车载制氧机加装预冷装置的研究与实现

航空兵部队地面保障装备之一的车载移动式制氧机，采用封闭循环水冷却，由于受到使用条件的限制，多数情况下冷却效果不尽理想，加装蒸汽压缩预冷装置，即可较好地了和低冷却系统温度，提高制冷量和整机使用寿命，又可满足整车机动性，动力等技术要求。     

海上无人驻守平台上的密闭循环涡轮发电机组

海上无人驻守简易平台设计是降低原油成本的重要手段之一,密闭循环涡轮发电机组(Closed Cycle Vapor Turbogenerator)是海上无人驻守平台上应用最可靠且低维护的远程发电系统。介绍CCVT这种发电机组,并讨论了在海上工程设计中需要考虑的问题,为今后简易平台上电站的选择设计提供参考。     

Quantitative evaluation of generator power control effect of FACTS controllers for power system stabilization

The advancement of power electronics technologies has significantly developed the power system stabilizing controllers. Quantitative as well as qualitative evaluation of their effectiveness in power systems is a matter of great importance for the feasibility investigation of these apparatus. In this paper, the possible control region of FACTS controllers with series and/or shunt configuration in a single machine to infinite bus system is formulated in the powerangle curve with a set of algebraic equations. The effectiveness of TCPST (Thyristor‐Controlled Phase Shifting Transformer), SSSC (Static Synchronous Series Compensator), and TCSC (Thyristor‐Controlled Series Compensator) for the improvement of the transient stability is evaluated quantitatively as a numerical example. The correctness of the proposed method has been confirmed by analysis based on the electromagnetic transients simulation with a detailed system model. © 2001 Scripta Technica, Electr Eng Jpn, 138(3): 43–51, 2002     

现场总线技术在发电系统数据采集中的应用

介绍了现场总线网络在干熄焦汽轮机发电生产过程中所起的作用，并重点介绍了系统所完成的数据采集，监视和管理等功能。     

无线信道中的电波传播

分析了信号在无线信道中传输时所经受的两种衰落,介绍了主要的无线传播模型,在此基础上提出了对抗衰落的措施。     

通信用VRLA蓄电池可靠性指标及计算探讨

在说明通信局（站）电源系统对VRLA蓄电池组可靠性要求的基础上，阐述了为了达到电信设备的电压、电流需求，通过串联或串并联构成电池组的单体VRLA蓄电池应达到的可靠性指标。在确定单体VRLA蓄电池应达到的可靠性指标。在确定单体VRLA蓄电池可靠性参数时，可通过现场使用调查或加速寿命试验的办法来求得。在单体VRLA蓄电池可靠性指标过低的情况下，可通过多种冗余连接方式来提高电池组的可靠性。     

二滩水电站地下厂房洞室的施工特点

国际承包商在二滩工程中的许多施工布置和方法，施工技术和工艺、施工设备和措施很具有特色，扩展了我们的视野、丰富的我们的思路。总结其经验，可作为国内类似工程的参考。     

Open‐cycle OTEC systems with freshwater product: Effects of noncondensable gases on performance of condenser

An open‐cycle ocean thermal energy conversion (OC‐OTEC) system is one of the energy conversion methods used to generate electricity from ocean thermal energy. For the OC‐OTEC system, steam evaporated from the surface seawater due to flash evaporation drives the turbine. At that time, dissolved gas such as air is introduced into the low‐pressure system (OC‐OTEC system) as the noncondensable gas, which degrades the performance of condensation heat transfer. In this paper, a small‐scale OC‐OTEC experimental unit experimentally investigates the effect of noncondensable gas on the heat transfer performance in a condenser. The experimental results are discussed in comparison with theoretical estimation by the Sparrow–in method. It is shown that the condensation is occupied by heat and mass transfer near a condensation surface and that the condensation efficiency is affected by exhaust quantity of noncondensable gas at a relatively high concentration ratio of condensable gas. © 2005 Wiley Periodicals, Inc. Electr Eng Jpn, 154(1): 29–35, 2006; Published online in Wiley InterScience ( www.interscience.wiley.com ). DOI 10.1002/eej.20179     

A novel robust current control approach using adaptive line enhancer for three‐phase current‐source active power filter

An effective system control method is presented for applying a three‐phase current‐source PWM converter with a deadbeat controller to active power filters (APFs). In the shunt‐type configuration, the APF is controlled such that the current drawn by the APF from the utility is equal to the current harmonics and reactive current required for the load. To attain the time‐optimal response of the APF supply current, a two‐dimensional deadbeat control scheme is applied to APF current control. Furthermore, in order to cancel both the delay in the two‐dimensional deadbeat control scheme and the delay in DSP control strategy, an Adaptive Line Enhancer (ALE) is introduced in order to predict the desired value three sampling periods ahead. ALE has another function of bringing robustness to the deadbeat control system. Due to the ALE, settling time is made short in a transient state. On the other hand, total harmonic distortion (THD) of source currents can be minimized compared to the case where ideal identification of the controlled system can be made. The experimental results obtained from the DSP‐based APF are also reported. The compensating ability of this APF is very high in accuracy and responsiveness although the modulation frequency is rather low. © 2004 Wiley Periodicals, Inc. Electr Eng Jpn, 150(1): 50–61, 2005; Published online in Wiley InterScience ( www.interscience.wiley.com ). DOI 10.1002/eej.20014