Design and Characterization of the CLIMPAQ,Chamber for Laboratory Investigations of Materials,Pollution and Air Quality*

A test chamber has been developed in order to provide a small and simple emission testing facility capable of testing construction products in a climate where the important climatic parameters such as temperature, ventilation rate and air velocity can be varied independently around typical indoor values. The test chamber CLIMPAQ is made of panes of window glass. Other main surface materials are stainless steel and eloxated aluminium. The chamber has a volume of 50.9 litres and is designed to meet the requirements for quantifying air pollution. In this investigation human subjects acted as air pollution judges, and chemical characterization of the air pollution was carried out. Carpet, linoleum, wall paint and seal- ant were tested simultaneously in the CLIMPAQ and in four other chambers ranging from a full-scale chamber of 28 m³ to a field and laboratory emission cell of 3.5· 10^?5m³. Product ranking is the same in all chambers for the sensory measurements. Emission rates based on sensory measurements differ for all products less than 100 % except for tests in a 3-litre chamber where emission rates were higher. Chemical measurements differ up to approximately 10 times for the same product in different chambers. Deviations appear to be the result of different environmental parameters in the various chambers. Low air concentrations or high specific ventilation rates seem to increase emissions, while differences in air velocities and sink properties may also be the cause of differences in emission rates.     

大泵站超驼峰水位运行压缩空气断流系统的设计方法

阐述了压缩空气断流的原理，提出了压缩空气断流装置的一般构成和设计方法，首次应用气体喷射器作为压缩空气减压增量变换器，不但及时地增加了补气量，防止断流后流道压力的下降，而且大大减小了储气罐容积，使该项技术得以满足工程实际的要求，为同类泵站的技术改造     

武钢 3×10~4m~3/h 空分手动变负荷生产的探索与实践

对武钢引进的两台３×１０４ｍ３／ｈ空分设备，为改变其自动变负荷生产调节范围小、时间长的问题，采用了人工手动变负荷的操作方法。实践表明：扩大了增减产范围，缩短了调节时间，有十分明显的综合经济效益，可供大型空分变负荷生产借鉴参考。     

气囊内模制作桥面板在华丰湾防洪工程中的应用

采用气囊作内模进行浇筑桥面板混凝土 ,加快了预制桥面板施工进度 ,确保工程施工质量 ,并降低了工程施工成本     

Kinetics of phenol oxidation in a trickle bed reactor over active carbon catalyst

The wet air oxidation of phenol over a commercial active carbon catalyst was studied in a trickle bed reactor (TBR) in the temperature and oxygen partial pressure ranges of 120–160 °C and 0.1–0.2 MPa, respectively. The performance of the active carbon was compared in terms of phenol and COD destruction. The weight change of active carbon due to reaction was also measured. Finally, oxic phenol adsorption isotherms were assessed in batch conditions at 25, 125 and 160 °C. In order to use the conversion data obtained from the TBR for a kinetic study, special care was taken to check the kinetic control in the TBR experiments. Several kinetic models including power law or Langmuir–Hinshelwood expressions were considered to describe the catalytic oxidation of phenol over active carbon. The simple power law model with first order dependence on both phenol and oxygen concentration predicted satisfactorily the experimental data not only over the entire range of operating conditions studied, but also outside its validity range. Copyright © 2005 Society of Chemical Industry     

The Danish Twin Apartment Study – Part II: Mathematical modeling of the relative strength of sources of indoor air pollution

Abstract This study deals with the modeling of air pollution in apartments from laboratory measurements of source strengths, using formaldehyde and Total Volatile Organic Compounds (TVOCs) as model pollutants. The sources in two test apartments were grouped into two: building-related sources and occupant-related sources. The measured source strengths and ventilation rates were used for the prediction of concentrations expected in the apartments. These predictions were compared to measurements in the apartment over 12 months. The conclusions were that the model predictions based on emission rates measured in the laboratory can be used to predict the long-term concentration of the two model pollutants in the apartments. Considering the measured differences in ventilation between the apartments, an occupant emission rate of between 0.2 and 0.3 mg/h/kg body weight could be estimated. Based on previous suggested limits of acceptable exposures of humans to VOCs, an acceptable average emission rate of VOCs from building materials in general was estimated to be about 30 (μ/m²/h. The modeling showed that during the first 200 days, building materials dominated the emissions. After this, sources relating to the occupants dominated. On average about half of the VOC pollution originated from the building materials.     

固井设备发动机防爆系统研究

针对目前固井设备不具备防爆功能的问题, 烟台杰瑞石油装备技术有限公司研制了JCMS210固井混浆橇中Detroit8V—71N发动机防爆气控系统。在对柴油发动机的引燃源进行分析后, 阐述了防爆气控系统设计方案, 给出气控系统工作原理图。室内试验和中海油田服务股份有限公司的现场使用证明, 这种防爆气控系统性能良好, 工作可靠, 能满足ZONE2的防爆要求, 解决了固井设备的防爆问题。     

金属矿山深热矿井空气温度的灰色预测

金属矿山深热矿井气温的预测计算是一个难题，本文探讨了应用灰色系统预测理论来解决这一难题的新途径，并通过实例验证了该方法的可行性和有效性。     

Air entrainment in fresh concrete with PFA

The results of a study into the influence of PFA on air entrainment in fresh concrete are discussed It is shown that the required dosage of AEA to produce an air content of 5.5 ± 0.5% in a PFA modified concrete mix is two-six times that required in the corresponding neat OPC concrete mix. The dosage of a vinsol based air entraining agent (AEA) required appears to be directly related to the PFA content of the mix. Similar direct relationships were obtained with a range of different PFAs. The dosage of an AEA based on the salt of a fatty acid appears to be sensitive to both PFA and OPC contents. For the type of PFA used, the variability of measured air content or the amount of air retained after continued agitation both indicated that vinsol based AEAs show the highest variability whilst fatty acid based AEAs show low variability. The between batch variability of air content was significantly improved by the addition of PFA regardless of the AEA used.     

空气调节中加湿处理的方案选择--某商标编织车间的空调设计

本文针对散热量大 ,散湿量小并要求控制室内相对湿度的场所进行了空调方案的分析比较 ,由此选择了一种比较节能和节省投资的空调设计方案。