炼铁生产环境负荷分析和预测研究

利用寿命周期评价的思想，计算了炼铁生产过程中的环境负荷，并分析了各因素对环境负荷的影响，运用神经网络对炼铁生产过程环境负荷进行了预测。     

Lattice structure on some fuzzy algebraic systems

In this paper, we study the lattice structure of some fuzzy algebraic systems such as (G-)fuzzy groups, some fuzzy ordered algebras and fuzzy hyperstructures. We prove that under suitable conditions, these structures form a distributive or modular lattice. This research partially is supported by the “ Fuzzy Systems and its Applications Center of Excelence, Shahid Bahonar University of Kerman, Iran”.     

InP基应变补偿结构偏振不灵敏半导体光放大器制作的研究

为了制备偏振不灵敏的半导体光放大器(SOA)，将有源区设计为由4个压应变、3个张应变阱层及晶格匹配的垒层InGaAsP交替组合而成的应变补偿结构。器件做成带有倾角的扇形脊形波导结构，避免了常规制作SOA的复杂工艺。对样品3在80～125mA电流范围内，获得了偏振灵敏度≤0．6dB．最小可达0．1dB；较大的电流范围内FWHM值为40nm。     

Numerical analysis of two-dimensional steady-state and transient heat transfer in a parallel duct filled with pressurized He II

Analysis on steady-state and transient heat transfer on a flat plate at the middle of a parallel duct immersed in He II was performed for bath temperatures from 1.8 to 2.1 K at 101.3 kPa. Two-dimensional computer code named SUPER-2D developed by the authors based on the two-fluid model and the theory of mutual friction was used. Steady-state critical heat flux (CHF) and the time lag from the application of a step heat input to λ transition, that is called a lifetime, were obtained numerically for various step heat fluxes and for the channel gaps from 2 to 20 mm. Effect of the gap restriction on the CHF and the lifetime were clarified. The solutions were compared with the experimental data for the ducts with the same structures and the corresponding conditions. They agreed well with the experimental data. The heat transport mechanism in the parallel duct was clarified.     

The Difference in Turbulent Diffusion between the Active and Passive Scalars in a Thermally Stably Stratified Medium

The difference in the turbulent diffusion between the active (heat) and passive (mass) scalars in a thermally stably stratified medium is investigated. The axisymmetric problem is treated on the formation of a turbulent circulation flow above a heated disk and on the turbulent diffusion of a passive scalar (impurity) from a continuous surface source in a stably stratified medium. The results indicate that the thermal stratification causes appreciable differences in the coefficients of turbulent transfer between the active (heat) and passive (mass) scalars. This means that the assumption of the identity of the coefficient of turbulent diffusion of heat and mass, employed in conventional models of turbulence, produces significant errors in estimating the heat and mass transfer in a thermally stably stratified medium.     

Comparison of activities in selective catalytic reduction of NOx by C3H8 over Co/MFI, Fe/MFI, and H/MFI zeolite catalysts

The Co/MFI(SiO₂/Al₂O₃ = 30) were prepared by a precipitation method with NaOCl in alkali solutions exhibited high activities to N₂ at 250 °C for the selective catalytic reduction (SCR) of NO_x. These catalysts showed two UV–vis bands at 700 and 400 nm, indicating the presence of octahedral Co(III) as well as tetrahedral Co(II). The high SCR activity over such Co(III, II)/MFI(30) seems to come from Co(III)---O moieties. The Co(II)MFI(30) catalysts prepared from Co(II)Cl₂ exhibited low SCR activities due to the presence of tetrahedral Co(II) ions in MFI. Less CO formation occurred over Co/MFI catalysts. The Fe/MFI(30) catalyst exhibited high activity due to the presence of some Fe---O species in MFI but more amount of CO were produced during SCR. H/MFI(30) catalyst exhibited a good SCR activity. However, more amount of carbonaceous deposits were produced on it. The correlation between acid concentration and SCR activity was discussed over H/MFIs.     

（E）-2-壬烯酸合成方法的改进

(E)-2-壬烯酸是有机合成的一种重要中间体,我们利用Knoevenagel反应机理,改进了(E)-2-壬烯酸的合成工艺,在不使用脱水剂条件下,使用少量吡啶作催化剂,获得了83%的反应收率。     

Highly ordered microstructures of poly(styrene-b-isoprene) block copolymers induced by solution meniscus

Microstructures of hundreds of micron thick poly(styrene-block-isoprene) copolymer films solution-cast in a cylindrical tube with the solvent evaporation controlled were investigated by transmission electron microscope (TEM), small angle X-ray scattering (SAXS) and optical microscope (OM). In a block copolymer with cylindrical polyisoprene microdomains, the orientation of the cylinders was varied along radial direction of the cylindrical tube. Highly aligned hexagonal arrays of in-plane polyisoprene cylinders were formed with their cylindrical axis parallel to the circumference of the tube in the regimes close to the wall edge. In contrast randomly ordered microdomains were observed at the center of the tube. We have also found that the orientation depends on the solvent evaporation rate and an intermediate rate (∼2.3 nL/s) provides the best orientation. In the case of a block copolymer with a bicontinuous double gyroid structure, we obtained a globally ordered microstructure where [111] crystallographic direction was parallel to the circumference of the tube. For both block copolymers, the area of highly ordered arrays of nanoscopic domains is over 1 mm². Development of the orientation was explained by coupling two orthogonal fields: (1) The flow of a solution induced by strong capillary force at a meniscus between the cylindrical tube wall and the block copolymer solution and (2) the solvent evaporation.     

基于Delphi的报童模型的实现与动态仿真

已往库存论中的决策模型,它是把现实过程用数学的方法进行分析,得到决策值,但不能看到决策的过程,不能反映出现实生活中的不确定性、动态性。运用Delphi 7.0和SQL server 2000对销售过程进行了动态仿真,利用Newsboy模型的推广(S,s)订购策略来监控库存并做出决策,这样就体现出此过程的不确定性、动态性;且举出了一个仿真商品销售的实例,对其中的一些关键技术,如何仿真、算法的实现等进行了阐述。     

国际放射防护委员会的剂量系数的可靠性

在评价公众成员摄入放射性核素的辐射危害时，需估算每单位摄入量所致的剂量。摄入放射性素后器官或民受到的剂量是受到的剂量是通过生物学模型和剂量学模型来确定的，因此剂量也必须根据模型来确定。文中初步探讨了国际放射防护委员会给出的剂量系数的可靠性问题。文中首先说明了估算剂量系数的概念和方法，然后分析了剂量系数估算中，采用胃肠道模型，呼吸道模型，系统生物动力学模型和剂量学模型所遇到的不确定度的各种主要来源。