全文获取类型
收费全文 | 49791篇 |
免费 | 4815篇 |
国内免费 | 2581篇 |
专业分类
电工技术 | 5150篇 |
技术理论 | 1篇 |
综合类 | 5069篇 |
化学工业 | 4622篇 |
金属工艺 | 3102篇 |
机械仪表 | 4831篇 |
建筑科学 | 5843篇 |
矿业工程 | 2265篇 |
能源动力 | 2877篇 |
轻工业 | 2259篇 |
水利工程 | 1278篇 |
石油天然气 | 2488篇 |
武器工业 | 615篇 |
无线电 | 4635篇 |
一般工业技术 | 4150篇 |
冶金工业 | 3134篇 |
原子能技术 | 632篇 |
自动化技术 | 4236篇 |
出版年
2024年 | 206篇 |
2023年 | 580篇 |
2022年 | 1177篇 |
2021年 | 1308篇 |
2020年 | 1561篇 |
2019年 | 1286篇 |
2018年 | 1260篇 |
2017年 | 1671篇 |
2016年 | 1840篇 |
2015年 | 1951篇 |
2014年 | 2954篇 |
2013年 | 2828篇 |
2012年 | 3774篇 |
2011年 | 3984篇 |
2010年 | 2886篇 |
2009年 | 2824篇 |
2008年 | 2713篇 |
2007年 | 3462篇 |
2006年 | 3073篇 |
2005年 | 2600篇 |
2004年 | 2011篇 |
2003年 | 1964篇 |
2002年 | 1608篇 |
2001年 | 1444篇 |
2000年 | 1204篇 |
1999年 | 1006篇 |
1998年 | 702篇 |
1997年 | 687篇 |
1996年 | 538篇 |
1995年 | 463篇 |
1994年 | 399篇 |
1993年 | 241篇 |
1992年 | 236篇 |
1991年 | 154篇 |
1990年 | 126篇 |
1989年 | 130篇 |
1988年 | 85篇 |
1987年 | 61篇 |
1986年 | 30篇 |
1985年 | 35篇 |
1984年 | 23篇 |
1983年 | 12篇 |
1982年 | 11篇 |
1981年 | 18篇 |
1980年 | 12篇 |
1979年 | 10篇 |
1964年 | 4篇 |
1962年 | 5篇 |
1955年 | 3篇 |
1954年 | 3篇 |
排序方式: 共有10000条查询结果,搜索用时 0 毫秒
31.
运用电子显微分析和波谱分析等方法对GH2027合金的第二相进行了研究,结果表明,合金晶界相主要是片状M6C和薄膜状M23C6,经波纹图样测得其错配度约为3%,晶内M6C和M23 相似文献
32.
在线性近似条件下,量子化了非线性薛定谔方程,用后向传播法数值求解了光孤子相互作用对压缩比的影响。数值结果表明,在碰撞距离附近,压缩比显著增加。 相似文献
33.
With the growing size and complexity of power systems, system analysis—such as transients calculation—takes much time. Hence, fast calculation methods are required. Although parallel processing is a hopeful method, there have been difficulties in the parallel solution of linear equations which appear in power-flow calculations by the Newton-Raphson method. This paper aims at the fast calculation of the power-flow problem by means of parallel processing. In order to improve the suitability to the parallel solution of the differential equation in transients calculation, we assume the use of a direct-mapping parallel processing machine to map directly the network of a power system onto a network of processors. Under this assumption, we propose a new parallel-processing-oriented method in which the linear equation is solved by linear iterations between nodes with Aitken acceleration. We simulate the method on three model power systems and compare this Parallel Iterative Method (PIN) with a Parallel Direct Method (PDM) which uses the banded matrix according to the number of operations required. As a result, we can expect that PIM may solve linear equations faster than PDM with m processors, although the PIM might be inferior to the PDM with m × m processors, where m denotes the half-band width of the banded matrix. 相似文献
34.
Li2O在保护渣中的作用 总被引:7,自引:0,他引:7
采用在不同玻璃性的两种基渣中加入Li2O为研究Li2O对保护渣粘度,熔化温度及玻璃性能的影响,并对Li2O改善保护渣玻璃性的机理进行了探讨,提出了寻找高速连铸保护渣中Li2O的代用物的一种方法。 相似文献
35.
为了改善M2高速钢共晶碳化物的分布,本文利用小凝固试样变质的方法研究了Ti,N和Mg对M2高速钢凝固组织和硬度的影响。试验结果表明,加入Ti或Ti-N后,共晶碳化物形态和分布有很大改善,而加入Ti-N后对凝固组织有轻微的细化作用,但只添加Ti不补碳时,钢的淬火硬度和回火硬度均下降;加入适量的Mg可以使片状的M2C型共晶碳化物转为鱼骨状的M6C型共晶碳化物,使其分布有所改善,Ti和Mg复合加入可以明 相似文献
36.
