n = 4) stationary mode. At transition, this mode had the largest amplitude. Signs of this mechanism can be found in past flow visualization of transition to turbulence in rotating disk flows.     

Non-linear current–voltage characteristics related to native defects in SrTiO3 and ZnO bicrystals

SrTiO₃ and ZnO bicrystals with various types of boundaries were fabricated in order to examine their current–voltage characteristics across single grain boundaries. Their grain boundary structures were also investigated by high-resolution transmission electron microscopy. In Nb-doped SrTiO₃, electron transport behaviors depend on the type of boundaries. Random type boundaries exhibit highly non-linear current–voltage characteristics, while low angle boundaries show a slight non-linearity. On the contrary, undoped ZnO does not exhibit non-linear current–voltage characteristics in any type of boundaries including random ones. It is suggested that the differences observed in current–voltage properties between the two systems are mainly due to the difference in the accumulation behavior of acceptor-like native defects at grain boundaries. A clear non-linearity is obtained by means of Co-doping even for the highly coherent Σ1 boundary in a ZnO bicrystal. This is considered to result from the production of acceptor-like native defects by Co-doping.     

转炉出钢口套整体袖砖工艺技术开发

介绍了天津天铁冶金集团有限公司炼钢厂转炉出钢口袖砖工艺的开发过程，主要工艺参数的制定，实践证明，该工艺的应用取得了良好的使用效果。