高效防气防砂一体化管柱的研制与应用 总被引:2,自引:1,他引:1
为解决文南油田高气液比井出砂易造成卡泵的问题,研制了高效防气防砂一体化管柱。该管柱主要由闭式气锚、重力式防气装置和激光割缝筛管3部分组成。闭式气锚的分离作用消除了气体对抽油泵的影响,提高了泵效;重力防气装置利用液气分离原理和高烟囱原理进行液气分离,液流回流时间可达10min,排气最高压差可达0.2MPa;经激光割缝筛管过滤后的液体含砂粒外径小于0.05mm。该管柱在文南油田现场应用16井次,累计增液6000t,增油2717t,平均单井泵效提高7%。 相似文献
37.
用试井方法确定注水后地层渗透率的变化 总被引:1,自引:0,他引:1
大港油田已进入开发中后期,高含水油田占73%,开发初期的一些参数已不适合现在开发的需要。研究出一套用试井方法确定注水以后地层渗透率变化的方法,对大港油田的增储上产具有重要意义。 相似文献
38.
The analytical solutions of a spinning Rayleigh beam with rotatory moment inertia and gyroscopic effect are presented in this paper. The critical speeds can be written analytically in a function of the length-to-radius ratio (l) defined by the beam's length over its outer radius and the hollowness ratio (α) defined by the hollow area over the total area of the cross section. The sensitivity analyses show that the critical speed is decreasing with l, but increasing with α. Moreover, α is more sensitive to the critical speeds. The design of a spinning beam should therefore be emphasized more on the hollowness factor. Contrary to common belief, only finite critical speeds exist and the number is independent of the boundary conditions. It increases monotonically with l, but decreases with α. The steady state unbalanced response can therefore be expressed analytically by the finite precessional modes and the corresponding generalized coordinates. 相似文献
39.
有机盐聚合醇氯化钾钻井液的应用 总被引:5,自引:2,他引:3
霍尔果斯背斜构造极其复杂,内应力极高,地层倾角大,断层、破碎带多,并存在高低压互层;安集海河组的灰绿色软泥岩水化严重并具有粘弹塑性.该区块重点探井霍003井三开、四开井段选用有机盐聚合醇氯化钾钻井液,同时为保证钻井液在高密度下(2.55 g/cm^3)具有好的流变性,使用活化铁矿粉、活化重晶石加重.应用结果表明,由于采用了强抑制和多元封堵的措施,该钻井液具有良好的流变性和较强的携带能力,钻进中曾携带出重2.8 kg和5.1kg的大掉块;滤失量低,泥饼质量好,封堵能力强,造壁能力强,减轻了井下阻卡程度;有良好的储层保护能力;在室内研究的基础上,经过现场合理使用和维护钻井液,霍003井提高了机械钻速,缩短了钻井周期,井身质量优于邻井.指出在高密度下,未选出适合有机盐聚合醇氯化钾钻井液的稀释剂,钻井液流动性较差. 相似文献
40.
Yong Ma Yong‐zhen Peng Xiao‐lian Wang Shu‐ying Wang 《Journal of chemical technology and biotechnology (Oxford, Oxfordshire : 1986)》2005,80(10):1118-1124
The laboratory scale anaerobic–anoxic–aerobic (A2O) process fed with synthetic brewage wastewater was designed to investigate the effects of changing feed C/P ratio on the performance of biological nutrient removal (BNR) processes. In the experiment, the influent chemical oxygen demand (COD) concentration was kept at approximately 300 mg L?1 while the total phosphorus concentration was varied to obtain the desired C/P ratio. Results showed that when the C/P ratio was lower than 32, phosphorus removal efficiency increased as C/P ratio increased linearly, while when the C/P ratio was higher than 32, the P removal efficiency was maintained at 90–98%, and effluent P concentration was lower than 0.5 mg L?1. However, regardless of the C/P ratio, excellent COD removal (90% or higher) and good total nitrogen removal (75–84%) were maintained throughout the experiments. It was also found that very good linear correlation was obtained between COD uptake per unit P released in the anaerobic zone and C/P ratio. In addition, the P content in the wasted activated sludge increased with the decrease in the C/P ratio. Based on the results, it was recommended that the wastewater C/P ratio and its effects be incorporated into BNR design and operational procedures, appropriate C/P ratios were used to achieve the effluent treatment goals. Copyright © 2005 Society of Chemical Industry 相似文献